調節電壓 的英文怎麼說

中文拼音 [diàojiédiàn]
調節電壓 英文
regulating voltage
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : 節構詞成分。
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 壓構詞成分。
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  • 電壓 : voltage; electric tension; electric voltage
  1. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調機轉速,減少了逆變器輸出流的諧波,降低了脈動轉矩,提高了的利用率。
  2. For a class of series - wound active power line conditioner the design approach law of a new fuzzy integral sliding mode variable structure control is presented. this method adjusts power electronic switch in order to achieve anticipated balance volt, finally makes active power line conditioner not only possess good robustness of variable - structure control and decrease vibration to the most but also increase the steady state precision. series - wound aplc adopted this control method possesses good dynamic and steady state performance

    針對串聯型有源調器運用變結構控制策略,調子開關模式,以獲得預期的平衡,對串聯型有源調器提出了模糊積分變結構控制方法,使串聯型有源調器既保持了常規滑模控制強魯棒性的優點,又減弱了滑模控制的抖振,提高了系統的穩態精度,使系統具有良好的動態和靜態性能,模擬試驗表明該控制策略是一種十分有效的控制方法。
  3. The mechanical platform of unregulated voltages, power and back - emf spikes, and the electronic platform of clean power and 5 - volt signals

    調節電壓力和反動勢峰的機械平臺以及干凈源和5伏信號的子平臺。
  4. The cooling system for engine adopted hydraulic drive and control technology to control the speed of the fan : the chip adjust the control - current of the proportional value, which used in the engine cooling system, to control the speed of the fan. and the size of the control - current is according to the coolant temperature, coolant temperature change rate and target temperature. as for as the hydraulic cooling system we used a motor to drive and control the fan ’ s work or stop according to the temperature of the hydraulic oil

    該系統的特點及其實現的功能為:液混合驅動方式改變了工程機械冷卻裝置驅動方式單一的缺點,發動機冷卻系統採用了液比例技術控制風扇轉速;單片機可以根據冷卻液溫度、冷卻液溫度變化率和目標冷卻液溫度調驅動系統中液比例閥的控制流,進而控制液油的流量,即可以實現冷卻風扇轉速的連續調;液油冷卻系統採用了動機驅動,然後由單片機根據液油的溫度控制動機的起動和停止。
  5. Using the traits of arc adjust itself of the co _ 2 welding, adopting slow - descending feature or even feature of electrical source equipping with system that delivering the welding rod at the invariable speed, then, the arc burning steadily is realized, and the quality of welding is improved

    利用co _ 2氣體保護焊弧的自身調特性,採用緩降或平硬特性的源配等速送絲系統,通過改變源空載調,再利用和熔化速度之間的關系調焊絲熔化速度使之等於送絲速度,最終實現弧的穩定燃燒。
  6. Part that needs frequency control adopts control technology of computer and universal electromotor and controls the transducer according to the formula that is voltage / frequency = const, which can adjust the speed of electromotor and accordingly control the working condition of ventilator

    變頻調速部分採用計算機和通用機控制技術的結合,按照與頻率之比等於常值的方式對變頻器進行控制,達到調機轉速的目的,從而控制通風機的工況。
  7. On account of the disadvantages of the feedback reactive power compensator, a device of its simplified scheme is studied in this paper, in which the reactive power is adjusted by regulating the voltage of the low - voltage side of the transformer

    由於這種反饋式補償方案存在一些問題,本文分析了它的簡化形式,即通過調器低側的母線調濾波器的無功出力的補償方案。
  8. Sb2015 - 3 precision decade dc resistance box adopts high voltage glass glaze resistors and special high voltage seal switch. its electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used to calibrate insulation resistance meter, and suitable to be used as high resistance standard

    3型精密十進位直流阻箱採用高玻璃釉阻器及獨特的高密封開關,性能穩定可靠、絕緣強度高、可在不斷開測試的條件下調阻值(正在使用的那隻開關不處在「 0 」位置時) 、操作方便,適用於檢定/校準絕緣阻表,也可作為高阻標準。
  9. Sb2015 - 2 precision decade dc resistance box adopts high resistance superfine glass silk and special high voltage seal switch. it electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used as dc resistance standard to calibrate insulation resistance meter

    2型精密十進位直流阻箱採用高阻玻璃微細絲阻器及獨特的高密封開關,性能穩定可靠、絕緣強度高、可在不斷開測試的條件下調阻值(正在使用的那隻開關不處在「 0 」位置時) 、操作方便,適用於檢定/校準絕緣阻表,也可作為直流阻標準。
  10. The test of this energy - saving technology is introduced, and the test data are analyzed

    調調能試驗做了詳細介紹,並對試驗數據進行了分析整理。
  11. To accept the current signal from high negative voltage circuit, the analog ground is raised to a certain positive voltage, which makes it possible for the signal amplitude to be compressed at the same time of its polarity reversion. a pi control program special for laser gyro current control is brought forward according to the conventional pid control method, in which the control signal is figured out corresponding to the difference between the sample and the reference value by turn of proportion - short step integral - long step integral. and at the end of this paper, a comparison of system performance on different conditions is made and the key elements influencing system performance are educed

