flow rate test 中文意思是什麼

flow rate test 解釋
流量試驗
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Standard test method for flow rate of metal powders

    金屬粉末流速的標準試驗方法
  2. 08. 01 flow rate of thermoplastics by extrusion plastometer, test method for

    擠壓式塑性計測試熱塑性塑料流速的方法
  3. During deliverability test, flow rate changes from small to big and we can obtain a series of flow pressures, including pressures above saturation pressure and below it, moreover, various physical characters can be obtained by experiments

    進行產能測試時，流量從小到大取得一系列穩定的流動壓力值，有大於和小於飽和壓力的測點。
  4. Highways winter maintenance plant and highways side equipment maintenance - deicing agent sprayer - fixed station test method for flow rate measurement

    高速公路冬季維修設備和高速路路邊設備維修.除冰劑噴灑機.流率測量固定站試驗方法
  5. The main products of our company : series of mining emulsion pump station, series of electric haulage shearer, sparying pump station, series of mining flame - proof vacuum / air electromagnetic starter, series of mining vacuum / air feeding switch, series of mining fame - proof and natural - safe. type ac soft starter, series of hydraulic stand valve and pipe system, high flow rate quick - moving valve, the new product nearing into market - the hydraulic support electric - control system, mining electric drill, hydraulic valve test table, electric performance test table

    公司主導產品為：系列電牽引採煤機、系列礦用乳化液泵站、噴霧泵站、礦用隔爆兼本質安全型交流軟起動器、系列礦用隔爆真空、空氣電磁起動器、系列礦用真空、空氣饋電開關、系列液壓支架閥類及管路系統、大流量快速移架閥、即將投入市場的新產品? ?液壓支架電液控制系統、煤電鉆系列、液壓閥試驗臺、電性能試驗臺等。
  6. Standard test method for volumetric flow rate of metal powders using arnold meter and hall funnel

    用阿諾德測量計和霍爾漏斗測定金屬粉末體流率的標準試驗方法
  7. In this research, through the test in geometric parameter and resistance performance, and comparison between random and other stacked packing, pvc screw thread oblique corrugated plate have more advantage. combined with test and theoretic calculate, determined the heat and mass transfer coefficient, obtained the influence relationship between inlet air flow rate, temperature and humidity, inlet liquid desiccate flow rate, temperature and concentration with outlet air humidity in dehumidifier, provided consideration for equipment design and production

    通過對除濕塔的現場測試並結合理論計算，確定其熱質交換系數，並分析得出採用pvc螺紋斜波紋板填料的一定結構的除濕塔，處理空氣的風量、入口溫度和含濕量及除濕溶液流量、入口溫度和濃度對空氣出口含濕量的影響關系，為除濕設備的設計和指導生產運行提供參考。
  8. Road construction and maintenance equipment. continuous batching equipment for products in powder form. test bench and method of flow rate measurement

    道路建造和保養設備.粉末狀製品用連續式分批配料設備.流率測量試驗臺和方法
  9. On the other hand, the hydraulic performance of the hole, including flow rate coefficient and uniformity of flow rate, have been tested as standards to evaluate the quality of holes punched by laser drilling machine with much better results than that punched by mechanical drilling machine. the shape of holes taken by a microscope photograph can also give detail and well explanations for this test results

    對噴孔水力學性能的試驗研究表明，本文提出的用噴孔水力學性能指標（流量系數和流量變異系數）來評價微噴帶激光打孔機質量的方法是可行的，並證明微噴帶激光打孔機的質量明顯優于機械打孔的質量，用顯微鏡觀察噴孔的形狀的照片也同樣證明了這一點。
  10. Much works has been distributed to the development of a vacuum system to simulate the outer space and a measurement system to test the arcjet performance. ignition experiments in various operational modes have been done with argon as propellant. macroscopical working parameters including thrust, mass flow rate, voltage, current, inlet pressure and vacuity are obtained by the test measurement system and actual performance parameters including specific impulse, thrust efficiency, ratio of thrust and power and ratio of power and mass flow are calculated

