蒸發冷凝 的英文怎麼說

中文拼音 [zhēngfālěngníng]
蒸發冷凝 英文
evaporative condenser
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 凝 : 動詞1. （凝結） congeal; curdle; coagulate 2. （注意力集中） fix
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. The condenser should be hot enough to allow venting of some of the volatiles carried in the steam.

    冷凝器的熱度，應足以使蒸氣中的一些揮發物質排出。
  2. This paper researches diathermancy and fluidity of condenser, evaporator, compressor, and capillary in detail. maths models of condenser, evaporator, compressor, and capillary are established and model predigesting and modifying methods are done methods are given in this paper, which can transfer the practical system into the simulating system. in the basis of refrigerating system character, components models are modified in the system administrative levels

    本文詳細研究了蒸發器、冷凝器、壓縮機和毛細管的傳熱特性和流動特性，建立和發展了蒸發器、冷凝器、壓縮機和毛細管數學模型，並進行了相應的模型簡化和修正方法研究，建立了從實際系統到模擬系統的轉換方法；本文針對各製冷系統的特點，在系統層次上進行了部件模型的修正研究，建立了相應的修正模型和演算法。
  3. Water vapor from the evaporative recovery process may be recondensed, and also reused.

    蒸發回收過程產生的水蒸汽可再冷凝，也可再用。
  4. It is the first time in china to set the speed increase gears form in the new compressor and to adopt several new techniques including the condenser with oil - separator built - in, jet exhauster and electrical expansion valve used to supply liquid for the flooded evaporator in the unit

    本壓縮機在國內首次採用了帶增速齒輪的形式，冷水機組在國內內首次採用了內置油分冷凝器、引射器和電子膨脹閥對滿液式蒸發器供液等新技術。
  5. The problem is often overcome by the use of chilled water or the fitting of a reflux condenser which, via the continued refluxing of vinyl chloride monomer, utilizes its laten heat of evaporation for cooling purposes

    解決問題的辦法是採用冷凍水或安裝迴流冷凝器，迴流冷凝器連續迴流氯乙烯單體，利用單體的蒸發潛熱冷卻反應物料。
  6. They used for making tubes of condenser or vapourizer of refrigeration, for waterfeeder, for capilliary tube in meters and oil - conducting pipe union for mechanical equipment

    該產品廣泛應用於機械、電氣儀表、汽車、輕工、化學工業等部門，作為製冷設備的冷凝器，蒸發器管、供水熱水管，儀表毛細管及機械設備聯結油管等部件。
  7. They used for malcing tubes of condenser or vapourizer of refrigeration, for waterfeeder, for capilliary tube in meters and oil - conducting pipe union for mechanical equipment

    該產品廣泛應用於機械、電氣儀表、汽車、輕工、化學工業等部門，作為製冷設備的冷凝器，蒸發器管，供水熱水管，儀表毛細管及機械設備聯結油管等部件。
  8. The results indicate that the qualitative behavior in this process is similar to that observed in condensation of vapor at or above atmosphere pressure, the coefficient of heat transfer for condensation in tube, the coefficient of heat transfer in total increase with the increasing of heat flux density and vapor pressure. however, heat flux density and vapor pressure have a more significant effect on them

    發現水平管內低壓蒸汽冷凝過程與常壓條件下蒸汽冷凝過程相同，管內冷凝傳熱膜系數、總傳熱系數隨熱流密度、蒸汽壓力的增大而增大，但熱流密度、蒸汽壓力對低壓蒸汽冷凝有著更為顯著的影響，管外冷卻水流量對其影響並不明顯。
  9. The tensile and compression experiment on bulk nanocrystalline ag prepared by igc method was carried on mt810 with different grain sizes and zwick 10tn2s machine at different strain rates under normal temperature respectively. the stain rate sensitivity m was found to be 0. 025, which was extremely lower than the ordinary values. also the work hardening exponent is very low

    本文從用惰性氣體蒸發冷凝和真空原位壓結法（ igc ）制備得到的直徑80mm ，厚度7 . 6mm的大尺寸納米晶金屬ag樣品上切割得到符合力學實驗要求的拉伸和壓縮試樣，在mts810和zwick精密力學測試機上分別精確測定了拉伸和壓縮應力?應變曲線與晶粒尺寸和應變速率的關系。
  10. Thermal performance analysis of indirect evaporative cooler with condensation in primary airflow

    有冷凝和沒有冷凝的板式間接蒸發冷卻器性能分析比較
  11. The analytical results indicate that the temperature and the concentration of water vapor have been changed in the condition of condensation and also provide evidence of structural optimum of indirect evaporative cooler

