liquid drop model 中文意思是什麼

liquid drop model 解釋
液滴模型
  • liquid : n 1 液體。2 【語言學】流音〈如 [l] [r]〉 adj 1 液體的，液態的，流動的。2 清澄的，透明的。3 易變的...
  • drop : n 1 滴；液滴，水滴。2 〈pl 〉 【藥學】滴劑；滴眼藥。3 微量，點滴；一口[杯]酒。4 滴狀物；耳墜；水...
  • model : n 1 模型，雛型；原型；設計圖；模範；（畫家、雕刻家的）模特兒；樣板。2 典型，模範。3 （女服裝店僱...
  1. The pressure drop of the compound tray can be regarded as consisting of dry plate pressure drop, clear liquid resistance, liquid surface tension resistance, and packing pressure drop. the model that has established can fairly predict the pressure drop of the compound tray, the value calculated by the model compared with that detected by experiment is less than 20 %

    復合塔板的壓降可認為由干板壓降、清液層阻力、填料層壓降和克服液體表面張力的壓降四部分組成，所建立的壓降計算模型，能較好地預測復合塔板的壓降，計算值與實驗值誤差在20以內，可用於工程設計。
  2. In this thesis, the basal theory of the nuclear structure were firstly and systemically described, the background and the application of the liquid - drop model, feimi - gas model, shell model and collective movement model were meticulously concluded and summarized. on the one hand, we not only pointed out their success, as well as their important effects on developing the nuclear theory and setting up the integrated nuclear theory system, but also pointed out their deficiencies

    本文首先對原子核結構的基本理論進行了系統的描述，對液滴模型、費米氣體模型、殼模型、集體模型等的背景以及它們的應用作了細致而又簡明的歸納和總結，一方面指出了這些模型的成功之處，以及這些模型在發展原子核理論並建立完整的原子核理論體系中的重要作用，同時也指出了它們的局限性。
  3. Liquid drop model of nucleus

    核液滴模型
  4. Abstract : a continuity wave model is put forward for the dispersion processof liquid - liquid two - phase system, by coupling mass and momentum conservation equations of two - fluid model. the conditions that result in a dispersion choke and the weak instability of a dispersion process are derived from the model. the phenomena of catastrophic inversion and transitional inversion are explained. the effect of drop size distribution on the maximum volume concentration of a emulsion is predicted using the model. according to the theory herein, emulsion inversion is the regime transition of liquid - liquid system due to the instablity of a dispersion process. the effect of drop size distribution on the maximum volume concentration of a liquid - liquid emulsion only occurs in a certain range of weber numbers

    文摘:以雙流體模型為基礎，通過質量守恆方程和動量守恆方程的耦合，提出了液-液兩相系中彌散傳質的連續波模型.由該模型得到彌散傳質過程阻塞和彌散傳質過程弱不穩定性產生的條件，計算了液滴尺寸及其分佈對乳化液極大堆砌分數的影響，解釋了劇變型乳化逆變和漸變型乳化逆變現象.研究結果表明，乳化逆變是由於彌散傳質過程的不穩定性而引起的懸浮體型態的改變，隨液滴尺寸多分散性的增大，極大堆砌分數增大；隨液滴平均尺寸的增大，多分散性對極大堆砌分數的影響減弱；當韋伯數足夠大時，液滴尺寸及其分佈對乳化液極大堆砌分數無影響
  5. Based on the liquid water content and optical visibility, the method for determining the parameters of gamma drop size distribution model of fog and clouds are developed, the drop size distributions for advection and radiation fog are obtained with empirical relations of the liquid water content and the visibility, the characteristics of drop size distribution for different kinds of fog are analyzed and discussed

    提出了利用雲霧含水量和能見度確定gamma雲霧滴尺寸分佈的方法，利用霧的含水量和能見度的經驗關系，得到了輻射霧和平流霧的霧滴尺寸分佈模型，並對不同類型霧的尺寸分佈特徵進行了分析和討論。
  6. Abstract : to analyze the temperature of the ladle completely and control it reasonably, the temperature drop behaviors of the molten steel in the ladle under various conditions were studied through establishing a proper mathematical model. the results provide a theoretical basis for reducing the temperature drop and decreasing the tapping temperature of the molten steel in the converter ， and for formulating proper temperature system of the liquid steel

    文摘:為全面分析，併合理控制鋼包溫度，通過建立合理的數學模型，對鋼包熱行為進行模擬，分析了不同情況下鋼液的溫度下降行為.為減少鋼液溫降、降低出鋼溫度、合理制定鋼包溫度制度提供了一定的依據
  7. Furthermore, asymptotic techniques to analyze large hartmann parameter flow and interaction parameter flow are employed and an analytical model has been developed for the calculations of mhd pressure drop of liquid metal flow in a packed pebble bed

    利用漸近線分析法對大hartmann參數流進行分析，給出了球床液態金屬溢流的磁流體動力學壓力損失的建模分析和計算結果。
  8. Model of oscillating liquid drop

    振蕩液滴模型
  9. The attenuation are also calculated and discussed with fog drop size distribution model and empirical relations of the liquid water content and the visibility or other parameters of fog and clouds. the measured results of sea fog attenuation in qingdao at 33. 5ghz and 93. 5ghz are analyzed and discussed

    提出了一種較其它經驗模式適用頻率和溫度范圍更寬，計算精度更高的雲霧衰減經驗公式，並對雲霧的毫米波衰減特性及海霧的毫米波衰減實驗結果進行了分析和討論。
  10. The relationship of the heat transfer coefficient with tea liquid concentration, heat transfer different temperature, vapor temperature, liquid flow rate, particle volume percent and different particle were studied. and analyzed the effect of liquid flow rate, particle volume percent on pressure drop. based on the character of inert particle fluidized bed evaporator, used the theorem, a mathematical model of inert particle fluidized bed evaporator heat transfer was proposed

    設計和建立了惰性粒子流化床蒸發實驗裝置，進行了傳熱性能和流體力學的理論分析和實驗研究；研究了物料濃度c _ e 、傳熱溫差t 、蒸發溫度t _ v 、液體流量i 、惰性粒子體積分率_ s等操作參數對流化床蒸發器傳熱性能的影響，文中還分析了液體流量i 、惰性粒子體積分率_ s等參數對床層壓力降的影響。
  11. A model was put forward and the theoretic value that calculated with it accorded with the experimental value well. at the same time, we also studied the pressure drop of the bed and the status of preventing and cleaning fouls. the results show that the heat transfer coefficient of vapor - liquid - solid three - phase circulating fluidized bed evaporator is 1. 5 times of the vapor - liquid two - phase evaporator ' s

    實驗結果表明，汽-液-固三相循環流化床蒸發器具有良好的傳熱性能，其傳熱系數是汽液兩相流蒸發器傳熱系數的1 . 5倍左右；惰性固體粒子具有良好的防、除垢效果，解決了設備的在線清洗問題。
分享友人
分享到 Line

分享到臉書