透光式液面計 的英文怎麼說
中文拼音 [tòuguāngshìyèmiànjì]
透光式液面計
英文
tra arent level gage- 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
- 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
- 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
- 液 : 名詞（液體） liquid; fluid; juice
- 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
- 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
- 透光 : photopermeability; pervious to light; translucidus; transmitting
-
According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d
本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。( 3 ). put forward two structure scheme of opto - electronic deflection measurement sensor, light transmitting with non - mechanical scanning and light reflecting with non - mechanical scanning after compared exisiting methods of liquid level measurement to satify this needafter the comparison, an opto - electronic deflection measurement sensor based on light reflecting with non - mechanical scanning be confirmed. then the concrete design is to carry out, which includes the design of reflective surface, the design of pds ( photo detective subassembly ) ' s bracket, the design of floater and the design of shaking - absorbed accessory. during the process, there are a series of caculations and emulations. at last, the opto - electronic deflection measurement sensor has been designed and produced
比較了現有液位測量方法后提出了能夠滿足大佛寺長江大橋撓度測量要求的基於連通管的光電撓度計的非機械掃描光透射式和非機械掃描光反射式的兩種方案，通過比較確定了非機械掃描光反射式方案。隨后通過對該方案進行具體的零件設計，主要包括反射面的設計， pds （光電接收組件）支架的設計，浮子的設計以及減震零件的設計等等，在設計的過程中包含了一些理論計算和模擬，最終設計和製作了光電撓度計。
分享友人