自調電弧 的英文怎麼說

中文拼音 [diàodiàn]
自調電弧 英文
self adjusting arc
  • : Ⅰ代詞(自己) self; oneself; one s own Ⅱ副詞(自然;當然) certainly; of course; naturally; willin...
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 名詞1. [數學] (圓周的任意一段) arc2. (古代指弓) bow
  1. Secondly, on the base of the analyzing design characteristic, this paper presents theoretical basis according to " design specification about steel gate in water conservancy and hydropower engineering " ( thereinafter for short specification ). it introduces module design means of hmvcad system. in the light of this means, it develops the module that can design the gate according to original data and specification automatically, the module of making the original design by user ' s experience, the module of majorized adjustment, the module of alarm device

    其次,本文在分析了形閘門設計特點的基礎上,按《水利水工程鋼閘門設計規范》 ( dl t5039 - 95 ,以下簡稱《規范》 )給出了設計的理論依據,介紹了hmvcad系統的模塊設計方法,據此研製了能根據原始資料動按規范設計的程序模塊,以及據用戶經驗進行初步設計、優化調整、預警裝置等功能模塊。
  2. Analyze and compare pid and vague, single neuron etc. control strategy, and combine with single neuron self adaptive gain, self adaptive right value and preventive integral saturation etc. control strategy. have improved single neuron control algorithm, may restrain efficiently to disturb, reduce broken arc and short circuit etc. phenomenon, make systematic control effect and robustness get to strengthen, also have certain application reference value for the design of the dc arc furnace

    通過對pid 、模糊、單神經元等控制策略的分析比較,將單神經元增益與權值的適應調節、抗積分飽和等控制策略相結合,改進了單神經元控制器演算法,可以有效抑制擾動,減少斷、短路等現象的發生,使系統的控制效果和魯棒性都得到增強,對爐控制系統的設計也具有一定的應用參考價值。
  3. Then the idea of integral control of automatic resonance and single - phase earth faulted line selection was put forward

    並在此基礎上給出了補償網中消線圈調諧與單相接地故障選線一體化的綜合控制思路。
  4. Based on the theory of piecewise - linear, the paper carries through the research of model self - adaptive control to electric arc - furnace electrode regulator system ( eafers ), and the digital self - adaptive control law of reference model is deduced. then, we designed the software simulation system of eafers according to the law, though which we studied the character of eafers. finally, a set of physical model of eafers, which is realized by hardware circuit, is designed according to the former research

    本文首先應用分段線性化理論,對調節系統的模型參考適應控制演算法進行了研究,推導出全數字化的模型參考適應律;然後根據推導出的適應律成功的設計出了的軟體模擬系統,用軟體對極控制進行了模擬研究;最後利用路構造出一套完整的爐煉鋼極控制硬體模擬系統,對調節進行了實驗室路模擬研究。
  5. Using the traits of arc adjust itself of the co _ 2 welding, adopting slow - descending feature or even feature of electrical source equipping with system that delivering the welding rod at the invariable speed, then, the arc burning steadily is realized, and the quality of welding is improved

    利用co _ 2氣體保護焊調節特性,採用緩降或平硬特性的源配等速送絲系統,通過改變源空載壓來調壓,再利用壓和熔化速度之間的關系調節焊絲熔化速度使之等於送絲速度,最終實現的穩定燃燒。
  6. Self adjust function of electric arc, easy arc igniton, less spatters, perfect weld appearance

    調節能力強,引成功率高,焊接飛濺小,熔敷率高,焊縫成形美觀。
  7. The tap - changer is made with solid state relay as its working mechanism and controlled by microprocessor. this switch has totally cancelled the mechanical drive organization, by the microprocessor according to the voltage of second side microprocessor decide the working condition of solid state rely, high regulation speed, need not transition resistor, rush current is low. operating frequently ; there is no electric arc to produce, can put in the fuel tank of the voltage transformer directly ; the structure is simple, the fabrication cost is low, benefit and use widely among the voltages transformer of distribution

    其中的有載調壓分接開關,它是一種完全由固態繼器作為分接開關執行機構,由單片機控制的有載調壓的變壓器分接開關。該開關完全取消了機械傳動機構,由單片機根據變壓器二次側壓的高低,決定與變壓器各分接頭聯接的固態繼器的工作狀態。調節速度快,改變分接頭時不需過渡阻,沖擊流小,可頻繁操作;無產生,可以直接放在變壓器油箱中;結構簡單,造價低,便於在配變壓器中推廣使用。
  8. Arc self - regulation

    調
  9. By adjusting the automatic tracing coil of arc extinction for switch stand and analysing technical parameters of arc extinction coil in normal operation, the paper indicates some problems should be taken care of, so as to operate properly automatic tracing coil, to remove the excess voltage of grounded arc and to ensure reliable power supply

    摘要通過調試開關站動跟蹤消線圈,分析動跟蹤消線圈正常運行技術參數,指出設計運行中應注意的問題,保證動跟蹤消線圈正常運行,消除光接地過壓,保證可靠供
  10. Application to parameters of pid control based on genetic algorithm

    調節系統的校正控制
  11. The results prove that the scheme increases the stability of electrode apparently, current fluctuating has been reduced, speed of system echo has been improved. the system has fine self - adaptive ability and fine ability to resist interference

    現場調試結果表明採用的控制方法大大提高了極控制的穩定性,流波動降低,系統的快速性大大提高,系統具有較強的適應能力和魯棒性。
  12. The basic principle of biasing magnet automatic resonance regulated petersen coil and its operating condition at wuzhan substation were introduced

    摘要介紹了偏磁式調諧消線圈裝置在武漢市武展變站運行的狀況。
  13. The paper explains the method of the petersen coil parameter selection and expatiates the working principle of micro - computer controller. new methods of on - line measuring of the capacitive current and the control of the series resistance are put forward ? which lead to the integration of the automatic resonance and the faulted line selection in a compensating network

    文中說明了消線圈參數的選擇方法,闡述了微機控制器的工作原理,提出了在線測量補償網對地流以及控制串聯阻的新方法,實現了補償調諧與單相接地選線的一體化。
  14. Considering the actual condition and development of the 35kv distribution network in changzhi district ? a new type of automatic resonance devices with on - line tap - changer is developed for the capacitive current compensation and faulted line selection in case of an earth fault

    結合長治地區35kv配網的實際情況和發展趨勢,研製了新型調匝式動跟蹤調諧消線圈接地補償裝置,用於補償網單相接地故障時的流和接地選線。
  15. The paper presents a new e. a. f ( electric arc furnace ) adaptive control method based on a neural network ' s compensation by predicting. the neural network is used here to predict the condition of e. a. f, then to control an actual system by compensating the outputing of routine controller. the dynamic modification of the weighting value of a neural network by improved dbd algorithm serves as an adaptive method. hence the system can adapt itself better to the variations in load and external interference. which has yielded a satisfied control quality

    調節器採用一種新的適應控制方法- - -基於神經網路預估補償的適應控制。採用神經網路預估對象狀態,進而對常規控制器的輸出做補償以控制實際對象,利用改進的dbd演算法動態修改神經網路權值作為適應方法,使系統較好地適應負荷和外擾的變化,從而獲得滿意的控制質量。
分享友人