電位差計 的英文怎麼說

中文拼音 [diànwèichājì]
電位差計 英文
potential difference meter
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. As a result, the electromagnetic field intensity is changed accordingly and fluctuating current in the damper coil is created. damping force is mostly produced because of the phase difference between fluctuating current and displacement of rotor. the formulas of fluctuating current and damping coefficient are deduced theoretically, and the calculated results are consistent with the experimental results

    通過分析發現電磁阻尼器線圈內由於轉子渦動時變化的磁場而產生的波動電流與轉子位移間的相位差是產生阻尼的主要原因，推導了波動電流、阻尼系數的計算公式，並通過實驗展示了被動式電磁阻尼器的阻尼效應。
  2. Design and research of the digital display electric potential difference meter

    數字電位差計的設計與研製
  3. Residual electromotive force of potentiometer

    電位差計殘余電動勢
  4. Sampling and analysis of iron, steel and other ferrous metals - methods of analysis - determination of chromium - ferrochromium and ferrosilicochromium : potentiometric method

    鐵鋼和其他黑色金屬抽樣與分析.第3部分:分析方法.第10節:鉻含量測定.第4小節:鐵鉻合金和鐵硅鉻合金:電位差計法
  5. The structure of the testing platform is described, and the experiment content and principles are given in detail. the transmission error curves and space frequency curves are emulated. the circuits of rotor part and software are finished

    本文介紹了實驗臺的整體結構，實驗內容的設置和各實驗的工作原理，模擬了傳動誤差曲線及其空域頻譜圖，詳細闡述了轉子測量的電路設計、下位機程序設計和上位機的軟體設計。
  6. The three - order modulator has a 2 - 1 cascaded structure and 1 - bit quantizer at the end of each stage, the modulator is implemented with fully differential switched - capacitor circuits. and then, the discussion will begin by exploring the design of various circuit blocks in the modulator in more detail, i. e., ota, switched - capacitor integrator, quantizer, two - phase non - overlapping clock signal, etc., at the same time, these circuits will be simulated in spectre and hspice. at last, the whole cascaded modulator will do behavioral level simulation by matlab soft and simulink toolbox

    本論文中，首先介紹模數轉換器的各種參數的意義，以及一階sigma - delta調制器和高階sigma - delta調制器的原理;給出解決高階單環sigma - delta調制器不穩定性的方案，引入級聯結構調制器，特別針對級聯結構調制器中的失配和開關電容積分器的非理想特性進行詳細的討論;本設計的sigma - delta調制器採用2 - 1級聯結構和一位量化器，調制器採用全差分開關電容電路實現;同時對整個調制器的各個模塊進行了電路設計，包括跨導放大器、開關電容積分器、量化器、兩相非交疊時鐘等，並利用hspice和spectre模擬工具對這些電路進行模擬測試;最後，利用matlab軟體和simulink工具對整個級聯調制器進行行為級模擬。
  7. A scheme to be formulated and submitted for approval to the harbour commissioners for the exploitation of white coal hydraulic power, obtained by hydroelectric plant at peak of tide at dublin bar or at head of water at poulaphouca or powerscourt or catchment basins of main streams for the economic production of 500, 000 w. h. p. of electricity

    有個建造水力發電廠的計劃：利用都柏林沙洲的滿潮噗啦呋咔272或鮑爾斯考特瀑布273的水位差主要河流的流域來開發白煤水力發電，經濟生產五十萬水馬力的電力。擬好后，將提交港灣委員會，以便獲得批準。
  8. Rectangular coordinate type potentiometer

    直角坐標式電位差計
  9. Polar coordinate type potentiometer

    極坐標式電位差計
  10. Under calculating background, we research the uniformity half space and multi - layers models, discuss the effect on studied background results to abnormity and overlapping field

    為了提高計算精度和計算速度以及避免由源奇異性引起的差分計算復雜性，計算時將電位分成二次異常電位和背景電位2部分。
  11. It creates the model of layer soil by using the cdegs software, analyses the resistance error which is measured by traditional three - poles way, measures the grounding grids resistance and soil resistance rate of hejin power plant, creates the electromagnetic model of layer soil and grounding grids model of hejin power plant, calculates the step voltage > touch voltage n voltage distribution of earth surface in fault of hejin power plant. in the end, it compares the measuring value and calculating value of grounding grids resistance in hejin power plant

