穩態模 的英文怎麼說

中文拼音 [wěntàimó]
穩態模 英文
steady-state mode
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  1. Study on the steady analysis model of variable displacement hydraulic pump

    變量液壓泵穩態模擬模型
  2. In order to improve the utilization efficiency of energy and equipment, a general steady simulation model of complex cross - feed multi - effect evaporation was established for the purpose of in - depth research on rule of multi - effect evaporation. in this model, the energy - saving measures, including extra steam being led off to preheat material liquid, the condensation water flash and solution flash, were adopted, and the solid separation was also considered in the process of evaporation

    為了提高多效蒸發系統能量與設備的利用效率以及深入研究多效蒸發過程的規律，建立了帶有冷凝水閃蒸、溶液閃蒸和引出額外蒸汽預熱原料液等節能措施並考慮蒸發過程有固相析出的復雜錯流多效蒸發穩態模擬通用模型。
  3. Study on the stable state numerical model to vacuum freeze drying

    食品真空冷凍乾燥準穩態模型的研究
  4. Accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is use to calculate the dynamic and steady performance by kron and symmetrical coordinate converter

    論文通過對電機基本方程進行kron變換和對稱分量變換，分別建立了系統完整的數學模型，編制了動態和穩態模擬程序，並對系統進行了模擬，對系統的動態、穩態性能進行分析。
  5. The results indicate that the position of sensitive plates is located at the section of middle or upper in tower but not near by feeding plate, and the smaller reflux ratio, the closer overhead of distillation tower. accurate calculation for flash is solved using matlab, and the result is correct and reasonable. complicated multi - components distillation and crude distillation are simulated using chemcad, and results are reasonable about profiles of flow for vapor and liquid as well as temperature in the tower

    數值分析的結果表明精餾塔靈敏板位置並不在進料板附近，而是位於精餾段的中上部，且迴流比愈小，愈靠近塔頂;利用matlab實現了蒸餾過程的嚴格計算，與參考值比較，結果正確、合理;藉助于chemcad進行常減壓塔的穩態模擬計算，得出了流量和溫度在塔內的分佈，經過理論分析，結果合理，可為實際生產提供參考。
  6. Here are three parts in this thesis : building steady state model and transient model for water hydraulic valves. research on the property of flow field inside water hydraulic valves. analysis of the force on water hydraulic valves

    論文主要包含三部分的內容：水壓閥穩態模型和瞬態模型的建立；水壓閥內流場過流特性的研究；作用於水壓閥閥芯及閥體上的力特性分析。
  7. This software can be used in steady - state simulation, components matching, optimization and performance analysis of automobile air conditioning system

    利用該軟體能對汽車空調系統進行穩態模擬、匹配和優化計算以及性能分析。
  8. Some of problems in distillation technology process are studied using excel, matlab and chemcad. they are distillation with simple balance, determining accurately the position of sensitive plates in distillation tower, distillation of multi - components, and crude distillation at steady state. this paper shows how to solve bubble & dew points for binary ideal system and five cases of flash by means of excel and analizes reducing pressure affects on phase equilibrium as an example of distillation and separation ethyl benzene & phenyl ethylene below atmosphere

    基於excel 、 matlab和chemcad軟體，對蒸餾過程中的簡單平衡蒸餾、精餾塔靈敏板位置確定方法、多組分精餾等進行了數值計算與定量研究，對原油煉制常減壓塔進行了初步的穩態模擬，實現了用excel求解雙組分理想體系的泡、露點問題和閃蒸計算的五種情況，並分析了減壓對其相平衡的影響。
  9. Based on them, in this thesis, the one cycle control theory was successfully applied to the detection and control of apf for the first time. an apf using a novel unified constant - frequency integration control method was presented. the method employs an integrator with reset as its core component to achieve the detection and control of distortion current for apf at the same time

    文中導出apf功率開關占空比必須滿足的控制目標方程、求出apf主電路的穩態模型、建立了通用常頻積分復位控制apf的數學模型，用簡單的模擬電路實現apf的通用常頻積分復位控制電路和通用常頻積分復位控制apf系統。
  10. Examinations of steady status and analysis of dynamic experiments have been conducted on band - tube evaporator and parallel - flow condenser using r134a refrigerant. the steady examination show that the model error was under the allowable error, the inlet mass and enthalpy disturb experiments indicate that the subsection model, be good at reflecting the change of parameters of the heat exchanger, accord with the basic principle of thermodynamics theory and the actual work status. hence, the subsection simulation model research has important benefits both on theory and engineering application

