補償衰減器 的英文怎麼說

中文拼音 [bǔchángshuāijiǎnqì]
補償衰減器 英文
compensated attenuator
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 衰 : 衰動詞（衰弱） decline; wane
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  1. After that, a fuzzy neural network control design with mixed performance was proposed aiming at different requirement to uncertainty, which separately compensate parameter uncertainties and external disturbances of robot system. this method can ensure the robust stability that under a prescribed attenuation level for the external disturbance, and also strengthens compensation to parameter uncertainties. the theory of hybrid force / position control is clear, however, it is difficult to implement

    針對實際應用中對不確定的不同要求，又提出了一種具有混合/性能指標的神經網路控制方法，對機器人不確定性（包括參數不確定性和外部擾動）分別進行補償，保證了系統對外界干擾在給定的干擾衰減度下具有魯棒穩定性的同時，還增強了系統對參數不確定性的補償。
  2. The proposed fuzzy sliding mode controller does not require any knowledge of a nonlinear system and attempts to improve both transient and stability margins

    建議的模糊滑動模式控制器是針對非線性系統在未知參數變化與結構下的強健追蹤控制，其設計包含補償器、衰減技術、模糊邏輯近似法。
  3. The proposed control system includes the attitude controller acting on the rigid hub, designed by using pulse - width pulse - frequency ( pwpf ) modulation integrated with command shaping technique based on csvs method, and the piezoelectric material elements as sensors / actuators bonded on the surface of the beam appendages, designed by the optimal positive position feedback ( oppf ) control technique, in which the selection of ppf gains is determined via introducing a cost function to be minimized by feedback gains which are subject to the stability criterion at the

    設計的控制器僅利用輸出信息，從而避免設計撓性模態狀態觀測器以及引入狀態觀測器誤差;在此基礎上，採用分力合成方法設計命令成形控制器來抑制撓性附件的振動，設計的優化命令成形控制信號在理論上可以對系統的各階撓性模態完全抑制。但考慮到模型不確定性和外部擾動，在內迴路又設計了最優正位置反饋（ oppf ）補償器以增加撓性結構的阻尼，使撓性結構的振動能夠很快衰減。
  4. This paper has analyzed the characteristics of near - field electromagnetic fields and the measurement principle of magnetic - field sensor, and designed probe, amplifier unit and compensator according to measurement needs. finally, based on the electromagnetic pulse simulator in the lab, a set of experiments have been done on the designed magnetic fields measurement system and analyzed the error of the measurement system

    文中分析了近場電磁場分佈的特點；研究了磁場探頭的測量原理；根據實際測量需要製作了磁場探頭、設計了信號放大單元和用於補償電纜信號衰減的補償器；最後利用實驗室的電磁脈沖模擬器對所設計的磁場測量系統進行了一系列實驗，分析了系統的測量誤差。
分享友人
分享到 Line

分享到臉書