高壓比 的英文怎麼說

中文拼音 [gāoyābǐ]
高壓比 英文
high-pressure ratio高壓比離心壓氣機 high-pressure ratio centrifugal compressor
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  1. A high - speed voltage comparator for pipeline adc

    的高速電壓比較器
  2. The article mainly studied and analyzed the chemical structure and conponents of yeast, pointed out that the way that yeast autolysis combined together with both breaking - wall in temperature difference and high - pressure homogenization can be used to promot the inside things from waste yeast cell and enhance the extract rate, thus searched for the technology in higher extraction rate

    摘要主要研究分析了酵母化學結構與組成，提出了酵母自溶、溫差破壁、高壓均漿三者相結合的方法來促進酵母內容物溶出提高抽提率，探索抽提率比較高的工藝流程。
  3. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高壓背壓式氣動測量用於小量程線性尺寸測量的靜態特性曲線的理論工作拐點進行了推導，對氣動測量系統中的噴嘴-擋板型氣動傳感器中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計，對主噴嘴和測量噴嘴的不同組合，將影響測量系統靜、動態特性指標的噴嘴參數進行了對比實驗和優化設計，並通過實驗驗證了理論推導，從而使氣動測量系統量程的示值范圍達到40 m ，靈敏度達到100mv m ，解析度達到0 . 05 m ，測量不確定度小於0 . 2 m ，滿足了壓縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  4. On the base of these theory calculations, we passivated the front - surface both of different surface doping concentration solar cells by a thin layer of thermally grown sio2. the results show that the in heavy surface doping concentration cell is lower compared to the cell in light surface doping concentration. the majority of improvement in comes from the emitter surface passivation

    接著採用sio2作為鈍化膜，從實驗上比較了在不同表面濃度下單晶硅太陽電池的鈍化效果，結果表明在高表面濃度下其開路電壓比低表面濃度下的開路電壓低，這開路電壓的提高主要來源於降低了前表面復合。
  5. In 2005, the department of health funded draper report found that children who lived within 200 metres of high voltage lines had a 70 % higher risk of developing leukaemia than those who lived more than 600 metres away

    2005年，英國衛生部資助的一項研究顯示，在高壓電纜塔周圍200米內的兒童患白血病的機率比居住在電纜塔600米外的兒童要高70 % 。
  6. The appropriate maximum stories and the appropriate maximum height of buildings are determined by using the various of control index, such as period, shear - compression ratio, allowable value of drift angle etc when earthquake fortification intensity is 8 degree

    用各項控制指標，如周期、剪壓比、軸壓比、層間位移角等進行對比分析，給出在8度區該結構的最大可建造層數和最大適用高度。
  7. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  8. The ridge lies farther from the equator in july than in either april or october.

    此高壓脊與赤道的距離在七月份比四月和十月份遠。
  9. Even under the condition that the filling pressure was up to 1. 5mpa, the onset temperature was only 237 ?. with the filling nitrogen of 0. 9 mpa, the maximal pressure ratio reaches 1. 21 and the operation frequency is 25 hz. the ratio of the harmonic wave of the engine was very little and the frequency jumping was not found in present experiments

    在充氣壓力為0 . 9mpa的條件下，該熱聲發動機最大壓比可達1 . 21 ，遠高於駐波型熱聲發動機，實驗結果和理論分析均表明系統的工作頻率為25hz左右，實驗裝置的諧波比例非常小，且也沒發現頻率跳變等現象。
  10. Based on the theory analysis and experiment work, the paper studies the humidifying property of the centrifugal nozzle with firing pin type, high pressure and little aperture. compared with the traditional air washer, the high efficiency and energy saving character of this kind of nozzle is stood out

    課題從理論和試驗兩方面分析研究了撞針型高壓小孔徑離心式噴嘴的霧化加濕性能，並將其與傳統噴水室加濕系統進行能耗比較，突出了撞針型高壓小孔徑離心式噴嘴高效節能的特點。
  11. Cracks control measures for masonry structure

    改善高層建築下部柱軸壓比性能的措施
  12. Li - ion batteries are widely used for their favorable advantages of high voltage, big specific capacity, long cycling life and non - pollution

    鋰離子電池以其高電壓、比能量大、循環壽命長，無污染等優點而得到廣泛的應用。
  13. Everything else being equal, a cold air column, because of its higher air density, is heavier than a warm air column and thus produces a higher air pressure

