粒度分級特性 的英文怎麼說

中文拼音 [lìdùfēnjítèxìng]
粒度分級特性 英文
sizing characteristic
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 級 : Ⅰ名詞1 （等級） level; rank; grade 2 （年級） any of the yearly divisions of a school course; gra...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled

    課題研究中，首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性，使其表面由憎水轉化為完全親水，確保與無機材料的復合質量；其次，通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾，使保溫材料在滿足必要的強度的前提下，導熱系數降至最小；並且，課題研究中成功解決了纖維在保溫材料中均勻分散的問題，達到了抑制保溫材料收縮的目的；最後，通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性，滿足施工的要求。
  2. Based on in - situ investigation and laboratory experiments, the article analyzed in detail the factors which affect the transportation and strength characteristics of gangue cemented tailing grain fillings such as powder coal, water - reducer, mortar density and grain size distribution

    摘要以現場調查和室內實驗為基礎，從粉煤灰、減水劑、漿體濃度、粒級級配等方面，對煤矸石作為膠結充填骨料的管道輸送特性和強度特性進行了詳細的分析。
  3. Based on an analysis of dynamic conditions for migration and precipitation of gold grains in water system and their diffusion in soil, this paper has advanced a discriminant formula for surfacce ore potential of gold anomalies from 1 : 50000 stream sediment survey, recounted methods for estimating the highest gold grade ores within the anomalies, calculated the discriminant indices for qinba area, and summed up index characteristics of ore - induced gold anomalies in 1 : 10000 soil survey, estimation formulae for orebody location as well as coefficients and constants of slope angles of various orders and grades

    摘要在分析金粒在水系中運移、落淤和在土壤中擴散動力條件的基礎上，本文建立了五萬分之一水系沉積物測量金異常地表含礦性的判別公式，闡述了推算異常內礦石最高金品位的方法並計算了秦巴地區的判別指數；總結出萬分之一土壤測量礦致金異常的標志特徵、礦體定位的估算公式及各級次地形坡度角的系數和常數。
  4. This paper gives a brief introduction of the formation mechanism of sma and the handing property of pavement from the aspects of theory and research. at the same time, this paper also studies the effect of aggregate size on road - related performance in some different grads. except, it also having inspected to use the sbs, the pe and the combination material of sbs and pe to analyze the influence to the function of material road

    瀝青瑪蹄脂碎石混合料（ sma ）以其溫度穩定性好、抗滑性能優良、低噪音、使用耐久等優點在公路建設中越來越受到重視，本文對sma組成特點，強度形成機理與路面使用性能從理論和試驗研究角度進行論述，並針對不同級配的瀝青瑪蹄脂碎石混合料，分析了粗、細集料的粒徑變化對其路用性能的影響，同時也考察了用sbs 、 pe 、 sbs和pe復合改性后的瀝青結合料對混合料的路用性能影響。
  5. Abstract : in light of thicker grain and smaller viscosity of debris flow, a segmented simulation of the debris flow with flume is presented. for the first time. more difficult resistance similarity is brought about by geometric rate without excessive coarsing and discontinuous similarity of sand grain composition in model is eliminated with different grain scale. on this basis the density similarity and sand conveying similarity are achived. the method presented is verified through a model test case

    文摘:針對水石流顆粒粗，粘性小的特點，提出了利用水槽進行分段模擬水石流的設想，首次通過幾何變率解決難度較大的阻力相似問題，改變了以往過度加糙的方式;通過變粒徑比尺的方法消除了模型沙級配不連續相似的問題，較好地實現了固體物質級配相似，達到了泥石流的密度相似和輸沙相似.通過水槽概化模型試驗實例，對本方法進行了驗證
  6. In this paper, the so preparing self - compacting concrete with low and middle strength using super fine mountain sand artifical sand and phosphorus slag is studied systemically. through the study the influence of the shape, the proportion of the dust and the grade of sand to the workability and the mechanical property of self - compacting concrete, it is found that super fine mountain sand artifical sand are not suit to prepare low and middle strength self - compacting concrete, but when they are combined and the additive and assistant band material are used, c20 - c40 high performance self - compacting concrete is prepared ; the corresponding additive is developed to solve the delamination caused by the low proportion of banding material ; the evaluating system for the workability of low and middle strength self - compacting concrete is built ; the controlling method for production, construction and curing was set up. and the result of the research is applied into several projects