    在進行模擬試驗時，以使用r134a作製冷劑的管帶式蒸發器和平行流式冷凝器為對象，完成了穩態模擬計算、試驗和動態模擬分析，穩態計算結果和試驗數據對比表明，其誤差在允許范圍內；進口質量和焓值的擾動試驗結果表明：本文所建的區段式換熱器模擬模型，能很好的反映換熱器性能參數的動態變化，與系統熱動力學理論和冷凝器、蒸發器的實際工作過程基本一致。
  11. Steady state simulation of a catalytic reforming reactor using a 17 - lumped kinetics

    十七集總催化重整反應器的穩態模擬
  12. Firstly, the performance is calculated at the design point of the ws - 9 aeroengine by using the numerical model established. secondly, after obtaining the performance coupling parameters, the steady - state performance of the non - designed points is caculated. third, respectively make the limitation of rotate speed of the high pressure rotor and low pressure rotor equal to corresponding parameters of designed point, after the data calculated compared with those of designed point and actual testing of the manufactory, the error is obtained

    首先，用所建立的發動機數學模型計算了發動機在設計點的各項性能，第二，根據發動機各部件的耦合特性參數計算得到發動機在非設計點狀態下的各項穩態性能，第三，分別設定限制高壓轉子轉速和低壓轉子轉速逼近設計點條件下對應的參數，將計算得到的性能數據與設計點性能進行了比較，並將非設計點的計算結果與生產試車過程實測的性能數據進行對比，給出了該穩態模型計算結果與實際試車數據的誤差。
  13. All these changes, which are of importance to subsynchronous oscillation analysis, cannot be described with the quasi steady state ( qss ) model any more. therefore, the deficiency of qss - model - based eigenvalue method is pointed out and a novel method named complex torque coefficient - test signal method is adopted to analyze the subsynchronous oscillation caused by hvdc or facts devices

    基於此，指出了採用準穩態模型進行hvdc系統次同步振蕩分析的局限性，並引入了分析hvdc或含有facts裝置的系統次同步振蕩問題的方法：復轉矩系數- - - -測試信號法。
  14. In this model, the dynamic response of the tire was expressed approximately by a series connection of a spring ( to represent the translational elasticity ) and a steady - state contact model ( to represent the contact between tire and road surfaces )

    該模型用一個彈簧（代表胎體的平移彈性）和穩態模型（代表胎面與路面的接觸作用，也稱接觸模型）串聯來近似表達輪胎的動態響應。
  15. The first chapter quotes three methods for determining the steady - state equivalent circuit parameters of an induction machine. they are the classical locked - rotor and no - load tests, the direct modification method and the recursive least - squares method. then a new parameter estimation method based on genetic algorithms is presented

    緒論首先引述了確定感應電動機穩態模型參數的其他三種方法：傳統的空載和堵轉試驗方法、直接修正參數法和遞推最小二乘法，並由此提出基於遺傳演算法的參數識別技術。
  16. Bayesian credibility model for experience rating based on mcmc method

    穩態模擬的貝葉斯經驗費率釐定信用模型
  17. Steady - state simulation of transcritical carbon dioxide automobile air - conditioner

    跨臨界二氧化碳汽車空調穩態模擬
  18. The main research contents are as follows : 1. build a steady - state simulation model of a general heat pump system, calculate system performances of using r22 and ( 30 / 70wt % ) r32 / r134a as refrigerants respectively, and get their performance curves as the working conditions change

    主要研究內容如下： 1建立了常規熱泵系統的穩態模擬模型，對採用r22和（ 30 70wt ） r32 r134a為製冷工質的系統分別進行了計算，得出其各自性能隨蒸發器進風或冷凝器進水溫度變化的關系。
  19. The team obsered significant decreases in glucose - insulin ratio and quantitatie insulin - sensitiity check index, and significant increases in baseline insulin and homeostasis model assessment

    研究小組觀察發現，血糖-胰島素比率和定量胰島素敏感性檢測指數明顯下降，而基線胰島素和內環境穩態模型評估指數明顯升高。
  20. The simulation methods and content about the mesh generation, the boundary condition of rotating wheels and moving ground of single car, and about the steady study on the two car running in row and overtaking process has shown the calculation results reliability and the numerical simulation methods feasibility. based on the comparison and analysis of mesh strategy, the descartes mesh strategy and the tetrahedron + prism mesh strategy are chosen. the continuous unsteady overtaking process of the vehicles, traveling with constant but unequal speed is replaced by a finite numerber of steps ; in each the relative position of both vehicles changes

    最後利用滑動交接面技術和動網格技術進行了瞬態的轎車超過某國產大型運輸車的數值模擬研究，在此之前國內外對此項技術均未有系統的研究和可借鑒的結論，以側向間距0 . 5倍轎車車寬為典型，用定性和定量兩種方法對比分析了超車過程中的轎車和運輸車與其單車情況及前文穩態模擬的異同，並將六種側向間距的瞬態結果與單車情況和穩態模擬結果進行了對比分析。
分享友人
分享到 Line

分享到臉書