誤差校正器 的英文怎麼說

中文拼音 [wùchājiàozhēngqì]
誤差校正器 英文
error corrector
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 誤差 : error
  • 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
  1. Cavec chroma amplitude and velocity error corrector

    色度幅度和速度誤差校正器
  2. Fourthly, this paper standardizes the linear of the inductance sensor and analyzes its error. then we discuss the angle error of the laser sensor and the datum plane error of the mechanism. finally, the paper gives some advice to improve the mechanism

    第四，此外，本文還對電感傳感器進行了線性校正及誤差分析，討論了激光傳感器傾角誤差，並對機械設計中的定位結構進行了誤差分析，提出了改進的措施。
  3. Chapter 3 discusses the modules used in the fh - mpsk and fh - / 4dqpsk systems. these modules include : duc / ddc ( digital up converter / digital down converter ), nyquist flitter, burst start detection, interpolation module, pll ( phase locked loop ), pll error extraction, initial phase correction and the coding and decoding for tcm

    第三章主要討論了跳頻模式下fh - mpsk和fh - 4dqpsk系統中各個模塊的設計，這些模塊包括：上下變頻器、奈奎斯特濾波器、信號到達檢測、插值模塊、通用環路、各環路誤差提取方法、初始相位校正和tcm編譯碼。
  4. The error of hall element is analysed and the compensative method is provided ; this paper makes the theoretical analysis of errors producing by the instrument amplifier and a / d converter. we adopt the technology of digital filter and linearization implementing by the neural network method

    對霍爾元件的誤差進行分析並給出補償方法；對儀表放大器和a d轉換器引起的誤差進行了理論分析；採用了數字濾波技術和採用神經網路方法實現的非線性校正技術進行軟體補償。
  5. Our demagnetizer is compact and simply, easy to operate and mainly apply for adjusting the precision error of speedometer which works by magnet response. this product has good effect when you use

    公司製造的退磁器結構簡單輕巧，操作方便，用於校正磁感應車轉速里程錶的車素指示精度誤差，具有很好的使用效果。
  6. At present most methods employ digital computations and certain correction techniques that minimize instrumental errors.

    目前大多數方法是採用電子計算機，同時配合一定的校正技術，以減少儀器誤差。
  7. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念，對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差，並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  8. The errors of system and parts of units of the laser imagesetter have been tested, analysed and connected in dynamic balance and also the errors of the laser scanner, reason and source for their generation, and other factors have been analysed and studied

    在照排實驗中對整體、單元部件產生的誤差對照排質量的影響進行了分析、實驗，校正（動平衡）等，並對試驗過程中掃描器產生的誤差、來源、原因、及其綜合因素進行了分析和研究。
  9. Due to mission requirements, the pd depth control arithmetic is designed and the simulation result is provided. in order to reduce heading control bias, the compass data bias is corrected

    為提高航向控制精度，對航向控制系統中的磁通門傳感器的誤差進行分析，並提出了誤差校正的方法。
  10. Neural network has the ability of approaching nonlinear function at random precision, so that correct non - linear errors of angular rate sensor on the basis of neural network method

    神經網路具有理論上以任意精度逼近非線性函數的能力，故本文採用基於神經網路方法來校正角速度傳感器的非線性誤差。
  11. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  12. The error accumulation caused by the errors of modal vectors is banished and an emendation to the classical modal model is conducted, due to the extraction of the independent contribution of each mode by means of the orthogonality of the modal filter

    通過對離散模態濾波器的改進，避免了載荷重構階段模態向量誤差引起的載荷識別誤差積累，從而實現了對經典載荷識別模態模型的校正。
  13. 1 calibration the comparison of a measurement standard of instrument of known accuracy with another standard of instrument to detect, correlate, eliminate by adjustment, and report any variation in the accuracy of the item being compared

    調校把一部己知其準確度的儀器的量度標準與另一儀器的標準作比較，來檢查、連系、更正並消除及報告比較專案的誤差。
  14. Other imperfections are due to the practical limits to which correction can be made for systematic effects, such as offset of a measuring instrument, drift in its characteristics between calibrations, personal bias in reading an analogue scale or the uncertainty of the value of a reference standard

    其它非理想性因素是由於對系統效應的修正產生的實際限制，比如測量儀器的誤差，兩次校驗之間的性質偏移，個人讀取量數的偏差或者參考標準值的不確定性。
  15. One dimension river flow roughness parameter inverse analysis kalman filter is introduced into the model to solve stochastic error in observed data. applying kalman filter automatism revising system, dynamic roughness course is obtained. using dynamic roughness course the model result precision is improved, it is more consistent with observed data

    對於一維河道糙率參數反分析，針對觀測資料存在的隨機誤差，引進卡爾曼濾波器的自動校正系統，求解出河道糙率變化的動態過程，使用動態糙率計算，明顯改善模型的模擬精度，使模擬過程和觀測過程很好吻合。
  16. At the same time, this paper summarized the experience on solving the problem of amplitude limitation of the controller output and proposed a method to predict system output by use of the model prediction with feedback correction. the on - line intelligence switch of controller output between the limited amplitude and imc controller output is determined according to the state whether the system output and the predictive output are within the given error range

    同時，本文在總結前人對輸入受限問題的處理經驗的前提下，提出用帶反饋校正的模型預測作系統輸出預測，根據系統響應和系統預測值是否在給定誤差范圍內來共同決定控制量在限幅值與內模控制器輸出值之間進行在線智能切換。
  17. Latitude error corrector

    緯度誤差校正器
  18. The structure and character of deformable mirror were analyzed, and the conflict between the deformation band and the pitch of deformable cells was pointed out. the " two - time compensation " wave - front correct mode was introduced to settle that conflict. the method for allocating wave - front aberration and designing static corrector was found, and the " two - time compensation " wave - front correct mode was validated by simulation

    分析了變形鏡的結構特點，初步給出了變形鏡本身驅動單元數與校正量之間的制約關系；引入「二次補償」波前校正方案，解決了變形鏡校正量有限與高功率固體激光系統波前誤差起伏量大的矛盾，建立了波前校正對象優化分配、靜態校正器優化設計等細節過程所需要的方法，通過模擬模擬驗證了「二次補償」波前校正方案對于降低變形鏡校正量要求和放寬光學元件加工精度的作用； 5
  19. Furthermore, because the three grades decelerate control method, which is used widely, in stack crane control in china has some shortcoming, two rbf neuron network applied in position error study and dot position control is put forward. because neuron network is of self - study, emendation and modification can be achieved in control and can remedy the shortcoming caused by shortage of sample

    另外，本文還針對目前國內在對堆垛機控制方面普遍採用的三段式減速控制規律的弊病，提出用兩個rbf神經網路分別作為位置誤差學習器和點位位置控制器，由於神經網路的自學習功能，可以使得在控制當中不斷校正和修改在訓練時由於樣本不足造成的缺憾。
  20. In the thesis, the error analysis of the instruments and error correction curve is presented, so the measurement accuracy is relatively high

    論文中分析了儀器的誤差，並畫出了誤差校正曲線，以達到提高了測量精度的目的。
分享友人
分享到 Line

分享到臉書