車臺 的英文怎麼說

中文拼音 [jūtái]
車臺 英文
bed shaft
  • 車 : 車名詞1. （中國象棋棋子的一種） chariot, one of the pieces in chinese chess2. （國際象棋棋子的一種） castle; rook
  • 臺 : 臺名詞（指臺州） short for taizhou （in zhejiang province）
  1. Jet engine test cell work experience is preferred

    具有發動機試車臺經驗者優先考慮
  2. For recreation, cactus resort sanya boasts the largest outdoor swimming pool in china, two tennis courts, beach volleyball, mountain bikes, pedalos, billiards, a massage area and a wide range of other indoor and outdoor

    仙人掌擁有中國最大的室外游泳池，同時提供網球場山地車臺球按摩服務及其他娛樂專案。
  3. Standard specification for bronze castings for bridges and turntables

    橋梁和轉車臺用青銅鑄件的標準規范
  4. On the part of the design of nine - component thrust vector stand, an automatic hydraulic pressure original position calibration system, a scheme of original position calibration, and the great rigidity universal flexible combinatorial underprop are designed. by using the scheme of “ universal flexible combinatorial underprop plus software digital filter ”, the inherent frequency of test stand is improved, and the problem of test stand libration is solved. then, the resolving method of the disturbance between underprops of the moveable frame is proposed, and the disturbance revise equation is deduced

    在推力矢量試車臺設計方面，設計了自動液壓原位校準系統、原位校準方案以及大剛度萬向柔性組合支撐;採用「萬向柔性組合支撐+軟體數字濾波」的方案，提高了試車臺動架的固有頻率，解決了試車臺動架的振動問題;提出了動架約束互擾問題的解決方法，推導了互擾修正方程;研究了九分力推力矢量測量誤差分析方法，並計算了推力矢量測量精度。
  5. Have administrative staff no. 15 now, have people 300 more than staff, existing advanced electric motor car platforms wait for 200 of equipment already at first - phase, the plan expands the scale to 600 within the year, estimate when the time comes that the annual output will reach 100 million yuan

    現有管理人員15人，首期已有員工300多人，現有先進的電動車臺等設備200臺，計劃年內將規模擴大至600臺，屆時預計年產值將達到人民幣1億元。
  6. Products with a reclined carriage position ( s ) must have a nondetachable feature to enable them to conform to the requirement in clause 6. 5 unless the product only can be adjusted to any reclined carriage position when a detachable device is attached

    產品（嬰兒車）如可調節至平躺位置，則其各部件必須是不可分離以滿足條款6 . 5的要求，或除非只有當一個可分離裝置裝上時車臺才可以調節至平躺位置。
  7. What ’ s more, the precision of thrust vector measurement is also calculated, depending upon the error analysis of nine - component model. a large - scale srm hot test is successfully done on the nine - component thrust vector stand. and the satisfactory results validate that the nine - component model is reasonable and the nine - component thrust vector stand design is feasible

    在九分力推力矢量試車臺上成功地進行了一次大型固體火箭發動機地面熱試車，得到了滿意的試驗結果，驗證了九分力模型的合理性和九分力推力矢量試車臺設計的可行性。
  8. Stand test methods of diesel locomotives - locomotives no - load performance test

    內燃機車臺架試驗方法機車空載性能試驗
  9. Lab of engine test bench

    發動車臺架測試系統
  10. Analogue convention mobile

    模擬常規車臺
  11. Digital trunking radio

    數字集群車臺
  12. To install a drop box at the back of the table for storing the finished part

    車臺後方開一槽位，裝上收集盒放置完成的后袋貼。
  13. Front pieces put on left side shelf and the cuffs put on right side table. after complete the sewing work, put the finished part on the right side shelf

    衫身放在左邊架上，而袖級則放在右邊車臺上，車縫后，成品放于車縫工右邊架上。
  14. Stand test methods of diesel locomotives - test of the traction and thermodynamic performance

    內燃機車臺架試驗方法牽引熱工性能試驗
  15. Stand test methods of diesel locomotives - test of oil water cooling equipment performance and heat balance

    內燃機車臺架試驗方法油水冷卻裝置性能及熱平衡試驗
  16. In addition, large - scale turn - tables are installed in certain rcps to facilitate the in and out movements of refuse collection vehicles

    此外，部分垃圾收集站亦設有大型轉車臺以方便垃圾車進出。
  17. The study shows that the nine - component model and nine - component thrust vector stand can improve the precision of thrust vector measurement greatly

    研究表明，九分力模型和九分力推力矢量試車臺提高了推力矢量測量的精度，適合用於測量大型固體火箭發動機的推力矢量。
  18. On the part of thrust vector measurement theory, some problems that exist in the six - component model and the six - component thrust vector stand are analyzed, and the solving methods of six - component model are studied. the thrust vector measurement nine - component model is established, and the design idea of curve rail can benefit the nine - component model solving is proposed

    在推力矢量測量理論方面，分析了六分力模型及六分力試車臺存在的問題，研究了六分力模型的方程求解方法;建立了推力矢量測量九分力模型，提出了弧形軌的設計思想，解決了九分力模型方程求解問題。
  19. Spinning test stand is difficult to simulate the flow field of srm under high acceleration condition because of its coriolis acceleration

    理論分析證明旋轉試車臺不能克服科氏加速度的影響，難以用來開展高過載條件下發動機流場的地面模擬試驗。
  20. Numerical study on supersonic ejector of simulated altitude test stand

    高空模擬試車臺超聲速引射器數值研究
分享友人
分享到 Line

分享到臉書