    利用集成a / d 、 d / a轉換器的新型晶元aduc824 ,實現了流()采樣?數據處理?流控制的閉環控制結構;地位的抬升解決了a / d轉換器對負高迴路流采樣時的輸入范圍匹配問題;控制信號反相的同時進行幅度縮,使得輸出調的解析度提高;根據常規的比例?積分?微分( pid )調模型,針對陀螺系統的特性,給出了一種可以滿足系統要求、據采樣值偏差大小進行的比例?大步長積分?小步長積分、分層次比例?積分演算法;不同條件下系統穩流性能的對比、分析在論文最後給出,並據此找出了決定該系統穩流精度的關鍵因素,提出了系統的改進意見。
  12. The study of the effect of material properties and dimensions and loading currents on liner buckling, using a capacitor bank as a driver, indicates that the mode number for buckling increases with the ratio of radius to thickness of a liner, and the yield strength to plastic hardening modulus, but keeps invariable with the increase of loading current, and that the magnitude of buckling increases with the loading current

    容器組脈沖發生器裝置作為驅動源,設計4種不同材料、不同尺寸的金屬套簡,通過調容器組的充得到不同的加載流,研究材料及幾何參數、加載脈沖特性對套簡屈曲的影響;採用瞬態非線性有限元方法對實驗結果進行了數值模擬。
  13. In order to ensure the whole system operate economically, power department equip transformer with onload tap changer and shunt capacitors for most distribution substations, according to the operating condition, adjusting the position of transformer taps and capacitors can control the variation of voltage and reactive power exchanger of distribution substations and power system in certain extent

    為確保整個系統運行經濟性,降低網損,力部門在大多數變站配置了有載調器和並聯補償容器組,根據運行情況適當調器分接頭的位置和投切並聯補償容器組,可以降低變化和變站與系統的無功交換控制在一定的范圍內,確保供質量和網運行的經濟性。
  14. The operating principles of svpwm and associated control algorithms are also covered in the paper. by using svpwm to control the magnitude and phase angles of the spatial voltage vector, the speed control of the drive system in this paper can reduce the output of current harmonics, lower the torque ripple, and improve the energy efficiency

    本文還對svpwm的工作原理和控制演算法進行了研究,控制系統採用svpwm演算法,通過對空間矢量的幅值和相位的控制來調機轉速,減少了逆變器輸出流的諧波,降低了脈動轉矩,提高了的利用率。
  15. Make use of adjustable fan unit system, touching switchgear adjust voltage, keep the wind speed of working area always in perfect status

    採用可調風量風機系統,輕觸式開關調節電壓,保證工作區風速始終處理想狀態。
  16. Were there no transformers to adjust the voltage, long - distance transmission of electricity would be impossible

    若無變器來調節電壓,遠距離輸送力是不可能的。
  17. Unlike the traditional single mode of charge pump structure, the paper adopted 1x / 1. 5x fractional adaptive charge pump, which can automatically convert working mode with the change of input voltage, and utilized ultra - low - dropout current regulators to make 0. 15v led _ minimum regulation voltage in order to remain the charge pump working mostly in higher - efficiency 1x mode

    與傳統的單一轉換模式的荷泵結構不同,本文採用了1倍/ 1 . 5倍分數型自適應荷泵技術,可隨輸入的變化自行轉換工作模式;採用低調器使led陰極最小調節電壓僅為0 . 15v ,使荷泵更多地工作在效率更高的1倍模式。
  18. 13 flavius gruian. hard real - time scheduling for low - energy using stochastic data and dvs processors. in proc

    並且在實時嵌入式系統環境下,如果只有單個任務執行,操作系統不能通過任務調調節電壓
  19. In the approach, non - load machine switch is replaced by scr controlled by mpu to regulate the temperature. this control precision is greatly improved, and at the same time parameters can be automatically stored and displayed during the manufacturing process, it also included some other auxiliary controlling functions, such as over - temperature alarm, work piece input or output reminding, etc. the fuzzy pid control algorithm consists of fuzzy control and digital pid adjustment

    針對鹽浴變器只能進行無載分接、有級調的問題,本方案採取在變器原邊串接晶閘管的方法,將手動轉換的溫度控制,即無載分接開關機械觸點調節電壓改為單片機自動控制晶閘管的導通,將手動控制溫度改為模糊pid控制,從而提高了控制精度,降低了工人勞動強度。
  20. In addition, the performance criterion is respectively described, and the torque ripple at low - speed is analyzed in this paper. according to a method to adjust the duty ratio coefficient, we select a torque track with adaptation fuzzy controller to simulate. the experimental results show that the control strategy proposed can acquire better control effect

    針對直接轉矩控制系統在低速運行時依然存在的轉矩脈動大、運行性能差的問題進行研究分析,結合傳統的固定采樣周期控制方法,提出一種基於自適應模糊轉矩跟蹤法,調節電壓矢量占空因子,進行模擬研究,改善了系統的低速性能。
分享友人