限流恆壓充電 的英文怎麼說

中文拼音 [xiànliúhéngchōngdiàn]
限流恆壓充電 英文
current content voltage charge
  • : Ⅰ名詞(指定的范圍; 限度) limit; bounds Ⅱ動詞(指定范圍, 不許超過) set a limit; limit; restrict
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ形容詞1 (永久; 持久) permanent; lasting 2 (平常; 經常) usual; common; constant Ⅱ名詞1 (恆心...
  • : 壓構詞成分。
  • : Ⅰ形容詞(滿; 充足) sufficient; full; ample Ⅱ動詞1 (裝滿; 塞住) fill; charge; stuff 2 (擔任; ...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  1. Constrained to technologies, the lead - acid battery mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current, etc. the charging current of these methods cannot match efficiently the acceptance curve of the lead - acid battery proposed by j. a. mas. as a result, some of these methods have a low time efficiency and incompleteness charging. and some of them lead to overcharge and gas - generation, which will result in low - efficiency, time - consuming and prone - to - damage of the charging operation

    鉛酸蓄池由於受到技術條件的制,其主要採用等常規模式,這些方法的未能有效的遵從馬斯所提出的可接受曲線,因而有的方法時間效率低、不完全;有的則存在著過和析氣等現象,並導致過程的低效,耗時和易損。
  2. The charging of lead - acid battery, the most widely accepted secondary battery, constrained to technological limitation, mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current and etc. those methods may not follow the internal physical and chemical laws within the battery, leading to serious overcharge and gas - generation, and resulting in low - efficiency, time - consumming and prone - to - damage of the charging operation

    二次池中被最廣泛接受的鉛酸蓄池由於技術條件的制,其主要採用等常規模式,這些方法未能遵從池內部的物理化學規律,大多存在著嚴重的過和析氣等現象,並導致過程的低效,耗時和易損。
  3. The hspice simulation results indicate that the charging current is up to 2a and the precision of termination voltage is very high with the error only around 10 - 3. the efficiency is approximate 68 % when the ic is powered by fix voltage source and up to 95 % when the ic is powered by current limited source

    Hspice模擬結果表明,該晶元模式下最大為2a ;對終止的控制精度高達10 - 3 ;當採用作為源時,效率為68 %左右;當採用具有制功能的源時,效率可達到95 % 。
  4. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想,通過對蓄池化成過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測,實現對蓄池靜等多種工作方式的控制。
  5. By analyzing the charging & discharging characteristics of accumulators, and by improving the hardware and control algorithm of the former chargers, this dissertation designes a high - power charger. the charger can not only charge accumulators with constant voltage and limited current, but also charge them intelligently. meanwhile, it is characteristic of over - voltage, over - current and overheat protection, self - recovery and automatic current - averaged in parallel

    本論文通過對蓄池的、放特性的分析以及對以往機硬體和控制演算法兩個方面的改善,設計了一種不僅能對蓄池進行,還可以進行智能,同時具有過、過、過熱保護、自恢復功能和並聯自動均的大功率機。
  6. In this paper, a charger of storage battery with power factor correction ( pfc ) is devised. additionally, the summarization, implement methods and the charge mode are mainly introduced

    本文設計帶功率因數校正的蓄路,主要介紹了功率因數校正的概況、實現方式及方式。
  7. In actual applications, the efficiency is same as the conventional linear charger when the ic is powered by constant voltage source and is similar to pulse or switch charger when current limited source is used for power supply

    實際應用中,當採用作為源時,其效率與傳統的線性器相同;當採用具有制功能的源時,效率接近脈沖器和開關器。
分享友人