膠凝熱 的英文怎麼說
中文拼音 [jiāoníngrè]
膠凝熱
英文
heat of gelation-
Mas precursor powders are prepared using aluminium sulfate, colloidal silica, and magnesium nitrate as raw materials via sol - gel methods, dsc - tg and xrd show that the mas precursor powders transform to cordierite completely at 1300
以硫酸鋁、硝酸鎂和硅溶膠為原料，採用溶膠-凝膠法，制得mas先驅體粉末， xrd表明，該粉末經1300的熱處理后，完全轉變為堇青石。Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )
體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。08. 02 test method for gel time and peak exothermic temperature of reacting thermosetting resins
活性熱固樹脂膠凝時間和最大放熱溫度測試方法Heat sets eggs and cold sets jullies
加熱能使蛋凝結，寒冷能使凍膠凝固。Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled
課題研究中，首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性，使其表面由憎水轉化為完全親水，確保與無機材料的復合質量；其次，通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾，使保溫材料在滿足必要的強度的前提下，導熱系數降至最小；並且，課題研究中成功解決了纖維在保溫材料中均勻分散的問題，達到了抑制保溫材料收縮的目的；最後，通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性，滿足施工的要求。The results show that in 185 saturated steam, pyrite tailing doesn ' t hydrate alone, but is converted into calcium silicate hydrate when mixed with lime
結果表明： 185飽和蒸汽壓下，硫鐵尾礦不具有水熱水化的能力，硫鐵尾礦與石灰可以形成具有膠凝性能的水化產物。For 2h, the osc and special surface area decreased sharply, meaning a bad thermal stability. the osc and special surface area of the samples prepared by precipitation keep very well after aged, exhibiting a promising thermal resistance. while the samples prepared by dipping method have a much more stable osc at different temperature, that is, they have a good thermal stability
研究表明，採用溶膠?凝膠法制備的樣品在老化前具有最大的儲氧量和比表面積，但經高溫老化后，其儲氧量急劇下降，表現出很差的抗高溫老化性能；採用沉澱法制備的樣品在老化前後，其儲氧量和比表面積降幅最小，有良好的高溫熱穩定性能；採用浸漬法制備的樣品不管老化與否，其儲氧量並不隨著儲氧溫度的改變而大起大落，表現出較好的熱穩定性。The pyrolysis process of the cmf aerogel was investigated firstly by means of ir technique. the results showed an infrared active vibration occured in the temperature range of 400 - 600 " c, which was corresponding to the tubstatic graphitized structure formed hi these aerogels
採用ir分析技術跟蹤c _ mf氣凝膠的熱解過程，發現400 600之間樣品中出現石墨化結構的紅外活性振動，表明炭氣凝膠的微結構中開始有亂層石墨化微晶出現。It is shown that the liquid phase methods, in which particularly methods of the sol - gel, deposition, micro - lacteous, hydrothermal / solvothermal reaction and hydrolyze, should be mentioned, as the most wildly used method in the present
指出液相法，尤其是溶膠凝膠法、沉澱法、水解法、微乳液法、水熱溶劑熱法等是目前制備納米金屬氧化物材料最廣泛應用的方法。With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion
研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。The sol - gel method and solid - state thermal reaction technique were used to prepare the composite oxides with variable lithium content. the doping treatments of some compounds were conducted. dta and tg were used to analyse synthesis mechanism, xrd to analyse phase composition, sem to observe morphology, li - b / licl - kcl / oxide simulated thermal cells to analyse the lithium - intercalation mechanism and properties of cathode material
實驗中採用溶膠?凝膠工藝和固相熱反應技術制取相應的不同鋰含量的復合氧化物，並嘗試對某些化合物進行適當的摻雜處理，應用dta和tg分析合成機制、 xrd分析所得物的物相組成、 sem觀察其形貌，模擬li - b / licl - kcl /氧化物的單體熱電池來分析陰極材料的嵌鋰機制及其電極性質。Firstly, a situ - polymerization method as the preparation process of gplb is introduced and pmma as the polymer matrix of the gel electrolyte is selected. the thermal polymerization process of the gel electrolyte is also optimized