    通過分析特細山砂和機制砂的顆粒形態、粉末含量、顆粒級配等特性對自密實混凝土的工作性能和力學性能的影響，發現特細山砂、機制砂不宜單獨用於配製中低強度等級自密實混凝土，宜將特細山砂和機制砂進行合理復配，並選擇合適的外加劑和礦物摻合料，優化配合比設計，可生產c20 c40中低強度等級自密實高性能混凝土；研製開發出了具有高效減水、保塑、抗離析功能的外加劑，有效解決了中低強度等級自密實混凝土由於膠凝材料用量少而出現的離析、泌水問題；應用正交設計方法，對因素和水平進行合理選擇，確定了生產中低等級自密實混凝土的最優配合比；建立了中低強度等級自密實混凝土的工作性評價體系；提出了生產、施工及養護的質量控制技術方法。
  7. Utilizing the property that the grains and the mixed stone have different specific weight and suspension speed as well as the airflow that is blown upward through the grains, the machine keep heavy impurity at the lower layer and uses a screen to force the material and impurity to move in different directions, thus separating the two of them

    該機是利用糧食與並肩石比重和懸浮速度不同的特性，藉助向上穿過糧流顆粒料間隙氣流作用，促使糧食與並肩石分級及重雜在下層，二者在往復運動篩板的作用下各自從相反方向運動，從而把並肩石從糧食中分離出來。
  8. Firstly, we present the conception and technology of software reuse, then deeply discuss key technologies of software reuse such as software component technology, software architecture and domain analysis, etc, whose software component, i. e. software chip, is the main part of software reuse ; software architecture is software framework, which can been reused as software framework of a large granularity and higher abstract level and offers the fundament and the context for component integration ; domain analysis concentrates on a special application domain so that the generality of the design of software component is not considered in wide range, meanwhile its ratio of the reuse increases

    本文首先敘述了軟體復用的概念和軟體復用技術，然後深入探討了軟體構件技術，軟體體系結構和領域分析等軟體復用中的關鍵技術，其中軟體構件技術（即軟晶元）是軟體復用的核心；軟體體系結構是軟體的骨架，可以作為一種大粒度的、抽象級別較高的軟體體系結構進行復用，並能夠為構件的組裝提供基礎和上下文；領域分析使軟體復用的目標集中在一個特定應用領域內，使構件的製作不需要在很廣的范圍內考慮其通用性，構件的復用率也相應增大。
  9. The second aspect : from qgp kinetic equations with collision integrals, by using the relaxation time approximation, we calculate the distribution functions to the second order correction. we obtain the distribution functions for quarks ( and anti - quarks ) and gluons under perturbation of the fluctuation of the color field. then in the high - temperature - low - density area, we discuss the characteristics of the distribution functions, and use t hem to get the net baryon density and the energy density

    第二，從有碰撞項的qgp動力論方程出發，忽略自旋，在色漲落擾動下，利用弛豫時間近似，得到夸克和膠子分佈函數的二級修正，通過數值分析重點討論了高溫低密情況下qgp中成分粒子分佈函數的特性，並且由分佈函數得到凈重子數密度和能量密度。
  10. Advanced technical ceramics - monolithic ceramics - general and textural properties - determination of grain size and size distribution characterized by the linear intercept method

    高級工程陶瓷.單片陶瓷.一般和紋理特性.粒度和粒度分佈的測定
  11. Advanced technical ceramics - monolithic ceramics ; general and textural properties - part 3 : determination of grain size and size distribution characterized by the linear intercept method ; german version en 623 - 3 : 2001

    高級工業陶瓷.單片陶瓷.總則和結構特性.第3部分:粒度
  12. This article mainly emphasize on the classification of coarse grained soil from the viewpoint of engineering application ( content of coarse grains ), vibrating method is introduced in the shaping. meanwhile, research is made to the water stability and shear strength. through research, following conclusions are obtained : coarse grained gradation is the main factors to determine its shear strength, when the coarse grains content is over 70 % or around, the maximum shear strength appears : the grains itself have a bigger effect on the shear strength

    以往對粗粒土的研究方法多採用擊實法，很少有人研究其抗剪強度特性，本文主要從工程應用的角度（粗粒含量）對粗粒土進行工程分類，成型方法採用振動法，同時對水穩定性、抗剪強度特性進行研究，通過研究得出以下結論：顆粒組成級配特性是決定其抗剪強度的主要因素，當粗粒含量在70左右時，抗剪強度最大；顆粒本身的特性對抗剪強度影響較大，顆粒越堅硬、大小顆粒相差越大、越不均勻、顆粒形狀越呈稜角狀、填築密度越大，抗剪強度就越高；含水量對抗剪強度的影響很小，可以忽略不計。
分享友人
分享到 Line

分享到臉書