硅鋁質 的英文怎麼說

中文拼音 [guīzhí]
硅鋁質 英文
sal(c. i. p. w. )(sial)
  • : 名詞[化學] silicon (14號元素符號 si)
  • : 名詞[化學] aluminium (13號元素, 符號al)
  • : Ⅰ名詞1 (性質; 本質) nature; character; essence 2 (質量) quality 3 (物質) matter; substance;...
  • 鋁質 : aluminum
  1. Refractory products. chemical analysis of aluminous, siliceous, silicon carbide, carbon and metallic silicon refractory products

    耐火材料製品.礬土材料碳化碳和金屬耐火材料製品的化學分析
  2. Application research of depurate sorts of water samples with the polysilicate aluminum ferric floccule

    聚合鐵絮凝劑凈化各類水的應用研究
  3. A green and permanent modificant for hypereutectic al - si alloys

    一種過共晶合金的綠色長效變
  4. They do not have an illuvial horizon enriched with either silicate clay or with an amorphous mixture of aluminum and organic carbon

    沒有富含酸鹽粘土或有機碳非晶混合物的淀積層。
  5. Metallograph of cast aluminium alloys. cast aluminium - silicon alloys modification

    鑄造合金金相.鑄造合金變
  6. The imported transparent glaze fired at lower temperature was analysed semi - quantitatively by adopting emission spectroscope. the stripping of lead and cadmium from this transparent glaze fired at lower temperature in ceramic product was determined by atomic absorption spectroscope. the effect of chemical composition on the stripping of lead and cadmium was analysed. upon the author s opinion, the overproof lead stripping from the imported transparent glaze fired at lower temperature can only be settled by adopting lead - free glaze instead of adopting low - lead prescription. the author succeeded in developing an excellent lead - free transparent glaze fired at the lower temperature of 1000 1050. the success is based on an inquiry into the feasibility of using such new agents of fusion as li2o and sro in replacement of pbo ; and on a study of the effects of the contents of sio2 , al2o3 , b2o3and other metallic oxides on such performances of glaze as coefficient of linear expansion, fusion temperature and transparency. it is also based on an analysis of coefficient of linear expansion of blank and glaze on an analysis of coefficient of linear expansion of blank and glaze on their correlation ; and on a study of technology for preparing glaze

    採用發射光譜儀對進口低溫透明釉進行半定量分析,並用原子吸收光譜儀測定其陶瓷製品的鉛、鎘的溶出量,分析化學成分對鉛、鎘溶出量的影響.結果表明,進口低溫透明釉採用低鉛配方不能解決鉛溶出量的超標問題,只有採用無鉛釉才能解決.探討用氧化鋰和氧化鍶等新型熔劑完全代替氧化鉛的工藝,研究釉料中氧化、氧化、氧化硼和各種金屬氧化物的含量,對釉的線膨脹系數、熔融溫度和透明度等性能的影響.分析坯料、釉料的線膨脹系數及其相互關系和釉料制備的工藝,研製出優的1000 1050低溫無鉛透明釉
  7. The key products of the company are high alumina brick, fireclay brick, phosphate - bonded wearable brick, exfoliation - resistant high alumina brick, high refractoriness under load brick, corundum brick, magnesite brick, magnesite ? chrome brick, series of corundum, sic furnace chamber and pipe, ceramisite brick, corundum - mullite brick, corundum - chrome brick, sillimanite brick, magnesite alumina spinel brick, acid - resistant brick, alkali - resistant brick, zirconia - corundum brick, alumina bubble products, series thermal insulating refractory products, high alumina castable, corundum castable, corundum ramming, brown - corundunm castable, sic castable, low - cement castable, alkali ? resistant castable, light silica alumina products, stainless steel fibre reinforced castable, etc

