copper crystal 中文意思是什麼

copper crystal 解釋
銅晶體
  • copper : n 1 銅;紫銅。2 銅幣,銅錢,〈pl 〉零錢。3 銅器;銅罐,銅壺,銅鍋;銅管;銅製品。4 (紫)銅色。5 ...
  • crystal : n 1 結晶,(結)晶體;晶粒;水晶(=rock crystal);石英。2 【無線電】晶體。3 結晶玻璃;雕玻璃;...
  1. The crystal structure of copper complex with dl - alanine

    配合物的晶體結構
  2. Atomistic simulation of tension properties of nano crystal copper wire under surface effects

    表面效應對納米銅桿拉伸性能影響的原子模擬
  3. At present the main products of company have : courtyard the light, ceiling lamp, last light, foot of a wall the the lights, light not under water, ceiling lamp, hanging overhead light, half a ceiling lamp, wall lamp, light, desk lamp, desk lamp, floor lamp, energy - conservation light, emergency light, sodium light, mirror headlight, putting out mosquito s light, searchlight, dampproof light, street lamp, wooden light, crystal light, shot - light, cow hide light, sheepskin light, cloud stone light, stone skill light, copper light, shelf light, etc.

    大至酒店賓館的燈飾照明工程,小到家庭裝飾的照明燈具。目前公司主要燈飾系列產品有:庭院燈吸頂燈地插燈墻腳燈水下燈吊燈吊頂燈半吊燈壁燈燈臺燈桌燈落地燈節能燈應急燈鈉燈鏡前燈滅蚊燈探照燈防潮燈路燈木燈水晶燈射燈牛皮燈羊皮燈雲石燈石藝燈銅燈架子燈等。
  4. Jiangmen boasts of rich mineral resources with 37 kinds of minable minerals, including limestone, silica sand, potassium feldspar, monazite, crystal, aquamarine, coal, tombarthite / rare earth, gold, silver, copper, iron, stannum and tungsten, among others

    礦產資源豐富,已探明可開採的有石灰石、硅砂、鉀長石、獨居石、水晶、綠柱石、煤、稀土及金、銀、銅、鐵、錫、鎢等37種。
  5. Tensile test and cyclic strain test of copper single crystal were performed. there are three stages in the plastic deformation

    觀測到銅單晶在拉伸變形過程中的三個階段,得到了循環應力應變曲線。
  6. After the cu - al mixed powder was milled 96h, the lattice constant of cu ( 111 ) plane became 0. 3653nm, and the diffraction peaks of aluminum have disappeared completely, which showed that aluminum atoms have dissolved in crystal lattice of copper

    當cu - al混合粉末球磨時間大於96h時, cu的( 111 )面的點陣常數變為0 . 3653nm , al的衍射峰已完全消失。通過分析可知,經過96h的球磨, al原子已經完全吲溶於cu的晶格中。
  7. Three parts are discussed, respective, ( 1 ) the nanostructure in the perfect of single crystal copper structure and perfect titanium structure. ( 2 ) the tensile deformation mechanism and stress analysis of the point defects effects. ( 3 ) the significance of effect as size reduced

    本論文所探討的內容可分為三部分,分別為: ( 1 )針對完美單晶銅結構與完美鈦結構的拉伸變形研究( 2 )包含了空孔點缺陷的拉伸變形結構研究( 3 )針對尺寸縮小后所造成的表面效應影響作一探討。
  8. Abstract : from the angle of the functional requirement for underwear and outwear, this paper analyses the properties of anti - microbial and occlusion fabric produced from copper and polar amino acid of silks complex emetic reaction to distributed by cu s crystal on the surface of silk. it made a study on the producing method of elastic fabric and indicates the common problems in both production and design

    文摘:從內衣對真絲的功能性要求及外衣對真絲綢成形能力的要求切入,介紹了利用銅化合物與桑蠶絲中的極性氨基酸發生絡合反應,在纖維表面形成硫化銅晶體得到抗菌導電真絲的原理和效果,還介紹了生產彈性真絲織物的幾種方法和影響織物彈性、服用效果的因素,提出了在生產、設計彈性真絲織物過程中應注意的主要問題。
  9. Abstract : the light atom imaging method in high resolution transmission electron microscopy ( hrtem ) and its application in crystal structure analysis for a series of metastable oxides of copper, nickel and silver is described. the idea stemming from this method has been extended to show the possibility of observing surface structure in a series of rather thick films with the hrtem plan - view imaging mode