首先，採用了現場聚合法制備凝膠聚合物鋰離子電池的工藝，根據該制備工藝選擇pmma基作為該凝膠聚合物電解質的聚合物體系，然後對凝膠的熱聚合工藝進行了優化，確定了最佳的熱聚合工藝。Focusing on the preparation process of lithium battery, thermal polymerization process of the gpe and optimizing the component of the gel electrolyte, the paper intends to resolve some of the key problems mentioned above and to prepare a gplb with good performance
本論文正是從目前凝膠聚合物鋰離子電池存在的這些問題出發，從鋰離子電池的制備工藝和凝膠的熱聚合工藝研究著手，對gpe的組份進行了改進和優化，制備了性能良好的凝膠聚合物鋰離子電池。Design and fabrication of pyroelectric infrared detector based on sol - gel derived litao3 thin film
溶膠凝膠鉭酸鋰薄膜熱釋電紅外探測器的設計與制備The nanometer tin dioxide powder aspects were prepared with the colloid - hydrothermal system which takes the merit of sol - gel law and hydrothermal method, and combine forming new preparing method - colloid - hydrothermal after the analysis of a large number of documents to the home and abroad and comparing to more than ten kinds of methods preparing the nanometer powder aspect, the nanometer stannic dioxide powder is prepared with the colloid hydrothermal system, and has avoided the pure sol - gel law to calcine with high temperature later period which causes the hard agglomeration
本文通過對國內外大量文獻的分析，對制備納米粉體的十多種方法進行了比較。取溶膠?凝膠法和水熱法各自的優點，結合形成新的制備方法? ?膠體水熱法。用膠體水熱法制備納米二氧化錫粉體，避免了純溶膠?凝膠法後期用高溫煅燒得到二氧化錫超細粉體時產生的硬團聚現象。Methods of testing plastics - other properties - determination of gelation time of thermosetting resins using a hot plate
塑料試驗方法.第8部分:其他性能.試驗方法835d :用熱板測定熱固性樹脂膠凝時間Antimony doped tin oxide ( ato ) and indium tin oxide ( ito ) thin films have been prepared by a sol - gel process using inorganic metal salts as precursors. the effects of heat - treatment atmosphere, temperature, time and dopant content on the electrical and optical properties of thin films were investigated. the fine patternings of the ato films were fabricated by chemical modification and sol - gel method
本文以無機鹽為出發原料，採用溶膠?凝膠法制備了光學和電學性能較為優良的摻銻二氧化錫（ ato ）薄膜和摻錫氧化銦（ ito ）薄膜，進一步研究了熱處理氣氛、溫度、時間、摻雜量對薄膜電學及光學性能的影響。And then, zno thin films were synthesize on quartz and silicon substrates by sol - gel dip - coating and spin - coating. the properties of the films and the effects of growth parameters on the quality of zno films were studied using x - ray diffraction, optical absorption, photoluminescence techniques, etc. to modify the energy gap of the zno, mg2 + was added in the sol - gel solution, and mgxzn1 - xo films were prepared by the same method as that for zno films
利用溶膠凝膠法成功地在石英玻璃和單晶矽片等襯底上制備出了c軸擇優取向的zno薄膜，並利用x射線衍射儀、紫外-可見光光譜儀、熒光光譜儀等對zno薄膜的結構和性能進行了測試、分析，並研究了熱處理參數等條件對zno薄膜性能的影響。Testing methods for paint - part 9 : coating powders - section 1 : determination of gel time of thermosetting coating powders at a given temperature
塗料的試驗方法.第9部分:塗料粉末.第1節:在給定溫度下測定熱固性塗料粉末的膠凝時間The protein in crude rice underwent no denaturation or gelatine because it never suffered from any hot and humid actions, which was a determinant factor of malt yellow rice wine features ( rich nitrogen amino acid )
生大米中的蛋白質，因未受濕熱作用而變性或膠凝化，決定了免蒸煮麥曲黃酒氨基酸態氮豐富的產品營養特徵。分享友人