    本文利用cdegs軟體建立分層土壤接地模型，對傳統三極法測量接地電阻誤差進行分析；對河津電廠接地網接地電阻和土壤電阻率進行測量；建立河津電廠分層土壤電磁模型和接地網模型；計算河津電廠接地網電阻和事故狀態下跨步電壓、接觸電壓和地表電位分佈；最後對河津電廠接地網電阻實測值與計算值進行比較分析。
  12. Data reduction was carried out in real time by a minicomputer. the microcora was replaced by a more advanced version, digicora, in 1993

    地面站即時用一部小型電腦從轉播信號的相位差計算出無線電探空儀的位置，從而計算出高空風向和風速。
  13. Auxiliary equipment of potentiometer

    電位差計的輔助設備
  14. Test on potentiometer with a degree of sub - division not exceeding 1 in 200, 000

    測試細分度不超過1200 ， 000的電位差計。
  15. Balance type potentiometer

    補償式電位差計
  16. High e. m. f. potentiometer

    高電熱電位差計
  17. If the potentiometer under test has its own internal voltage reference and power supply, these will be used, unless they are found to be unstable. generally, the calibration procedure recommended in the manufacturer s service manual will be followed

    若接受測試的電位差計附有內部電壓標準及電力供應設備，在測量過程中，除非此等電壓標準及電力供應被發現並不穩定，否則將盡量被使用。
  18. The synchronous rectifying and low power sampling technology is used to reduce the power consumption, flexible external loop compensation, error amplifier output clamp are adopted for better system large signal response. the piecewise slope compensation technology is employed to minimize the consequence of over compensation. the sensor resistor is externally connected, which realize output voltage programmable. the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system

    同時，電路設計採用同步整流技術、低功耗電流采樣技術降低功耗，提高轉換效率;採用靈活的外部環路補償技術、誤差放大器輸出嵌位技術以實現良好大信號特性;採用分段斜坡補償技術，消除不穩定因素，並最大程度地減小過補償帶來的問題;採用外接輸出采樣電阻的方式，實現輸出電壓的可編程。
  19. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的相位關系，即干涉相位差，方位角或仰角是直接由干涉相位差計算得到，或將兩基線正交的天線陣的干涉相位差轉化為驅動電壓（電流）分別加到crt陰極顯示器的垂直偏轉線圈和水平偏轉線圈，模擬顯示出來波方位，干涉儀測向為典型的相位測向方法。
  20. In this paper, based on the previous research result, by using theory of electrochemical mechanism, probability math, reliability theory, basic theory of pre - stressed concrete structures, structure optimum design, theory of control, maintenance strategy decision theory of structures and etc., the research on steel corrosion monitoring method, structural corrosion damage model, reliability analysis, the maintenance and repair method that based on corrosion control, the optimum structural design method of new bridge structures that consider durability and the optimum maintenance strategy decision theory are carried out. 2. corrosion mechanism and monitoring technique it is widely accepted that the corrosion of steel in concrete structure is a electrochemical process, include the formation of anode & cathode area on metal surface and potential difference between different ' area

    本文在已有理論研究的基礎上，針對預應力混凝土橋梁建設及使用中存在的影響結構耐久性的實際問題，綜合運用電化學理論、概率理論、結構可靠性理論、混凝土和預應力混凝土結構基本理論、結構優化理論及控制維修決策等理論和方法，詳細研究了基於電化學理論的鋼筋銹蝕檢測方法、預應力混凝土橋梁結構的腐蝕損傷模型、可靠性分析、基於腐蝕控制的維修方法、橋梁結構方案選型及優化設計以及在役橋梁結構的優化維修決策等問題第二章混凝土結構的腐蝕機理及檢測技術目前普遍認為，結構混凝土中鋼筋的腐蝕是一種電化學的過程，包括在金屬表面形成陽極（腐蝕）和陰極（鈍化）區域以及不同區域間的電位差等。
分享友人
分享到 Line

分享到臉書