    數值模擬以及熱力性能分析的結果表明，冷凝使得間接蒸發冷卻器內部的溫度場、水蒸汽濃度場等的分佈發生了變化，換熱效果以及有用能的利用狀況也發生了變化。
  12. Extracting can also be done by partially freezing the salt solution

    加熱蒸餾法是將鹽水加熱，使水分蒸發，然後再使蒸汽冷凝成水。
  13. The theory of interface of two - phase fluid id used to analyze the role of the interfacial heat transfer resistance in cond ensation process, it shows that the interfacial heat transfer resistance can not be ignored under such a vacuum condition, and the effect on heat transfer process becomes declined with the increasing of vapor pressure

    應用兩相界面理論分析了汽液界面熱阻在水平管內低壓蒸汽冷凝過程中所起的作用，發現實驗范圍內汽液界面熱阻不可忽略，且其對冷凝傳熱過程的影響隨蒸汽壓力的增大而減弱。
  14. Abstract ： in this paper, the methods including the reduction ball - milling, the optical induction, the chemical reduction, the liquid phase reduction, the liquid - solid phase reduction, the spray pyrolysis, the evaporation and condensation, and the atomization et al. which have been used for preparation of nanometer silver flakes and nanometer spherical silver powders in china since the 1990s were summarized under categories, the features of each method were compared, the development of preparation technology was looked forward to, in the meantime, the present application and potential application of nanometer silver powders were expounded

    摘要：本文分類總結了20世紀90年代以來國內納米片狀銀粉和球形銀粉的制備方法，包括還原球磨法、光誘導法、化學還原法、液相還原法、液-固相還原法、噴霧熱分解法、蒸發冷凝法及霧化法等，比較了各種方法的優缺點，展望了納米銀粉制備技術的發展，同時，論述了納米銀粉現有的和潛在的用途。
  15. In this article, on the basis of evaporation & condensation principle, a research on the heat and mass transfer of liquid dehumidification and seawater desalination was developed

    本文對液體除濕和海水淡化中蒸發冷凝傳熱傳質過程展開了研究。
  16. As well - known, there is an induced current on the surface when metal material is in the high frequency electromagnetic field, since tending to skin heating effect to make the temperature of metal material surface go up promptly, surface beginning melt when temperature reaches the melting point of metal, metal material is heated up continuously by surface to core till the metal droplet of melting

    自懸浮定向流技術制備金屬納米微粒與一般的蒸發冷凝法有所不同，其原理是：金屬材料在高頻電磁場中產生表面感生電流，由於趨膚加熱效應使得金屬材料表面的溫度迅速升高，當溫度達到金屬的熔點時表面開始熔化，通過熱傳導作用金屬材料由表面到芯部不斷加熱直至熔化成金屬液滴。
  17. Based on the results of numerical simulation, the conversion and destruction of available energy had been studied. the exergy destruction in and out of the heat exchanger were also researched. the thermal efficiency and exergy efficiency of indirect evaporative cooler were defined according to the thermodynamic performance of heat and mass transfer

    在大量數值模擬的基礎上，分析了考慮與不考慮冷凝的間接蒸發冷卻過程中能量以及有用能的轉化和損失情況，並根據兩種情況下的收益火用和代價火用的特點，分別定義了火用效率的計算表達式。
  18. The phenomenon of condensation of low - pressure vapor in a horizontal tube is studied

    結合蒸發式冷凝器的設計，對水平管內低壓蒸汽冷凝現象進行了實驗研究。
  19. Three - dimensional numerical simulation of indirect evaporative cooling process with condensation in primary airflow

    一次空氣有冷凝的間接蒸發冷卻過程的三維數值模擬
  20. Measurements were made of system pressure, mass flow rate of steam, air, and cooling water, temperatures of condensing flow and cooling flow, and the water level of boiler. the major phenomena observed in the present experiment are similar to those by other investigators. the mass flow rate of steam, the system pressure and air content are the most important factors affecting steam condensation

    實驗結果表明，維持二次側冷卻水流量不變，無論對于純凈蒸汽還是含有空氣的蒸汽冷凝，隨著蒸汽發生器加熱功率的增大（即蒸汽流量增大） ，有效冷凝段長度將加長；當蒸汽中含有少量空氣，有效冷凝段長度也會明顯加長；提高系統壓力，有效冷凝段長度將縮短。
分享友人
分享到 Line

分享到臉書