螺旋管過熱器 的英文怎麼說

中文拼音 [luóxuánguǎnguòrèqì]
螺旋管過熱器 英文
spiral superheater
  • 螺 : 1. [動物學] （軟體動物） spiral shell; snail; conch 2. （螺旋形的指紋） whorl （in fingerprint）
  • 旋 : 旋Ⅰ動詞1 （旋轉） whirl 2 （用車床切削或用刀子轉著圈地削） turn sth on a lathe; lathe; pare Ⅱ名詞...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 螺旋 : 1 （具有螺紋的圓柱體 屬于斜面類的簡單機械） corkscrewspin; screw; spiral; helix 2 （螺旋現象;尾旋...
  1. Our factory increase a set of intensifier with non - grade - adjustable rating speed to form the intensive air drying, the wet material mixed with hot air fully by screw feeder in the intensifier and material surface is crashed into fine granules and moving to the outlet as well as drying, under rapid rotating hitting and pushing. in the long run, the materials get a further even drying in the dryer pulled by the wind force and those wet and weighty granules the wind force can not pull continue to be crashed, dried until they are pulled by the wind force into the dryer

    我廠強化型氣流乾燥是在基本型上增加一套轉速可以無級調節的強化器組成，濕物料通過螺旋加料器進入強化器后和熱氣流充分混合，在飛速旋轉的擊刀擊碎和推進下，物料被破碎成細顆粒，在乾燥同時向出口移動，最後在風力吸引下進入乾燥管，進一步均勻乾燥，風力無法吸引的濕重顆粒繼續被擊碎、乾燥、直至能被風吸起進入乾燥管。
  2. The results show that while the mass flow of refrigerant is 1. 85g / s, the inlet temperature of refrigerant is 18. 9, the evaporating pressure is 0. 62mpa, the mass flow of water is 31. 1g / s, and the inlet temperature of water is 36. 9, the refrigerant of miniature evaporator wholly vaporizes in the tube, and the heat transfer rate is 342w. it achieved the demand of design

    經過實驗測試，當製冷劑質量流量為1 . 85g / s ，製冷劑入口溫度為18 . 9 ，蒸發壓力為0 . 62mpa ，水的質量流量為31 . 1g / s ，水的入口溫度為36 . 9 ，此時，螺旋管蒸發器內製冷劑完全蒸發，換熱量342w ，達到了微型蒸發器的預期設計要求。
  3. Design of the spiral finned tube low temperature reheater has been made by means of applicable investigation of spiral finned tubes, some mathematical - physical models for computing spiral finned tubes wall temperature have been set up

    通過對螺旋肋片管的應用探討，進行了螺旋肋片管低溫再熱器的設計。
  4. The purpose of this study is to investigate the formation of liquid falling film and its flow behavior on the surface of a horizontal twisted and fluted tube used in the case of wet flue gas desulfurization, desalination, and so on

    本文從理論上研究了水平螺旋槽管壁面液膜的形成機理及流動特性，為工業生產過程中高效換熱器的應用提供理論基礎。本文做的主要工作有： 1
分享友人
分享到 Line

分享到臉書