生長速率 的英文怎麼說

中文拼音 [shēngzhǎng]
生長速率 英文
growing rate
  • : Ⅰ動詞1 (生育; 生殖) give birth to; bear 2 (出生) be born 3 (生長) grow 4 (生存; 活) live;...
  • : 長Ⅰ形容詞1 (年紀較大) older; elder; senior 2 (排行最大) eldest; oldest Ⅱ名詞(領導人) chief;...
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 率名詞(比值) rate; ratio; proportion
  • 生長 : grow; grow up; ascent; merisis; build up; auxesis; increment; overgrowth; gain; burgeon; bourgeon...
  • 速率 : speed; rate; tempo
  1. Effects of 60co - ray radiation on the growth speed and chlorophyll content of begonia tuberhybrida voss., ph. viollacea rchb., cyclamen persicum mill., dahlia pinnata chlav

    射線輻射對滇特色花卉生長速率及葉綠素含量的影響
  2. The growth rate can exceed the pull rate and even be negative at a given time.

    生長速率可能大於拉晶,甚至某一時刻是負值。
  3. Through the study of the example of shaxi porphyry body in anhui province, the authors first figured out the storage time of plagioclase phenocrysts, then calculated the nucleation rate and growth rate of the crystals and, on such a basis, established the thermal model for cooling of the hypabyssal magmatic system

    本文試圖通過對安徽沙溪斑巖體進行實例研究,先求出斜石斑晶的存儲時間,再算得晶體成核生長速率,進而建立起淺成巖漿體系冷卻的熱模型。
  4. Promote good growth and survival of prawn shrimp

    可提高幼蝦苗生長速率
  5. The fungistasis of dichloromethane extracts 7 plants from were tested by growth rate method with the common fungi such as rhizoctonia solani, cladosporium ucumerinum, alternaria solani and fusarium oxysporium

    摘要用生長速率法以辣椒絲核病菌、黃瓜黑星病菌、番茄早疫病菌和黃瓜枯萎病菌為供試菌種,對7種植物的12種二氯甲烷提取物進行了抑菌活性測定。
  6. And the spherulite growth rate of phbv is studied and the factors, which influence the growth rate and the formula of spherulite growth rate, were discussed

    並通過對phbv球晶生長速率的測定,對結。晶度方程及影響因素做出修正。
  7. Abstract : the thermogram of s. dysenteriae of fungistatic action w as determined and the growth rate constant at different concentration of medicin e was calculated, and the optimum allowable concentration of the co salt complex abtained

    文摘:微量量熱法測定並研究計算了在不同濃度的鈷配合物作用下痢疾桿菌的生長速率常數和最佳用藥量。
  8. In this paper, the course of isothermal crystallization kinetics of polymer in limited volume unit is simulated by use of the method of monte carlo. four factors influenting on the course of polymer in the limited volume unite isothermal crystallization are analyzed under the given conditions. the four factors are sample volume shrinkage, the change of the linear growth rate of entities g, the change of sample thickness and the change of the number of nuclei

    本文採用montecarlo方法研究了高聚物在有限體積元中的等溫結晶動力學過程,分析了在一定條件下,樣品體積收縮、晶體線生長速率變化、樣品厚度變化和晶核數目變化這四種因素對高聚物在有限體積元中的等溫結晶過程的影響。
  9. The results showed that the relative survival rate of zoospores decreased with the uv radiation time and distance increased, and the uv radiation could reduce the growth rate, survival capacity, pathogenicity and reproduction capacity of phythophthora sojae remarkably

    結果表明:游動孢子的相對存活隨照射距離及時間的延而降低,紫外線照射使大豆疫黴菌生長速率存能力、殖能力、致病性等都明顯降低。
  10. A reliability experiment of thermal aging was carried out for the two types of joints, scanning electron microscopy, energy dispersive x - ray spectrometer and micro x - ray diffractomer were adopted to investigate the interfacial evolution behavior of joints, and kinetics model of imc formation was established. the results show that imc growth follows the parabolic law as a function of aging time at certain aging temperature, imc growth is more sensitive to the aging temperature than the aging time, the activation energy of cu - al imc growth is 97. 1kj / mol and the major forming cu - al imc are cual2 and cu9al4, the activation energy of au - al imc growth is 40. 1kj / mol and the main au - al imc are au4al and au5al2, with au2al and aual at the interfacial periphery of joints, the rate of cu - al imc growth is about 1000 times slower than that of au - al imc, and kirkendall voids and cracks are easily appeared during thermal aging in gold ball bonds while voids and cracks are absent in copper ball bonds even after aging at 200 for 2900 hours and 250 for 169 hours

