顯微測譜術 的英文怎麼說

中文拼音 [xiǎnwéicèpǔshù]
顯微測譜術 英文
microspectrometry
  • 顯 : Ⅰ形容詞1 （明顯） apparent; obvious; noticeable; evident 2 （有名聲有權勢的） illustrious and inf...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 譜 : Ⅰ名詞[書面語]1 （按類別或系統編成的書或冊子等） table; chart; register 2 （指導練習的格式或圖形）...
  • 術 : 術名詞1. （技藝; 技術; 學術） art; skill; technique 2. （方法; 策略） method; tactics 3. （姓氏） a surname
  • 顯微 : microadiography
  1. Secondly, introducing the image analyzing technology with reference to the disadvantages of the traditional ferr - graph analysis technology, and with the combination of characteristic parameter optimizing filtration so as to raise a description method of debris micro - morphologic character. thirdly, with the application of mode recognition method, completing the process of debris auto - recognition based on the collected information of the debris configuration characteristics ; and conducting the diagnosis on the aero - engine wear faults according to the theory of particle tribology. fourthly, introducing information fusion technology to solve the problem that a single method can not collect enough fault premonitory information to conduct the wear fault diagnosis, hence to conduct the research and exploration in the field of comprehensive diagnosis on the aero - engine ' s multi - fault premonitory information

    本文的研究工作主要包括以下五個部分：首先，介紹航空發動機常見的磨損故障類型，研究磨損故障的失效機理，分析磨粒的產生機理、分類以及形態特徵：其次，針對傳統鐵譜分析技術的缺點，引入圖像分析技術，再結合特徵參數優化篩選，形成基於圖像的磨粒顯微形態學特徵描述方法：然後，基於提取到的磨粒形態特徵信息，應用模式識別方法完成磨粒自動識別，並根據顆粒摩擦學的基本原理進行航空發動機磨損故障的診斷與定位：再后，鑒于單一方法不能提取足夠的故障徵兆信息進行磨損故障診斷，本文引入信息融合技術，開展航空發動機多故障徵兆信息綜合診斷方法的研究與探索；最後，基於航空發動機滑油光譜分析與鐵譜分析數據，應用時序模型、灰色模型以及組合模型進行磨損故障的預測方法研究。
  2. Zno thin films were deposited on silicon ( si ) and glass substrate by reactive radio frequency sputtering ( rf ) technique with zinc target in the mixed gas of ar ando2, and used zno buffer improving the quality of zno thin film. the effects of parameters on the thickness, composition, texture, morphology, optical properties and electrical properties of zno thin films had been systematically investigated by means of xrd, xps, sem, afm, pl and hall test system

    採用x射線衍射（ xrd ） 、 x射線光電子能譜（ xps ） 、掃描電子顯微鏡（ sem ） 、原子力顯微鏡（ afm ） ，光致發光譜（ pl ）和霍爾效應測試技術系統研究了濺射工藝和退火工藝對zno薄膜的厚度、成分、織構、表面形貌、光學性能和電學性能的影響規律。
  3. Fourth, the advanced surface analysis technique - x ray photoelectron spectrum is employed to study the adsorption of soluble - starch on the pvdf membrane. then we test by using xps combined with sem the original sample, the fouled sample and the washed sample with rubber sponge balls

    第四，採用x射線光電子能譜（ xps ）技術分析了可溶性澱粉在聚偏氟乙烯膜表面的吸附，並將xps技術與電子顯微鏡技術相結合，對原始樣品、污染樣品和海綿橡膠球清洗樣品進行了測試和分析。
  4. The phase structure of different cu - fe thin films were studied by using grazing incidence x - ray analysis ( gixa ). the texture and residual stress of different cu - fe thin films were measured by scan of x - ray diffraction ( xrd ) and 2 scan with different. the thicknesses of different thin films were characterized by means of small angle x - ray scattering ( saxs ) technique. by using atomic force microscope ( afm ) measured surface roughness of thin films. the component of different thin film was characterized by energy disperse spectrum ( eds ) and x - ray fluorescence ( xrf ). the magnetic properties of cu - fe thin films were measured by means of vibrating sample magnetometer ( vsm ). in addition, the giant magnetoresistance ( gmr ) effects of different films were also measured. the original resistance of the film fabricated by a direction - current magnetron sputtering system is directly affected by bias voltage

