負載脈沖 的英文怎麼說

中文拼音 [fùzǎimàichōng]
負載脈沖 英文
load pulse
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 負載 : [電學] load
  1. The characteristics of high pressure gyratory sprayed pumping discusses is presented, which is applicable in wide range of scope and ground layers, convenient for construction, long durability, wide source of materials. mechanism for subgrade strengthening : complex foundation of cement solid and earth between piles was formed by pulsant load of flowing pressure and spraying flow, water wallop, cavitation phenomenon, water wedge effect, extrusion force and air flow agitation etc so as to enhance foundation bearing force and reduce settlement and deformation

    高壓旋噴注漿技術具有適用范圍、適用地層較廣，施工方便，耐久性好，材料廣闊等特點；其加固地基機理主要是通過流動壓、噴射流的脈動負荷、水塊的沖擊力、空穴現象、水楔效應、擠壓力、氣流攪動等效應形成水泥固結體與樁間土的復合地基，從而提高地基承載力，減少沉降變形。
  2. Based on the study of transferring characteristics of the lcc - type resonant voltage, the parameter combinations, which make widths and magnitudes of voltage pulses of resonant network adjustable, arededucedo when the following requirements are met : fn > 3, k > 3 or cp / cs > 8, the above circuit is of natural voltage - stabilized characteristics, thus open - loop control method for bucking voltage is presented and the experimental results verify that the method is feasible.,

    實測整機在額定負載時效率達到88以上。在研究lcc諧振網路電壓傳輸特性的基礎上，推導出滿足可變寬度和幅度的諧振網路輸出電壓脈沖列的參數組合。設計f n 3 、 k 3或c _ p / c _ s 8時，諧振網路具有自然穩壓特性，因此本文提出並實驗驗證了一種整機為降電壓時的開環控制策略。
  3. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  4. It ' s high - frequence noise absorption, absorption of noise caused by rapid rise of front and self - reset function have widespread application in imput of supply, for absorption of inductive load switching surge voltage and for protection of two - way thyristor switching device, bypass capacitors, micro - machines and the others

    它所具有的吸收高頻噪聲、前沿快脈沖上升噪聲及自復位功能，使其在電源輸入端、吸收電感性負載開關浪涌電壓、保護雙向可控開關器件、旁路電容器、微型電機等方面有著廣泛的用途。
  5. The three - phase aviation static inverter with high frequency pulse dc link is made of three independent aviation static inverters and has the advantages such as strong function with unbalanced load and easy realization for module

    三相高頻脈沖直流環節航空靜止變流器由三個獨立的航空靜止變流器構成，具有帶不平衡負載能力強、易於實現模塊化等優點。
  6. Solar array simulator is programmed in labview to simulate the running condition of satellite ( such as sun angle, shadow time, orbit and so on ). electronic load is programmed in labview to simulate the running condition of satellite load. by data collecting and processing, satellite power engineers can monitor and evaluate working condition of satellite power system

    該測試評估系統應用labview軟體對太陽能電池陣列模擬器進行編程，模擬太陽能電池在空間各種狀態下（軌道、光照角、進出陰影等）的情況；對電子負載進行編程，模擬衛星負載的各種變化（平均負載、短期負載和脈沖負載）情況，信號採集和數據處理單元在測試評估系統運行過程中記錄電源系統各組成部分的工作參數，據此對衛星電源系統進行測試和評估。
  7. Design and realization of energy feedback type electronic power load

    用脈沖整流器實現的電子模擬功率負載
  8. Firstly, under the assumption that the output driving torque generated by the stepper motor of the mirror is constant, such influence analysis is conducted. secondly, a mathematic model of the stepper motor is given. under the assumtion that the input impulse frequence is constant, the rotational motion of the stepper motor of the mirror with the mutual exertions of damping torque, friction torque and disturbance torque generated by satellite platform ' s attitude motion is simulated and analyzed

    對衛星平臺姿態振動對紅外相機掃描機構轉動的影響進行了系統深入的模擬分析:首先在步進電機驅動力矩一定條件下，模擬分析了星體姿態運動干擾力矩對紅外相機掃描鏡轉動的影響;接著建立了步進電機的數學模型，在步進電機輸入脈沖頻率一定條件下，模擬分析了步進電機在阻尼力矩、干摩擦力矩、平臺干擾力矩等負載轉矩的共同作用下的轉動情況。
  9. However, it is difficult to make the product available because most of the academic institution focused on certain aspect only. the experts indicate that the ic designers should know more about the system though they don ’ t design the system directly. it points out a way for us ic designers when we are engaged in the research work

    本文提出的開關變換器，利用反饋原理將輸出電壓穩定在某一需要的值，根據負載的不同而採取兩種控制模式，即脈沖寬度調制（ pwm - pulsewidthmodulation ）模式和脈沖頻率調制（ pfm - pulsefrequencymodulation ）模式。
  10. Using an equivalent circuit model, the limit to the achievable rising time with spark technology was calculated, and a pulse conditioning system consisting of coaxial transmission line and sub - nanosecond switches was designed and built

