cathode aluminium 中文意思是什麼
-
The research and development and industrial test of aluminium electrolysis wetness cathode
鋁電解可濕潤性陰極的研究開發與工業試驗 -
The results show that the properties of the graphitized samples based on high quality eca and quantitative low ashes raw materials produced by proper carbon technics have reached to the demand of the cathode materials for high - current aluminium electrolysis cell
結果表明，以無煙煤為主要原料，配以一定比例的少灰料作為骨料，通過適當的炭素工藝制備的石墨化陰極材料試樣，其常規理化性能可以滿足大電流鋁電解槽用陰極材料的要求。 -
Carbonaceous materials used in the production of aluminium - prebaked anodes and cathode blocks - determination of flexural strength by the four - point method
鋁生產用碳素材料.預焙陽極和陰極碳塊.用四點法測定抗彎強度 -
Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrodes - determination of density of cathode blocks and prebaked anodes
制鋁工業用炭素材料抽樣和試驗方法.第3部分:電極.第2節:陰極塊和預焙陽極密度測定 -
The paper points out the inadequacy of production process in carbon cathode production and puts forward the improvement measures through the experience in the aluminium cathode production
摘要指出青銅峽鋁業集團有限公司炭素廠炭陰極生產工藝設計中的不足，通過在鋁用陰極生產中積累的經驗，提出了改進方法。 -
Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrodes - determination of electrical resistivity of cathode blocks and prebaked anodes at ambient temperature - section 3. 6 determination of electrical resistivity of cathode blocks and prebaked anodes at ambient temperature
制鋁工業用碳素材料的取樣與試驗方法.電極.室溫下陰極碳塊和預焙陽極電阻率的測定 -
Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrodes - determination of the bulk density apparent density of cathode blocks and prebaked anodes using a dimensions method - section 3. 3 determination of the bulk density apparent density of cathode blocks and prebaked anodes using a dimensions method
制鋁工業用碳素材料的取樣與試驗方法.電極.用尺寸法測定陰極碳塊和預焙陽極的體密度 -
Partially graphitiferous cathode carbon block for aluminium electrolysis
鋁電解用半石墨質陰極炭塊 -
The preparation process of cathode carbon block with low specific electric resistance for aluminium electrolysis, including selection of formula, determination of binder amount and optimization of technolgical parameters, was introduced
摘要介紹了試制低電阻率鋁用陰極炭塊生產工藝條件，包括骨料配方的選定、粘結劑用量等，並將所制得工業試驗炭塊應用於鋁電解。 -
Carbonaceous materials used in the production of aluminium - sampling methods - part 1 : cathode blocks
鋁用炭素材料取樣方法.第1部分:底部炭塊 -
Carbonaceous materials for the production of aluminium - cathode block materials - determination of the expansion due to sodium penetration with application of pressure
鋁生產用含碳材料.陰極塊材料.壓力作用下由於鈉滲透引起的膨脹的測定 -
Carbonaceous materials for the production of aluminium - cathode block materials - determination of the expansion due to sodium penetration without application of pressure
鋁生產用碳質材料.陰極塊材料.無壓力作用下由於鈉滲透引起的膨脹的測定
分享友人