靜態感應器 的英文怎麼說

中文拼音 [jìngtàigǎnyīngqì]
靜態感應器 英文
stationary induction apparatus
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  1. The principle and the mechanical structure of the air - gap inductance - type transducer are analyzed in this article, and the static parameters are calibrated. dynamic calibration is applied to air - gap inductance - type transducer which is not good in dynamic capability, to obtain the dynamic parameters of the transducer and its measuring circuit. based on the result of the dynamic calibration, the transducer and its serving circuit are modeled so that the method of how to improve the dynamic performance can be found

    本文對現有氣隙式電感傳感器在原理和機械結構上作了深入的分析，對其參數進行了靜態標定；並且針對常規電感傳感器動態響應低，不宜用於快速動態測量的缺點，引入測試系統動力學的思想，設計了一套動態校準系統，對現有傳感器進行多次動態校準，根據動態校準的實驗結果對現有傳感器建立數學模型，得到現有傳感器的動態特性；在此基礎上，根據磨床工件在線檢測的要求，設計一個硬體補償系統來提高整個測試系統的動態特性。
  2. By virtue of their high self - resonance, good transient response and very small measuring distance, the tension compression force transducers are equally suitable for both static and dynamic applications

    依靠它們很高的自振性良好的瞬時響應和很小的測量距離，無論靜態或是動態場合，拉壓力傳感器都同樣適用。
  3. By the way, a displaying system and a communicating system is added. this dissertation is divided into four chapters altogether : chapter one is the introduction, introducing the hore component and its important characteristic and putting forward the basic task ; chapter two introduce the principle of the auto - tracking system and respective parts of the auto - tracking system ; chapter three introduce the applications of auto - tracking system under static condition and dynamic condition and give out the experiment results ; chapter four introduced the displaying system, communicating system and the applicability of the auto - tracking system to other sensors

    本文共分為五章：第一章緒論中，介紹了霍爾元件及其一些重要特性，並提出了測量系統的基本方案；第二章詳細介紹了測量系統各部分的構成及原理，特別是對直流通道、溫度補償模塊和音圈電機為核心的隨動機構的論述；第三章介紹了實際系統在靜態測量和動態測量兩種模式下的應用及實驗結果；第四章介紹了系統的顯示功能和遠程通信功能並討論了系統對其它傳感器的適用性。
  4. Automatic water - measuring meter is the combinative production of traditional method and present cmos integration circuit technology. it consists of water - level sensor and mainframe circuit. on the basis of analyzing its application, this paper gives the design of mainframe circuit, including time circuit, time - sequence circuit, input - interface circuit, switch circuit and power circuit

    本文在分析cmos集成電路應用的基礎上，給出了自動量水儀表主機電路的設計，包括定時電路、時序電路、輸入介面電路、開關電路和電源電路的設計；其次，對水位傳感器進行了研究，分析了水位傳感器的工作原理、測量使用條件、動態特性、靜態特性以及水位傳感器的率定、標定方法。
  5. It is found ecn could n ' t solve the problem that the sender responds to congestion slowly, and the average queue length of router is sensitive to the static parameters of ecn. in chapter four we propose an algorithm called fecn, which provides congestion control and indication messages in router, so that the sender could response to congestion in good time. this algorithm can also adjust the max drop probability according to the active conne

    Ik的特性，而且平均隊列長度和網路吞吐量對ecn的靜態參數較為敏感，因此本文在第4章中提出了一種fecn演算法，該演算法在路山器處提供擁塞控制和指示機制，使源端能夠快速響應路由器發回的擁塞指示消息，調整發送速率，避兔擁塞的發生，該演算法還可以通過估計鏈路中的活動連接數動態調整最大丟棄概率。
  6. For the image acquisition of optical scan mode, normally, ccd image sensor is used to capture image, but in our system, due to the system request of micromation and high integration, cmos image sensor is adopted as the image collection device, and then the thesis gives a interface circuit between the chip and dsp and a control solution of image collection ; toward the information storage in our solution, dsp is directly linked to usb host chip and it is the dsp that accomplishes the processing of usb protocol and interface control so as to reduce the cost, minimize product cubage and consequently meet the requirement of system micromation ; at the same time, the thesis probes preliminarily into usb otg ( on - the - go ) technology, which offers an approach between embedded machines including pda, mobile phone, printer, digital camera and so on ; in addition, some attempts on the other application area with tms320vc5402 which was commonly used to voice processing and static image processing are done, for example, to arrange the chip to control lcd module directly