    主要產品有:高磚、粘土磚、磷酸鹽耐磨磚、抗剝落磚、高荷軟磚、剛玉磚、碳化磚、鎂磚、鎂鉻磚、各種剛玉、 sic爐膛、爐管製品、陶粒磚、剛玉莫來石磚、鉻剛玉磚、線石磚、鎂鉻尖晶石磚、耐酸磚、耐堿磚、鋯剛玉磚、氧化空心球製品及各種輕保溫材料、高澆注料和剛玉澆注料、搗打料、棕剛玉澆注料、碳化澆注料,低水泥澆注料、抗堿性澆注料、輕製品、鋼纖維增強澆注料等80餘種系列耐火材料。
  8. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討,選用鎳鉻合金電阻絲作為加熱元件,配以陶瓷埋入式爐膛;選用陶瓷小尺寸扁平?圓盤均熱塊體型樣品支持器;選用0 . 5mm絲徑鎳鉻?鎳熱電偶( k )作為測溫元件;熱電偶對稱安置在樣品支持器容器的中部;選用耐火纖維作保溫材料;合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體;採用升溫曲線來控制爐膛供熱過程;採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法,進行圖形處理。
  9. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要,在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化和氧化基陶瓷材料摩擦副在水、化學腐蝕性介作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  10. Abstract : to increase industrial grade silicon product quality, bottom blowing melt of industrial grade silicon outside the furnace can effectively decrease al and ca contents in industrial grade silicon

    文摘:為提高工業產品量,採用爐外底吹氧化精煉工業熔體,有效地降低了工業、鈣雜的含量。
  11. Continuous hot - dip aluminium silicon - coated cold - reduced carbon steel sheet of commercial and drawing qualities

    商業和拉伸量用連續熱浸鍍層碳素鋼薄板材
  12. Use natural hard clay as raw material, melt in electric furnace in the temperature of above 2000 and become into fiber by air blowing

    耐火纖維(陶瓷棉) ,以天然硬粘土或配合料為原料,在2000以上的電爐中熔化,用氣流噴吹法成纖。
  13. This kind of high silica wrought aluminum alloy is provided with low density and well heat - stability, especially with the metallurgical structur ? similar with bearing alloy ? which is composed of dispersion distribution common silicon crystal hard mass point and the alloyed basal body is very fit for the components manufacture ? can bear small capacity moving load and friction load

    這種高變形合金具有密度小和200以下良好的熱穩定性,特別是它的由彌散分佈的共晶點及合金化的相基體組成的類似軸承合金的金相組織、特別適合用於製做承受小能量動載荷和摩擦載荷的零件。
  14. Non - water alumina - silicate refractory mortar

    非水系耐火泥漿
  15. Alumina - silica insulating refractory mortars

    隔熱耐火泥漿
  16. Test method for alkali - resistant of alumina - silica castable refractory

    硅鋁質耐火澆注料耐堿性試驗方法
  17. Research status and development of high silicon aluminium alloy for light weight electronic package materials

    合金輕電子封裝材料研究現狀及進展
  18. Our main products are silicon carbide, alumina ceramic, tungsten carbide, and carbon - graphite seal rings

    我們的主要產品是碳化、硬合金、碳石墨密封環和氧化陶瓷製品。
  19. Ningbo dongya mechanical seal manufacturer is a professional manufacturer and exporter of mechanical seals, pumps, gaskets, o - rings and other sealing materials

    本公司專業生產碳化,硬合金,氧化陶瓷,碳石墨等密封材料和各種工礦介的機械密封
  20. Tsino ceiling board products are divided into three series : tisno ac - ca composite ceiling series, tsino pc metal paint composite ceiling, and tsino sc water proof paint surface composite ceiling ; and over 50 kinds of pattern variations, to meet the requirement of different architecture styles

    思龍裝飾天花板產品現已形成五大產品系列? ?異形天花系列、 ac鈣復合天花系列、 pc烤金屬漆復合天花系列、酸鈣大板系列和sc防水塗料復合天花系列;有多種規格及50多種花色圖案,可滿足不同建築設計風格及不同使用功能的需求。
分享友人