finite vortex method 中文意思是什麼

finite vortex method 解釋
有限旋渦法
  • finite : adj. 有限的；【語法】限定的；【數學】有窮的，有盡的。n. 〈the finite〉 有限（性）； 〈集合詞〉有限物。adv. -ly ,-ness n.
  • vortex : n. （pl. vortexes,-ti-ces ）1. 旋渦；旋風；旋卷行雲。2. 【物理學】渦旋；【航空】渦流；【動物；動物學】〈V-〉 單腸渦蟲的一屬。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. In the second chapter, the fluid mechanics principle of vortex flowmeter at first was introduced. the classical theory about vortex flowmeter and the method of computational fluid dynamics about flow around body were expanded on, and the model of the single bluff body and the dual bluff body vortex flowmeter were constructed. and then, fvm - finite volume method - analysis software fluent was applied to analyze the flow phenomenon of flow over single bluff body or dual bluff body

    然後通過大量實驗和理論分析給出雙鈍體渦街流量計的設計準則：當管徑為d ，鈍體形狀為三角形，則鈍體設計參數為：銳邊寬度= 0 . 26d ，高度= 0 . 34d ，鈍體之間的距離= 1 . 2d （即當兩鈍體寬度相等且鈍體距離等於單鈍體兩列旋渦之間的距離） 。
  2. In the second part, firstly, the mathematical model for predicting hydrodynamic characteristics of varivec propeller under steady or unsteady condition are present, based on the general propeller lifting - surface theory, potential flow theory and green theorem. then, theoretical calculation methods for predicting hydrodynamic characteristics of varivec propeller designed above paragraphs are present, based on the finite basic solution method, the unsteady vortex lattice method and hess - smith method

    在理論計算部分，本文首先基於常規螺旋槳升力面理論、勢流理論和格林定理建立了定常和非定常狀態下全方向推進器水動力性能計算的數學模型，然後利用有限基本解法、非定常渦格法和赫斯?史密斯方法對全方向推進器定常和非定常狀態下的數學模型進行了數值離散，接下來針對前面所設計的全方位推進器進行了數值預報。
  3. Abstract : hybrid finite analytic method ( hfam ) and staggeredgrid are applied to calculate the line buoyant jets in cross flows. the phenomenon and development of end - vortex are simulated successfully and the influences of diffuser length and buoyancy on turbulent buoyant jets are analyzed

    文摘:本文利用混合有限分析法及交錯網格，對橫流中有限長線源型浮力射流進行數值計算，成功模擬了端渦現象及其發展過程，並分析了擴散器長度及浮力對湍浮力射流的影響。
  4. Through the research of amf contact structure, several kinds of improvement are proposed and the improvement effects of amf density have been analyzed by adopting finite element method with cae. after fully considering the influence of the vortex and residual amf, a new cup - type contact structure with amf has been confirmed

    本課題通過對現行杯狀縱磁場結構的研究，提出了幾種改進方案，採用有限元法應用cae手段對改進方案的縱向磁場密度進行了分析，在充分考慮渦流和剩磁的影響后，從中確定了一種新的杯狀縱磁場觸頭結構。
分享友人
分享到 Line

分享到臉書