    在圖像的光電掃描輸入上，傳統方案大部分採用ccd型圖像傳感器，而在本方案中，根據系統微型化、高集成的特點，使用了cmos圖像傳感器作為攝像器件，並且設計了該晶元與dsp的一種介面電路以及圖像採集控制方案；在信息存儲上，本方案採用dsp直接與usbhost晶元連接，由dsp處理usb協議和介面信息，從而降低了系統成本、縮小了產品體積，滿足了系統微型化的要求；同時本論文也對usb - otg技術進行了初步探討，利用此項技術，不再需要計算機作為主機，就能實現在pda 、移動電話、印表機、數碼相機等嵌入式應用之間直接互聯通信；另外也對廣泛用於語音處理和靜態圖像處理的tms320vc5402其它方面的應用進行了嘗試，比如直接控制液晶顯示器等。
  7. As to doubly fed adjustment system, it will own excellent dynamic and static behavior if vector control is used. but if the system includes speed and position sensor, it will cause the increment of cost, descend of reliability, complication of structure and limitation of application area

    雙饋調速系統，如果採用矢量控制，將具有良好的動、靜態性能，但若系統中設有位置傳感器和速度傳感器，則會使系統的成本增加、可靠性降低、結構復雜、從而使應用場合受到很大的限制。
  8. In experimental, static response and frequency response of coupling acoustic / vibration optic fiber sensor have been analyzed. the results indicate that the response of the sensor to static pressure has high sensitivity. because the resonant frequency of different materials and structure is different, the sensor has maximum sensitivity in specific frequency

    試驗研究中，對耦合型聲振動光纖傳感器的靜態響應特性和頻率響應特性進行了試驗分析，分析結果表明該類型傳感器對應變的響應非常靈敏，而對頻率的響應則由於材料及結構本身的共振頻率的差異有不同的峰值響應頻率。
  9. The performance, feature and application fields of non - contact displacement sensors used in bearingless motors are compared. the static and dynamic characteristics of the eddy current displacement sensor are studied experimentally

    對比分析了目前在無軸承電機上使用的非接觸式位移傳感器的性能、特點和應用范圍，重點對所選用的電渦流傳感器進行了靜態和動態特性的試驗研究。
  10. This paper studied mainly mechanism about pneumatic sensor of small measurement range linear dimension measurement in pneumatic measure system concluding static stage and dynamic state characteristics study

    主要進行用於小量程線性尺寸測量的氣動測量系統中氣動傳感器的機理研究，氣動傳感器靜態特性研究和動態響應特性研究。
  11. The prototype of the 6 - dof force / torque sensor on the steward platform is modeled by pro / e. and the static performance and dynamic performance of the sensor have been studied by using the fem software - ansys. the inherent frequency is also acquired

    應用大型工程制圖軟體pro / e建立了整體預緊式六維力傳感器的空間結構模型，並應用大型有限元分析軟體ansys對該六維力傳感器的靜力和動態特性進行了分析，得到了六維力傳感器的固有頻率。
  12. This paper presents the technological design and the process of manufacture of yb film stress sensor, which are verified to be feasible by material testing and sensor calibrating in dynamic and static states

    介紹了鐿薄膜應力傳感器的工藝設計和製造過程，通過傳感器的靜態、動態標定及材料測試，驗證了新的工藝設計和製造過程是正確可行的。
  13. Abstract : this paper presents the technological design and the process of manufacture of yb film stress sensor, which are verified to be feasible by material testing and sensor calibrating in dynamic and static states

    文摘:介紹了鐿薄膜應力傳感器的工藝設計和製造過程，通過傳感器的靜態、動態標定及材料測試，驗證了新的工藝設計和製造過程是正確可行的。
  14. In the end, the methods of the static calibration and the rule of transforming forces to movement velocities are studied. the thesis helps to develop virtual body control system test the sensor ' s control functions. the 6 - axis f / t sensor is also proved to be successful in the micromanipulator robot system

    本文的最後部分研究了多維力傳感器的靜態標定方法，建立了從六維信號到被控對象的運動控制之間的對應關系，開發了檢驗六維力傳感器控制功能的虛擬樣機控制系統，並將六維力傳感器用於微操作機器人控制系統中。
  15. Have build - in vibration sensor. when the car is driven at night, four lights will shine alternately ; and when the car stops, they will go to a stand - by situation automatically

    內置振動感應器，夜晚車行駛時4個燈交替閃爍；車靜止時，它會進入自動待機狀態
分享友人
分享到 Line

分享到臉書