    研究結果表明:金屬間化合物厚度與老化時間的關系符合拋物線法則,金屬間化合物的對老化溫度比老化時間更加敏感; cu - al金屬間化合物的激活能為97 . 1kj / mol ,老化后金屬間化合物呈層狀分佈,主要相為cual2和cu9al4 ; au - al金屬間化合物的激活能為40 . 1kj / mol ,主要相為au4al和au5al2 ,同時在界面周邊區域成了au2al和aual ;老化過程中cu - al金屬間化合物生長速率比au - al金屬間化合物生長速率小103數量級;金絲球鍵合點200老化96小時出現了明顯的kirkendall空洞和裂紋,但銅絲球鍵合點200老化2900小時和250老化169小時都沒有形成空洞和裂紋。
  11. The burst size of the cyanophage was ca. 200 pfu ? cell " 1. the rate of adsorption to host was markedly higher under light condition than that under dark condition ( p = 0. 02 ), and light was necessary for infection

    此外,固體培養條件下,織線藻的生長速率與噬藻斑的擴大之間有明顯的同步性,即度越大,噬藻斑的擴大就越明顯。
  12. Besides, the growth of gasb expitaxy film was monitored by reflection high energy electron diffraction ( rheed ). the rheed images and intesity oscillation are collected by computer system. it showed that the gasb film prepared in 400 was amorphous and it became monocrystalline when the temperature rose to 500. atomic force microscope ( afm ) was applied to analyse the surface morphology of the films which were grown in diffrent growth rates or substrate temperature. the analysis were compared to simulation results. the experiment results indicated it was easy to form clusters when the rate of growth is high or

    此外,本文通過反射式高能電子衍射( rheed )監測了gasb外延薄膜的,利用rheed強度振蕩的計算機採集系統實現了rheed圖像和rheed強度振蕩的實時監測。實驗發現在400的gasb薄膜為非晶態,溫度升高到500薄膜轉變為單晶。利用原子力顯微鏡對不同生長速率和襯底溫度的gasb薄膜的表面形貌進行觀察分析,並與模擬結果進行比較。
  13. Abstract : determined the power - time curves of the promoter bacteria of ganoderma lucidum for e. coli, using 2277 thermal activity moniter, a new experimental model of promoter bacteria growth were established. the growth rate constant and heat output at different concentration of ganoderma lucidum have been calculated. from - c and q - c curves the optimum concentration has also been established

    文摘:用熱活性檢測儀測定了天然藥物靈芝對大腸桿菌起促菌作用的熱功-時間曲線,並根據曲線建立了細菌的新的實驗模型,按新模型計算了促菌作用下的生長速率常數,發熱量及最佳促菌濃度。
  14. The results show that the optimal temperature for the hypha growth, hypa color turned, and stroma differentiation is 22. 7, 20. 2 and 18. 1, respectively, and the appropriate temperature for the hypha and stroma growth under artificial culture is 15 - 18 and 14 - 17, respectively

    結果表明,蛹蟲草菌絲生長速率最大時的環境溫度為22 . 7 ,轉色的最佳溫度為20 . 2 ,子座分化的最佳溫度為18 . 1 ;在人工栽培時,適宜的發菌溫度為15 ~ 18 ,子座的適宜溫度為14 ~ 17 。
  15. In the low - temperature - freezing stage, the water is frozen as ice phase, while the solute precipitate as the salt phase. the velocity of ice phase growth ( vf ) in the solution and the velocity of solute diffusion ( vd ) decide that whether the heavy segregation of solute appears

    當低溫冷凍時,水以冰的形式凍結,溶質則以鹽的形式析出,形成冰鹽兩相;冰相生長速率和溶質擴散決定了溶質鹽是否發大的偏聚。
  16. Growth rates of between 0. 25 and 1. 3μm/min were reported with the c axis of hexagonal zno grown on(0112)-oriented al2o3 lying in the plane of the film。

    據報道,在(0112)取向的Al2O3襯底上C軸位於薄膜平面上的六角晶體ZnO的情形中,其生長速率在025mmin和13mmin之間。
  17. " both species of fish are being caught in substantial numbers through directed fisheries and as bycatch, but they are extremely vulnerable to exploitation, due to their slow growth, low reproductive rate, long gestation periods, and late maturity.

    這兩個品種被人類大量獵殺,又經常成為間接漁獲,加上其生長速率緩慢繁殖力低懷孕期及遲熟,極易受濫捕的威脅。
  18. Only later were the tissue isolates reduced to their minimum size to produce the maximum relative growth rates.

    只有到后來,離體組織減少到它們的最小體積而產最大的相對生長速率
  19. What was surprising is that dinosaurs grew as fast as they did

    令人驚奇的是,恐龍的生長速率竟是如此之快。
  20. Its faster growth rate actually produces less sturdy wood

    而它較快的生長速率,事實上也產出較為柔弱的木質。
分享友人