致冷液 的英文怎麼說

中文拼音 [zhìlěngyè]
致冷液 英文
refrigerant fluid
  • 致 : Ⅰ動詞1 （給與;向對方表示禮節、情意等） deliver; send; extend 2 （集中於某個方面） devote （one s ...
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 液 : 名詞（液體） liquid; fluid; juice
  1. Hydrotropic solution of calcium chloride is the important cryogen for refrigerator and ice making. it is also a good anti - freeze agent and agglomerating agent in construction for concrete hardening and cold hardiness of sand mortar

    氯化鈣水溶液是冷凍機用和製冰用的重要致冷劑，基建上能加速混凝土的硬化和增加建築砂漿的耐寒能力，是優良的建築防凍劑凝結劑。
  2. Acute toxicity of 5 kinds of perm lotion

    冷燙液皮膚刺激性和致敏性試驗研究
  3. In persons with underlying medical conditions, especially liver disease, can cause bloodstream infections characterised by fever, chills, decreased blood pressure, blistering skin lesions, and often, death

    患者如本身有其他疾病，尤其是肝病，便可能引致血液感染，病徵為發燒發冷血壓下降皮膚出現水泡，嚴重者會引致死亡。
  4. In persons with underlying medical conditions, especially liver disease, it can cause bloodstream infections characterized by fever, chills, decreased blood pressure, blistering skin lesions, and death in severe cases

    患者如本身有其他疾病，尤其是肝病，它可能引致血液感染，病徵為發燒發冷血壓下降皮膚出現水泡，嚴重者會引致死亡。
  5. In the future this may be represented by illumination of the coolant fluid level warning light and incorrect operation of the engine even so far as the engine failing to start

    此後，這將導致發動機冷卻液液位報警燈點亮及發動機工作不正常，甚至導致發動機無法啟動。
  6. Extensive tissue damage or cryogenic burns can result from exposure to liquid oxygen or cold oxygen vapors

    暴露于液氧或冷的氧蒸氣會導致大面積組織損傷或低溫燒傷。
  7. The results indicate that soil water moves from the warm end to the cool end in both gaseous and aqueous phases under temperature gradient, which causes changes of matric po

    研究表明，在溫度勢梯度影響下土壤水分以液態和汽態兩種狀態從暖端向冷端遷移，從而引起暖端基質勢的相應改變，導致水分在兩種勢梯度交互作用下逐漸達到平衡。
  8. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  9. Calculated the aggregation frequency for the crown - shaped liquid droplets on condersor at > 90 in light of the properties of liquid droplets distribution function, and the detailed balance equation is derived for liquid - vapour phase transition

    摘要根據冷凝壁面液滴分佈函數的概念和性質，計算了> 90時冷凝壁面球冠形液滴的融並頻率；導出純氣液相變下冷凝壁面的細致平衡方程。
  10. 8. no parts and components warranty will be delivered if such parts and components as body, cylinder cover, cylinder liner, water pump, oil cooler and compressor are cracked in winter, because customer fails to drain water immediately or completely exclusive of case when anti - frozen fluid is used after shutting down the power unit

    因冬季顧客停機時未及時放水，或水未放凈採用防凍液的除外，導致機體缸蓋缸套水泵機油冷卻器空壓機等零部件凍裂，相關零部件不予保修。
  11. The results show that the yield of terephthalic acid increases and the mass fraction of 4 - carboxybenzaldehyde decreases when the reflux temperature or the reaction pressure increases, or when the reflux ratio decreases, but that the combustion rate of p - xylene and acetic acid increase simultaneously

    計算表明：冷凝迴流溫度的升高、迴流比的降低和反應壓力的升高都導致反應溫度增加，雖然醋酸和對二甲苯的副反應消耗增加，但液相中對羧基苯甲醛的質量分數降低和反應收率增加。
  12. Specification for calculation procedures for static measurement of refrigerated light hydrocarbon fluids

    致冷輕質液態烴靜態測量用計算規范
  13. This contact risks causing premature wear of the pipe due to chafing, which long term could lead to a leakage of coolant fluid

    這種接觸會造成早期的出水管老化，長時間會導致冷卻液的泄漏。
  14. Chart is committed to being the preferred global supplier of engineered equipment required throughout the cryogenic liquid supply chain

    查特致力於成為全球深冷液體供應鏈所需設備的首選供應商。
  15. Natural gas purification plants must remove co2 because the methane is heading for a liquefied natural gas tanker and must be kept free of cold, solid carbon dioxide ( dry ice ) that could clog the system or because the co2 concentration is too high ( above 3 percent ) to be allowed on the natural gas distribution grid

    天然氣純化廠中，由於甲烷要導入液化天然氣槽，必須嚴防冰冷堅硬的二氧化碳（乾冰）可能堵塞系統，或二氧化碳濃度過高（超過3 % ）導致無法用於天然氣供配網，因此必須脫去二氧化碳。
  16. Lcd modules with backlight are available upon your choice. these make use of easy - to - see light sources such as ccfl, el and led. the following examples show the structures of lcd modules with backlight

    您可以選擇帶背光源的液晶顯示模塊，這些模塊使用例如ccfl冷陰機熒光燈， el場致發光器和led發光二極體等可見光源，下面是帶背光源的液晶顯示模塊的結構示意。
分享友人
分享到 Line

分享到臉書