超導測輻射計 的英文怎麼說

中文拼音 [chāodǎocèfúshèjì]
超導測輻射計 英文
superconducting bolometer
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 輻射 : radiation; exposure; radio; beaming
  1. First, it was taken that a discuss about the effects of geometry parameters of each piezocrystal on direction parameters ( main lobe width, side lobe amplitude, elimination of grating lobes ), amplitude of ultrasonic pressure, element viberation pattern, mutual radiation among elements, efficient test regions, ability to keep accurate and near - field distance and so on. based on the direction of ultrasonic field in ulpa deduced by ourselves. in addition, on the base of integrating all kinds of factors, it was put forward that the principle and method for optimized design of geometry parameters of piezocrystals in ulpa transducer, and its design programme and interface were compiled

    首先在推導超聲相控線陣換能器聲場的指向性的基礎上，就各個晶片幾何參數對指向性指標（主瓣寬度、旁瓣幅度、消除柵瓣） 、聲壓幅值、陣元振動模式、陣元間互輻射、有效檢測區域、精確控制能力、近場長度等方面的影響進行了論述，並在綜合各方面影響的基礎上，提出了晶片幾何參數優化設計的原則和方法，編寫了設計程序和界面。
  2. Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too

    本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
分享友人
分享到 Line

分享到臉書