    文摘:介紹了利用高分辨電子顯微學進行晶體結構分析的一種方法輕原子成像法的建立過程及其在銅、鎳、銀等金屬的初期氧化(硫化)產物結構分析中的應用.介紹了利用輕原子成像法的思想解決厚膜上觀察表面結構的可能性問題的新進展
  10. The result showed that the interpenetration network structure between polymeric and deposited metal has been observed under a scanning electronic microscope and optical microscope. the experiments showed that copper deposition gradient distribution and crystal structure were greatly influenced by the the ph value of electrochemical reduction medium solution and the size, number and distributing of microporous in swelling cathode film

    用掃描電鏡和體式顯微鏡對制備的pmgcf進行了分析,結果表明:制備的pmgcf樣品的金屬沉積層梯度分佈均勻,在一定的電化學條件下金屬銅和聚合物基體形成了互穿的立體網狀結構。
  11. 3 the experiment showed that there is no copper deposition in the film using p ( an - mma ) as polymer matrix. but the copper deposition and gradient distributing appears in the film when using p ( an - ita ) and p ( an - mma - as ) as polymer matrix. the size and number of crystal increases as the concentration of ita in copolymer increase and the film is prone to be ruptured

    3實驗顯示p ( an - mma )作為基體制備的pmgcf五金屬沉積,銅的沉積量為零; p ( an - mma - as ) , p ( an - ita )兩種共聚物為基體時均出現金屬銅的沉積,二者金屬沉積相均呈現一定程度的梯度分佈形態,但p ( an - ita )為基體時得到的晶體比較粗大,且隨其中ita的含量的增多得到粗糙晶體的數目增大,所制的pmgcf脆而硬,受外力沖擊時容易斷裂。
  12. On the other hand, when using p ( an - mma - as ) as polymer matrix, the gradient distribution of copper in pmgcf is raisonne, the crystal is smaller and compacter than the former, the flexibility of pmgcf increase as the concentration of mma in copolymer increase, the size of copper crystal increase as as the concentration of ita in copolymer increase

    P ( an - mma - as )為基體時金屬梯度分佈較合理,金屬晶體細小而且緻密,而且所制的pmgcf柔韌性較好,隨mma含量的增多而柔韌性增大,隨其中的as的含量的增大,所得的金屬晶體尺寸變化與p ( an ita )相似,但變化的趨勢較緩慢。
  13. Surface effect, tension and bending of nano single - crystal copper are researched on the basis of molecular dynamics using the eam ( embedded atom method ) potential

    本文主要應用分子動力學方法對納米單晶銅桿的表面效應及拉伸、彎曲性能做了分析和研究。
  14. The two strain rates are applied. the bending of nano - single copper pole is studied also. it proves that nano single - crystal of copper pole has the difference deformation compared with macroscale

    研究了銅納米桿在高低兩種應變率的變拉伸以及納米單晶銅桿的彎曲,觀察到了位錯的產生。
  15. After studying the precision of fdm process, a rapid edm electrode fabrication technology based on fdm is developed, the technology, which combined pulse - reverse electroforming with strengthening of copper wire - arc spraying, can obtained compact crystal electrode ' s working part, and strengthened filling part which has big adhesion strength, better electricity and heat conductivity, the edm performance of the obtained electrode reaches that of electrolysis copper electrode

    繼fdm工藝精度研究后,開展了快速模具製造技術的研究,建立了基於fdm原型快速製造電加工電極的工藝。該工藝將脈沖電鑄和電弧噴塗紫銅背襯相結合,獲得了結晶緻密的電極工作層和結合強度高、導電與導熱性良好的電極背襯層,得到的電極達到了常規機加工紫銅電極的電加工性能。
  16. Higher purity copper cathode - determination of arsenic content - heteropoly arsenomolybdic acid - crystal violet spectrophotometric method

    結晶紫分光光度法測定砷量
  17. Computer simulation of self - organised dislocation structures during the cyclic deformation in a copper single crystal

    計算機模擬循環形變銅單晶體的自組織位錯結構
  18. Synthesis and crystal structure of two - dimensional network copper coordination polymer linked by tartrate

    配位聚合物的合成和晶體結構
  19. Higher purity copper cathode - determination of phosphorus content - heteropoly phosphato - vanadato - molybdicacid - crystal violet spectrophotometric method

    結晶紫分光光度法測定磷量
分享友人