    調制器由脈沖形成線、傳輸線、主開關、亞us開關（ pc開關）和匹配負載組成，其中的亞us氣體開關能穩定運行於45atm 。
  11. Further, the characteristics such as the response speed, the efficiency and the relationship between load and the modulation factor are counted and analyzed. during the stage of circuit design, the whole chip and the sub - block circuits are well - designed, respectively

    基於此模型，計算並分析了離散脈沖頻率調制下升壓型dc / dc變換器的響應速度、效率和負載與調制度的關系等特性。
  12. Finally, a compact uwb pulse source composed of pzt95 / 5 ferroelectric ceramic, a 50 coaxial transmission line charged by a pulse transformer, a peaking - chopping switch, a coaxial matched load and a pulse diagnostic system was built and tested, which can produce pulse voltage on a matched 50 load with peaking voltage of 100kv, rising time of 870ps, falling time of 670ps, and fwhm of 1. 410ns

    在上述工作的基礎上，我們研製了一臺以pzt95 5鐵電陶瓷沖擊去極化為能源的新型緊湊型脈沖發生器。該發生器由pzt9515爆電能源、空心脈沖變壓器、單同軸脈沖形成線、 pc開關、同軸匹配負載和脈沖診斷系統組成，能產生100kv 、上升前沿870ps 、后沿670ps 、脈寬1 4us的超寬帶脈沖。
  13. The inductive voltage of the thunder and lightning and the produced disturbance voltage when the inductive load turns on or is separated from the power network is main disturbance pulse voltage

    摘要雷電感應電壓和感性負載接入或脫離電源電路時所產生的干擾電壓是電源網主要的干擾脈沖電壓。
  14. In order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg ' s long pulse width, high - current and low voltage pulse to a short pulse with high voltage

    為用fcg驅動象hpm源這樣較高阻抗的負載，必須使用脈沖功率調制電路把fcg產生的低電壓、大電流、上升時間長的電壓脈沖轉化為高電壓、上升時間短的脈沖。
  15. But if we using the same size blumlein line as pfl, we can only get a square pulse with 31ns pulse duration. this experiment results show that replacing the intermediate conductor of blumlein line by helical conductor can get long pulse

    實驗表明採用螺旋blumlein型脈沖形成線我們得到負載上的方波脈沖的脈寬為260ns ，而同樣長的blumlein線在負載上只能得到31ns的方波。也就是說螺旋blumlein線在原理上是可得到長脈沖的。
  16. The load characteristics of clearing wastewater by electrocoagulation with the pulse power supply was also analyzed

    在直流負載特性的基礎上，進一步分析了脈沖電源作用下的負載特徵。
  17. Carbon nanotubes were separately synthesized by a new pulsed laser ablation ( pla ) for in - situ growth method and cvd support method in this paper. ft - ir, uv - vis, xfs, laman, tem, xrd, bet methods were used to characterize the sol, carbon nanotube and other products in the experiment. in the pla method, the sols containing carbon nanotubes were successively obtained by using 1064nm pulsed laser to ablate the interface of fe / c, or ni / c targets and ethanol under common temperature and pressure, and then carbon nanotubes were directly acquired by evaporating the ethanol

    脈沖激光轟擊原位生長法是在常溫常壓下使用1064nm波長的脈沖激光轟擊目標靶與乙醇流動相的固液界面來連續制備含有碳納米管的溶膠，進而除去乙醇相得到碳納米管，其中目標靶為石墨與fe 、 ni等金屬催化劑混合壓製成的靶片； cvd基體法是使用自製的六方介孔mcm - 41多孔材料為基體，負載fe催化劑活性組分，通過cvd法催化裂解c2h2來生長碳納米管。
  18. In order to insure pressurize, the edges and corners of the flume box should be agglomerated with right - angle aluminum material. in the part of the water heater circuit design and analysis, base on the induction cooker circuit, the main circuit, control circuit, protection circuit were mainly analyzed. and some circuits those do not relate close to the water heater circuit were ignored

    電磁渦流熱水器的電路設計分析部分，主要在電磁爐電路的基礎上，著重對主電路、控制電路、保護電路進行分析，分析了電路的工作原理和工作過程，而對于與電磁渦流熱水器關系不大的某些電路如試探脈沖產生電路和負載檢測電路等可以忽略。
  19. The maximum output current on a 60uh inductive load was 1660a, and the maximum peaking voltage on resistive and capacitive loads was over 100kv in our experiments

    我們還利用爆炸沖擊波加載技術對pzt95 5鐵電陶瓷進行了實驗研究，在60 h的電感負載上得到1660a的脈沖電流，在電阻和電容負載上獲得100kv 、 2
分享友人
分享到 Line

分享到臉書