重質焦油 的英文怎麼說

中文拼音 [zhòngzhíjiāoyóu]
重質焦油 英文
heavy tar
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 焦 : Ⅰ形容詞1 （物體受熱失去水分 呈現黃黑色並發硬、發脆） burnt; scorched; charred 2 （著急） worried;...
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 重質 : heavy hydrocarbon oil
  • 焦油 : tar; pez; goudron; coke tar
  1. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  2. Extensive experiment on tar cracking was performed on bench - scale tar catalytic cracking test system in itpe. cold trapping was used for tar sampling and gravimetric analysis of tar samples was performed to achieve tar content in flue gas

    在分析該領域研究現狀的基礎上，建立了實驗室規模生物質氣化焦油催化裂解實驗系統，採用冷態捕集方法進行焦油取樣，採用重度分析方法對焦油樣品進行分析以確定煤氣中焦油含量。
  3. The results reveal that the five - lump model can work with only the compositional information of the raw tar as the input parameters, and it can be used to predict the results of different cracking conditions and the final composition of residual tar. the simulation of the cracking process was satisfying

    結果表明，五集總模型的應用可獨立於焦油的來源和性質，對焦油轉化過程動力學行為描述的準確度明顯高於整體轉化模型，且該模型不僅對裂化過程進行動力學模擬和結果預測，還可給出轉化后焦油的構成等重要信息。
分享友人
分享到 Line

分享到臉書