瞬變抑制 的英文怎麼說

中文拼音 [shùnbiànzhì]
瞬變抑制 英文
transient suppression
  • : Ⅰ名詞(眼珠一動; 一眨眼) wink; twinkling Ⅱ動詞(眨眼) wink
  • : Ⅰ動詞(向下按; 壓制) restrain; repress; curb Ⅱ連詞[書面語]1 (表示抉擇) or 2 (表示轉折) but3 ...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • 抑制 : 1 (控制) restrain; control; check; hold up; curb; stop; repress; bridle; choke; prehension; sup...
  1. Intermodulation suppression for fh ( frequency hopping ) receiver is designed by selecting the intermediate frequencies and changing group of filters, local oscillation ( lo ) frequency, bandwidth of lo frequency under the condition that receiver configuration, sensitivity, dynamic range, instantaneous bandwidth and precision of frequency measurement are fixed

    摘要針對跳頻接收機的體和靈敏度、動態范圍、時工作帶寬、測頻精度等設計參數,通過改預選器組成、本振頻率和本振帶寬,分析接收通道的中頻選取原則,以實現跳頻接收機的互調設計。
  2. Compared with the classical bp algorithm, robust adaptive bp algorithm possesses some advantages as following : ( 1 ) increasing the accuracy of the network training by means of using both the relative and absolute residual to adjust the weight values ; ( 2 ) improve the robustness and the network convergence rate through combining with the robust statistic technique by way of judging the values of the samples " relative residual to establish the energy function so that can suppress the effect on network training because of the samples with high noise disturbances ; ( 3 ) prevent entrapping into the local minima area and obtain the global optimal result owing to setting the learning rate to be the function of the errors and the error gradients when network is trained. the learning rate of the weights update change with the error values of the network adaptively so that can easily get rid of the disadvantage of the classical bp algorithm that is liable to entrap into the local minima areas

    與基本bp演算法相比,本文提出的魯棒自適應bp演算法具有以下優點: ( 1 )與魯棒統計技術相結合,通過訓練樣本相對偏差的大小,確定不同訓練樣本對能量函數的貢獻,來含高噪聲干擾樣本對網路訓練的不良影響,從而增強訓練的魯棒性,提高網路訓練的收斂速度; ( 2 )採用相對偏差和絕對偏差兩種偏差形式對權值進行調整,提高了網路的訓練精度; ( 3 )在採用梯度下降演算法對權值進行調整的基礎上,通過將學習速率設為訓練誤差及誤差梯度的特殊函數,使學習速率依賴于網路訓練時誤差時的化而自適應的改,從而可以克服基本bp演算法容易陷入局部極小區域的弊端,使訓練過程能夠很快的「跳出」局部極小區域而達到全局最優。
  3. The main circuit is consisted of 18 thyristors circuit and protection circuit. with the help of control subsystem, it can get the output of low frequency voltage ( current ) with the shape of sine wave ; the core of the control subsystem is the cpu of 87c196kc, and the synchronization circuit, the pulse - widen circuit, and the power - enlarged circuit form the accessorial subsystem of the control system. it possesses all the functions of digital triggering, digital tuning, analog / digital conversion ; the input transfer can isolate the input and output ; and the circumfluence reactor can reduce the circumfluence

    主迴路採用由18個晶閘管組成的三相零式電路,並輔以晶閘管的保護電路,通過控可以得到低頻正弦波的電壓(電流)輸出;控迴路主要以87c196kccpu為核心,其外圍電路包括同步電路,脈沖拓寬電路,功率放大驅動電路等,完成了數字觸發、數字調節、模數轉換等功能;進線電源壓器具有壓和隔離作用;環流電抗器則實現了有效主迴路時脈動環流的功能。
  4. A g reat deai of tests showthat the power suppiy circuit, the ac current and voitage circuit, communication and the binary input circuit are the main routes for transient. the filter, three - terminal chip capacitor and the capacitor can be used in the lowvoitage power suppiy circuit ( 5v. + l - 15v and 24v ) to restrain the efts affecting thedigital system

    3提出在5v 、 + / - 15v 、 24v弱電電源迴路中,通過增加適用於弱電系統濾波器、 emi片狀濾波器以及在弱電電源端加入電容器等措施,可以有效地騷擾對數字系統的影響。
  5. Through theoretic reckoning and simulating analyzing, several control strategies for shunt apf were compared and chose ip - iq arithmetic of the instantaneous reactive power theory control strategy as the right scheme to produce the instructing current. based on it, some new control arithmetic was subjoined to suppress the resonance in system and balance the dc side capacitor voltage. two topologies of main circuit were compared and chose the three - phase voltage - source converter with a split - capacitor as its main circuit structure

    通過理論計算和模擬分析,比較了並聯型apf的幾種控策略的優點和缺點,從中選擇時無功理論控策略i _ p - i _ q計算方式為指令電流產生的演算法,並在此基礎上增加了系統諧振和平衡直流側電容電壓的控;比較了並聯型apf主電路的兩種常見形式,從中選擇了三相電壓型流器的主電路形式;算出適合該apf的直流側電容和出線電感的參數;設計出能有效消除apf產生的高次諧波的高通濾波器。
  6. The recombinant was identified by dual enzyme digestion and the direction of cd40 / pcdna3 was analysed with t7 primer. after being packed by lipofectaminetm2000, the recombinant was transfected into b lymphocytes. cd40 expression on membrane, cell proliferation and antibodies concentration were detected with flowcytometry, mtt colorimety assay and el1sa, respectively

    以脂質體為介質時轉染健康人及sle患者b細胞系,利用流式細胞技術檢測膜cd40的表達情況,並利用mtt比色法檢測細胞的增殖能力, elisa法檢測培養液的ig濃度,以研究b細胞在cd40被以後增殖能力、抗體分泌的改
  7. Surge suppressor surge suppressors are devices capable of conducting high transient voltages. they are used for protecting other devices that could be destroyed by the transient voltages

    器突器是能夠間高電壓的設施,用來保護其他設備免受間電壓的破壞。
  8. The ferrites can be used in ac current and voltage circuit andcommunication circuit, because they absorb the transient energy effectively. furthermore, changing the arrangement of the primary winding coil and the secondarywinding coil and using the double screen for auxiliary current and voitage transformercan be adopted to " induce the common mode transient

    指出鐵氧體磁環/磁珠對交流電流/電壓迴路、通信迴路的共模騷擾有較好的作用。此外通過改原副方繞組的布置以及採用雙層屏蔽等技術減小輔助流器/壓器原、副方繞組的耦合電容也能夠共模騷擾。
  9. Using the optimization control method of the moderm control theories, the time - varying control and output - feedback control the authors study the variable structure active control over the rotor vibration with sma, especially the method of restraining the transient response of the rotor vibration. they get the rule of the optimum control force and the optimum control electric current and discuss the influence of variable stiffness on the total system stiffness through analyzing the structure of sma controller. they also indicate the shortcoming of the orthodox design method of a controller, especially the imbalance phenomenon caused by the lack of the rod stability, and propose a new method for improvement and items which ought to be paid attention to in the design stage

    運用現代控理論中的最優控方法,引入時和輸出反饋控,研究利用形狀記憶合金對轉子振動進行結構主動控,特別是轉子振動的態響應的方法,得出了最優控力和控電流的強度化規律;通過分析形狀記憶合金動作器的結構,探討了剛度支承對系統總體剛度的影響,指出了傳統設計方法的不足之處,特別是由壓桿穩定性不足引起的失穩現象,並提出了改進的方法和在設計中值得注意的問題
分享友人