    以氬氣作為推進劑，在不同工況下進行點火實驗，測量獲得了其工作推力、電弧電壓和電流、推進劑流率和弧室壓力等宏觀參數，得到了不同實驗條件下其工作的實際比沖、推力效率、推力/功率比以及比功率等性能參數，分析了推進劑質量流率、電弧功率、電弧加熱發動機電弧室結構尺寸等因素對其性能的影響，為數值模擬研究和實際的低功率電弧加熱發動機優化設計及研製提供了實驗基礎。
  11. Standard test method for volumetric and mass flow rate measurement in a duct using tracer gas dilution

    用示蹤氣體稀釋法測量管道中體積和質量流量率的標準試驗方法
  12. Through analysis of test data in the field, it shows that the main causes leading to said phenomenon for are : adding water - cooling panel in the furnace ; rising of the feed - water temperature ; and somewhat smaller air flow rate in operation

    通過對其現場測試數據的分析表明，爐內增加水冷屏、給水溫度升高以及運行風量偏小是造成其主蒸汽溫度偏低的主要原因。
  13. Concentric jacket pipe surrounded the test condenser. steam was generated in the boiler, flowed upward to the inlet of connection pipes, then flowed downward into the condenser tube, the cooling water flowed countercurrently through the annulus. the experiment covered the range of the pressure 1. 0 ~ 3. 0bar, heating power 2. 0 ~ 15. 0kw, steam mass flow rate 0. 001 ~ 0. 004kg / s, air mass flow rate 0. 0 ~ 0. 00163kg / s, and cooling water temperature 20 - 60 ?

    在系統壓力為0 . 1 0 . 3mpa ，加熱功率為2 15kw ，蒸汽質量流量為0 . 001 0 . 004kg s ，空氣質量流量為0 . 0 0 . 00163kg s ，二次側冷卻水溫度20 60的范圍內，系統研究了豎直下降管內含有空氣的蒸汽冷凝特性，獲得了不同壓力、不同空氣含量和不同加熱功率下，冷凝段的溫度分佈和局部熱流密度的數據。
  14. The labyrinth - type emitter can be directly applied to irrigation experiment, the flow rate of 8 emitter prototypes are mensurated under 12 pressure values on the test - bad. moreover, experimental data are analyzed with multivariable linear regression in matlab, formulas of pressure versus flow and regression plots for 8 different emitters are induced from the regression analyses

    製作出的一體化滴頭原型直接連接到水力性能試驗臺上進行流量試驗，測定了12個壓力點下8種滴頭原型的出水量；應用matlab軟體中的多元線性回歸演算法對所得試驗數據進行了回歸分析，得出了8種滴頭的壓力流量公式和回歸曲線圖。
  15. The differential pressure across the pressure test points is measured and the flow rate calculated using the calibrated chart or flow coefficient table

    測量經過壓力測試點的壓差，並利用標準化圖表或流量系數表計算流動速率。
  16. Presents the field test data around a year of a groundwater source heat pump with pumping and recharging in the same well ( gshpprsw ) project in beijing, including the inlet and outlet groundwater temperature, groundwater flow rate and temperature of observation wells

    給出了北京某同井回灌地下水地源熱泵工程近一年的現場試驗數據，包括進出口水溫、地下水流量、測井溫度。
  17. Road construction and maintenance equipment. continuous batching. equipment for aggregates. test bench and method for flow rate measurement

    道路建造和維護設備.連續批量處理機.集料設備.流量比率測定的方法和試驗臺
  18. The reasons for higher oxidizer flow rate, lower fuel regression rate and lower motor performance in both hot firings are discussed. several necessary improvements for the test system are suggested. 6

    通過對兩臺發動機試驗結果的分析，找出了試驗中氧化劑流量偏高、燃料退移速率和發動機性能偏低的原因，並提出了具體的改進措施。
  19. Workplace atmospheres - pumps for the sampling of chemical agents with a volume flow rate of over 51 min - requirements and test methods

    工作場所空氣.體積流速大於51 min的化學試劑取樣用泵.要求和試驗方法
  20. Workplace atmospheres - pumps for the sampling of chemical agents with a volume flow rate of over 5 l min - requirements and test methods

    工作場所空氣.體積流速大於5公升分的化學試劑取樣用動力泵.要求和試驗方法
分享友人
分享到 Line

分享到臉書