    利用掠入射x射線分析（ gixa ）技術對不同cu - fe薄膜的相結構進行了研究;利用xrd掃描及不同角度的2掃描對薄膜進行了結晶織構及殘余應力分析;運用小角x射線散射（ saxs ）技術測量了薄膜的厚度;採用原子力顯微鏡（ afm ）觀察了薄膜的表面形貌;運用能量損失譜（ eds ）及x射線熒光光譜（ xrf ）對薄膜進行了成分標定;使用振動樣品磁強計測量了不同cu - fe過飽和固溶體薄膜的磁性能;最後利用自製的磁阻性能測試設備測量了真空磁場熱處理前後不同薄膜的巨磁阻值。
  5. By the essential control of the initial stage of - material growth, the high - quality crystal films can be obtained. by using mocvd technology, studies of some kinds of methods such as hydrogen - terminated, nitridation, plasma - assisted, growth of two stages and sputtering buffer layers have been conducted. by measuring of xrd, pl, sem and tem, and analysis of spectra of xrd, raman scatting, oa, and pl at different temperatures, we observed that the crystal quality has been improved markedly

    本文利用mocvd技術，採用各種對si襯底處理的方法，如氫終止法、氮化法、等離子體轟擊方法、兩步生長法、濺射緩沖層法等進行了試驗與研究，通過x射線衍射技術（ xrd ） 、光致發光技術（ pl ） 、掃描電子顯微術（ sem ） 、透射電子顯微術（ tem ）等檢測，並對其x射線衍射光譜、拉譜光譜、吸收光譜及不同溫度下的光致發光光譜分析，發現外延晶體的生長質量得到了明顯提高。
  6. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  7. In this article, bioaerosol mass spectrometry, an instrument for real - time detection of bioaerosols using simultaneous measurement of particle aerodynamic size and intrinsic fluorescence, real - time qpcr, and fcm / fl were discussed

    生物性氣膠質譜偵測儀（指即時偵測生物性氣膠及微粒氣動直徑之儀器） 、即時定量酵素聚合反應技術、螢光染色配合螢光顯微鏡將于本文中討論之。
  8. Changes in h2o2 generation in guard cells of vicia faba induced by aba were measured by using fluorescence probe, 8 - hydroxypyrene - l, 3, 6 - trisulfonic acid ( hpts ). examination of epidermis peel was performed using a laser scanning confocal microscope ( lscm ) and spectrofluorometer, set to an excitation light of 405 nm and an emission light of 512 ran

    以蠶豆葉片下表皮為材料，將熒光探針hpts導入蠶豆氣孔保衛細胞內，利用熒光光譜和激光共聚焦顯微鏡技術，檢測了aba誘導蠶豆氣孔關閉過程中h2o2的產生。
  9. The uv - vis spectra, contact angle test and afm analysis indicated that all the films so prepared had a layer - by - layer structure. transmission electron microscopy ( tem ) analysis revealed that zno nanoparticles were equally distributed in the composite film

    採用紫外一可見光譜wv vis ） 、接觸角測試、原子力顯微鏡（ mm ）等分析技術對納米復合濕敏膜進行了表徵，發現四個納米自組裝復合膜體系都是層層交替結構， zno納米粒子均勻分散於有機無機自組裝膜中。
  10. In large rotating machinery using filmatic bearing ( turbogenerator, air compressor, etc. ) there is a potential trouble from impefect installation or running conditions, a metals " contact between rotors and shells. the trouble is usully called rubbing. the advantage of ae technologe in the rubbing diagnosis and early detection is showed. instead of classical ae characteristic parameters ( counts, amplitude, energy, duration and the other ones ) a new feature extraction by frequency analysis of ae envelop signals is discussed. both research of ae process and field experements indicate that periodic components in the envelop spectrum related to rotational speed increase evidently at the beginning of rubbing production, hence are highly sensitive to the rubbing fault diagnosis. according to the new design an acoustic emission equipment for the rubbing diagnosis named buaa ae testing system is developed and described

    汽輪發電機、空氣壓縮機等採用油膜支撐的大型轉動機械，由於安裝或運行中的原因，在轉子旋轉過程中，可能和器壁發生輕微的摩擦和碰擊，簡稱碰摩.聲發射技術在碰摩發生特別是故障早期診斷上有優越性.本系統的特點是沒有沿用傳統的計數、幅度、能量和持續時間等聲發射特性參數，而是在聲發射包絡信號的頻率分析中進行特徵提取.聲發射發生的過程分析和現場試驗都表明這種方法對碰摩檢測很敏感，在碰摩發生的起始階段，包絡譜中與轉速同步的周期性分量顯著增加.根據這種新的設計思想自行研製了buaa碰摩聲發射檢測儀並對此作了介紹
分享友人
分享到 Line

分享到臉書