界面粘度比 的英文怎麼說

中文拼音 [jièmiànniándùbǐ]
界面粘度比 英文
interfacial viscosity ratio
  • 界 : 名詞1 （相交的地方; 劃分的界限） boundary 2 （一定的范圍） scope; extent 3 （按職業、工作或性別等...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 界面 : [物理化學] interface; boundary; limiting surface
  1. Here, fem is applied in the analyses of i ) fiber axial stress and interphase shear stress in fragmentation tests during initially applied strain, ii ) influence of temperature on the stress transfer across the interface, iii ) modulus and thickness of the interphase and their influence on interfacial stress transfer, iv ) interfacial debonding process, and v ) fragment aspect ratio, contact friction along the interface and their influences to the interfacial stress transfer efficiency

    在論文的這部分工作中，使用有限元法描述和分析了逐節斷裂試驗中初始應變下的纖維軸向應力和界面相剪切應力，溫度對界面應力傳遞的影響，界面相模量和厚度、纖維節長寬比、界面脫粘過程、界面接觸中的摩擦效應等因素對逐節斷裂試驗中應力傳遞的影響。
  2. ( 2 ) interfacial agents this experiment adopts three types of interfacial agents : no interfacial agent, neat cement paste which has the same water - cement ratio with the new concrete, cement paste mixed with 10 % expanding agent which has the same ratio with the new concrete ( which is called cement paste mixed with expanding agent for short ). the thickness of the interfacial agent is 2 ~ 3mm

    （ 2 ）粘結劑本試驗採用三種粘結劑：無粘結劑、同新混凝土相同水灰比的水泥凈漿、摻10 u型膨脹劑的同新混凝土相同水灰比的水泥凈漿（以下簡稱水泥膨漿） 。界面劑的厚度一般為2 3mm 。
  3. The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp

    結果表明：與純聚丙烯相比，納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度，力學損耗因子則降低，納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯；界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用，與聚丙烯相比，納米復合材料的流動活化能提高約15 % ，結晶峰溫度提高10k左右。
  4. This paper first present a study on the bond properties of furan resin concrete reinforced with gfrp bars, in which the pull - out test was adopted to investigate the bond performance between gfrp bars and furan resin concrete, compare the bond strength of gfrp bars of different surface disposal and validated the feasibility by test the gfrp bars reinforced furan resin concrete beam. then the paper provides a micro - mechanical model for the splitting failure analysis of gfrp reinforced concrete member and deducted the relation between splitting failure load and parameter of gfrp rod

    本文首先對gfrp筋加強呋喃樹脂混凝土及普通混凝土的界面粘結性能進行了實驗研究，對玻璃鋼筋表面採取了三種處理方法，用拔出試驗研究分析了gfrp筋和呋喃混凝土、普通水泥混凝土之間的粘結強度，比較了用不同方法進行表面處理的效果，確定了合適的表面處理方案，並通過對gfrp筋加強呋喃混凝土梁進行了彎曲試驗，進一步驗證了方案的可行性。
  5. Based on analysis and comparison of existing test data applied to existing ultimate strength prediction models, interfacial stress at the end of plate is deduced. after formulas for calculating the effective moment of inertia for frp - strengthened beams being revised and adjustment coefficient related to nominal main steel reinforcement ratio and curtailment length ratio being put forward, strength prediction formulas of compound beams under plate end debonding failure are established. in analysis of strength of compound beams under intermediate crack induced interfacial debonding failure mode, several bond strengths and their relation are introduced

    對于板端剝離破壞，在總結現有承載力模型的基礎上，利用已有試驗數據對各承載力計算公式進行了分析比較，進一步採用分階段分析法，推導了板端界面應力的計算公式，在此基礎上，採用加固復合梁有效慣性矩的修正公式，建立了考慮名義配筋率和板端偏移比影響的板端剝離破壞梁承載力的計算公式；對于跨中受彎裂縫導致的粘結破壞，闡述了常見的幾種粘結強度之間的區別和聯系，並基於拉剪粘結強度，提出了跨中受彎裂縫導致粘結破壞的承載力計算公式，並利用現有試驗結果確定了模型中的一些參數；最後，利用試驗數據對本文建立的兩種粘結破壞承載力計算公式進行了檢驗，結果基本吻合。
  6. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
  7. Aminobenzenesulfonic acid super - plasticizer is selected though cement paste test, which be provided with high water - reducing property, low slump loss and good compatibility with cement. according to the request of super high early strength, admixture rf is obtained though tests to compare performances of different accelerators and admixtures. experimental research and analysis are carried out on coarse aggregate ' s grain - size effect and composite aggregate ' s bulk - density to take sensitivity of coarse aggregate into account

    通過水泥凈漿試驗比較選擇了減水率高、坍落度損失小、與水泥適應性好的氨基苯磺酸鹽高效減水劑；針對超早強的性能要求，試驗比較了不同早強劑及早強性摻合料的性能表現，研製了早強性能顯著、與高效減水劑和水泥相容性較好的rf摻合料；考慮到修補混凝土對粗集料粒徑的敏感性，對粗集料粒徑效應及混合集料堆積密度進行試驗研究與分析；並對修補混凝土的抗折、抗壓、新老界面粘結強度以及抗凍性等進行了試驗研究。
  8. 2. effect of the viscosity ratio, mterfacial adhesion, processing conditions and composition on the dispersing morphology and properties of pp / eoc blends was investigated. low viscosity ratio and high shear rate during processing were found to produce fine and uniform dispersion of eoc in pp matrix, while low viscosity ratio, high interfacial interaction, good fluidity of elastomer and high shear rate in molding process resulted in fibril dispersion, which afford a guide for controlling the morphology of pp / eoc blends

    研究了粘度比、界面相互作用、加工條件和共混比例等因素對pp eoc體系分散形態和性能的影響，發現粘度比小和加工過程中剪切強度大有利於彈性體在基體中分散均勻細化；粘度比小、界面相互作用強、彈性體本身的流動性好及成型時受到的剪切應力大，使彈性體相易變形，沿流動方向取向呈纖，闡明了各因素對形態影響的作用機制，這對pp eoc共混物的形態控制具有重要的指導作用。
  9. The research work can be divided into two parts : 1. research on the interfacial bond of new - to - old mortars. this paper has research on the bond performance under the conditions of different curing systems, bond method aging and proportion, by means of " 8 " mould and giving preliminary discuss on the mechanism of different materials by use of sem

    本文的研究工作可主要分為以下兩大方面： 1 、新老砂漿界面粘結的研究採用「 8 」字型新老砂漿粘結抗拉粘結強度的試驗方法，研究了多種界面粘結材料在不同養護制度、不同粘結方法、不同齡期、不同配比條件下的粘結性能，並利用掃描電鏡對界面微觀結構進行了分析，對各種材料粘結改性機理進行初步探討。
分享友人
分享到 Line

分享到臉書