    在一般相同情況下，冷空氣柱因其密度較高，會比暖空氣柱重，因而產生氣壓較大
  14. The shear mechanism, failure mode, deformation capacity, bearing capacity and the reliability of the anchored angle steels of the wrapped steel concrete cast - in - site frame typical story exterior joints under the middle and high axial compression ratio ( n = 0. 3, 0. 5, 0. 6 ), the working performance, failure mode, and the shear capacity of top story joints under the crack moment, the hysteresis characteristic and the dissipation energy capacity of the test joints are all analysed based on the 1 / 4 model pseudo - static tests of five specimens of wrapped steel concrete cast - in - site frame exterior joints, which varied in axial compression ratio, distribution of the beam angle steels and the stirrup ratio

    基於上述分析，本次試驗通過五個外包鋼混凝土邊節點1 4比例模型的偽靜力試驗，以柱的軸壓比、梁角鋼布置形式、配箍率等為主要參數，分析外包鋼混凝土現澆框架一般層邊節點在中高軸壓比（ n = 0 . 3 、 0 . 5 、 0 . 6 ）條件下，節點的抗剪機理、破壞模式、變形能力、承載能力和角鋼錨固的可靠性；分析了頂層邊節點在張開彎矩作用下的工作性能、破壞模式和抗剪承載力；分析了試驗節點的滯回性能和耗能能力。
  15. They say that will help the search for genes and non - genetic factors that explain why american blacks run elevated rates of such diseases as high blood pressure, prostate cancer ( news - web sites ), obesity, asthma and diabetes

    他們說這樣會有助於研究為什麼美國黑人在像是高血壓，前列腺癌，肥胖，氣喘跟糖尿病逐年升高的比例中基因跟非基因的因子。
  16. Children who live near overhead power lines may be at greater risk of early leukaemia, a study published in the british medical journal said

    住在高壓電線附近的兒童，罹患早期白血癥（血癌）的風險可能比較高，一項刊載在英國醫學期刊的報告指出。
  17. However, it doesn ' t mean that the sealed pressure case made by lc4 will be perfect in performance

    Lc4超硬鋁合金在可選的材料中性價比居高，然而用它製成的高壓密封艙並非十分完美。
  18. Cetane improver. makes the engine run better at higher compression settings

    碳氫化合物的改進物。使引擎在高壓縮比時運轉較為順暢。
  19. The research shows that : 1 ) the ductility of the hsc bending members constructed is much greater than 5 ; 2 ) increasing the vertical links and distribution steel can increase the deflection under ultimate moment ; 3 ) with appropriate compressive bars, vertical links and distribution steel the increase of moment after yield and the decrease of moment under ultimate moment can be ignored, so the ductility of the hsc bending member is much larger ; 3 ) the width / depth ratio of hsc bending member has no obvious effect on the ultimate compressive strain of concrete ; 4 ) the method used here to calculate the deflection is applicable ; 5 ) the location of crack coincides with the location of vertical links and distribution steel ; 6 ) the bending property of the hsc structure under the blast load can meet the demand of protective engineering

    研究表明：本文研究的梁、板構件的延性比遠大於5 ；增加箍筋（鉤筋、分佈筋）含量，可以提高壓區混凝土剝落時的撓度；在適當的受壓筋、箍筋（鉤筋、分佈筋）含量下，可以忽略壓區混凝土剝落瞬間的承載力下降，從而大大提高構件的延性；受彎構件的寬高比對壓區混凝土極限應變的影響不明顯；受彎構件的裂縫間距受箍筋（鉤筋、分佈筋）的布置影響；文中所用的承載力和變形計算方法是可行的。化爆試驗表明，高強混凝土構件的動載抗彎性能能夠滿足防護結構的要求。
  20. Touch on developing large - flow and high - pressure ratio impressor and large - enthalpy drop turbine, reducing harmful emission, solving the major problems of high - temperature blade material, cooling, protective coating and single - grain blade casting, and comfirm some important manufacturing techniques

    涉及了開發大流量高壓比壓氣機、大焓降渦輪，降低有害排放量，解決高溫葉片的材料、冷卻、保護塗層及單晶葉片鑄造等主要問題，並確認了一些關鍵的製造技術。
分享友人
分享到 Line

分享到臉書