纖變晶結構 的英文怎麼說

中文拼音 [xiānbiànjīngjiēgòu]
纖變晶結構 英文
fibroblastic texture
  • 纖 : 纖形容詞（細小） fine; minute
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. There are many adaptive changes in the two research subjects ( artemisia. songarica schrenk. and seriphidium. santolinum ( schrenk ) polijak. ) in morphology and anatomy, such as with the increase of the daily age, the root - shoots ratio increased ; the root became stronger ; the ratio of leaf volume and leaf area increased ; the volume of epidermic cell decreased ; the cut - icle and phellem layer on the surface of root thickened. stoma caved in leaf ; epidermal hair of leaf and stem well - developed, palisde tissue developed well, the cell gap decreased ; the spongy tissue disappeared ; leaf is kinds of isolateralthat is the typical xeromorphic structure ; crystal cell and fibric cell increased ; conducting tissue and mechanical tissue developed well ; bundle sheath appeared

    實驗研究的兩種菊科（ compositae ）植物（準噶爾沙蒿（ artemisiasongaricaschrenk ）和沙漠絹蒿（ seriphidiumsantolinum （ schrenk ） poljak . ） ） ，形態解剖方面的變化表現為：隨日齡增加，根長/株高比值日益增大；根系逐漸發達；體積與葉面積比逐漸增大；表皮細胞體積變小；角質層增厚；根外部出現加厚的木栓層；氣孔下陷；葉、莖部的表皮毛密布，柵欄組織日益發達；而細胞間隙日漸變小；海綿組織逐漸消失；葉面結構常為典型旱生結構? ?等葉面；晶細胞及纖維細胞數目增多；輸導組織、機械組織日漸發達；具有維管束鞘等等。
  2. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  3. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  4. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。
  5. It is the first time to get phbv fiber by melt spinning in china. and the changes of fiber crystallization structure and orientation structure under force were studied

    並在國內首次通過熔融法制備了phbv纖維，首次論證了纖維結晶結構的變化及其在外力作用下取向結構的變化。
  6. Structures of the camp fibers were also discussed. the results showed that the hydrogen bonding between the pva and caa damaged the regularity of crystalline field and the crystallinity of the fibers reduced. the cluster structures of each phase in the blend were changed and movement of the molecular chain segment was reduced

    對camp纖維結構的研究表明， pva與丙烯酸-丙烯酰胺共聚物（ caa ）共混后，大分子間的氫鍵作用破壞了pva晶區結構的規整性，導致pva在camp纖維中的結晶性明顯減弱；兩種共混組分的聚集態結構發生變化，大分子鏈段運動受到影響。
  7. The microcrystalline was same to the direction of electric field. the microcrystalline orientation of the film that was obtained by melting pvdf congealing in the effect of electric field changed along electric field obviously. comparing with the film congealing without electric field their crystalline plate become thick

    發現pvdf纖維在電場作用下微觀結構變化較大，極化后微晶取向發生較大變化，極化以後微晶變化為沿電場方向取向的厚片狀，熔融態的pvdf在電場作用下凝固時變化更明顯，與不加電場直接凝固的pvdf膜相比，在電場作用下幾乎所有的分子鏈都沿電場方向取向所以出現有序的片晶結構，而且結構緻密。
  8. The results showed that the in - situ formed tibi particles which had a size of about 50nm, exhibited a homogenous dispersion in the copper matrix. moreover, the interface between the nanoscale particles and the copper matrix was clean, and there was no certain location relationship. due to their reinforcement, the tensile strength and hardness of the in - situ cu - tib _ 2 nanocomposite significantly improved

    通過光學顯微鏡、 tem 、 xrd等對cu - tib2原位復合材料進行了金相組織、微結構分析，原位復合材料的鑄態金相組織中彌散分佈著團簇狀的tib2顆粒；形變態金相組織中tib2顆粒呈纖維狀排列； tem觀察表明：在基體內存在著尺寸約為50nm 、彌散分佈的tib2顆粒，且tib2顆粒與基體之間界面清晰，但由於tib2結構與銅晶體結構的差別較大， tib2顆粒與基體之間無固定的位向關系；納米tib對銅基體有良好的增強作用。
  9. Because of the crystalline leading to the piezoelectricity of pvdf, pvdf fiber and pvdf / pa11 fiber ' s structures and crystalline were investigated and analyzed by means of wide angle x - ray diffraction, differential scanning calorimetry, fourier transmittance infra - red spectroscopy and scanning electron microscopy, etc. it was shown that there are two kinds of crystalline - a phase and b phase in pvdf fiber

    由於pvdf的壓電性與晶體結構有關，於是利用紅外光譜、差熱分析、廣角x光衍射和掃描電鏡等測試手段對純pvdf纖維以及pvdf pa11共混纖維的結構性能及晶型轉變進行了深入的研究。
分享友人
分享到 Line

分享到臉書