loading density 中文意思是什麼

loading density 解釋
加荷密度
  • loading : n. 1. 裝貨。2. 裝載量；重量；載荷；（船隻等的）貨載。 3. 填充物，填料。4. 額外人壽保險。
  • density : n. 1. 稠密；濃厚。2. 【物理學】濃度；密度；比重。3. 愚鈍，昏庸。
  1. , 2200bpi, 200tpi unrecorded single - disk, double - density cartridge front loading, 2200 bpi, 200 tpi, general, physical and magnetic requirements

    未記錄的單片雙密度盒式磁盤
  2. This dissertation presents a hypoelastic constitutive model with four material constants in describing the mechanical behavior of granular materials under loading. analysis results of the model have good coincidence with those of triaxial experiment of the standard sand under different relative density. the model can describe the contractant and dilatant phenomena of granular materials

    提出了一種含4個材料常數的亞彈性本構模型，來描述散粒體在加載時的力學行為，本模型的分析結果與不同相對密度下標準砂的三軸實驗可較好地吻合，能反映散粒體的剪縮、剪脹現象，還對如何用三軸實驗數據來確定這4個材料常數，給出了適宜的計算方法。
  3. Failure criterion of strain energy density and catastrophe theory analysis of rock subjected to static - dynamic coupling loading

    動靜組合加載下巖石破壞的應變能密度準則及突變理論分析
  4. Do not use the cloud or glass loading the device cloud the density low, the flap high, can affect the sound effect. glass density ratio cloud the is high, however not thick and solid, the flap more seriously. can use to spend the or, and it is tallest to is, density particularly, loading device than ideal, but the thickness want 3cm above

    別用雲石或玻璃承載器材雲石密度低，諧振高，會影響音響效果。玻璃密度比雲石高，卻不厚實，諧振更嚴重。可用花崗石或麻石，尤其是麻石，密度最高，承載器材較理想，但厚度要3厘米以上。
  5. During the course of developing and using high ballistic performance artillery with high exit velocity, high chamber pressure and high loading density, there were many accidents of breech blow

    在高初速、高膛壓和高裝填密度為特徵的高彈道性能火炮的研製與使用過程中，曾經出現過多次膛炸事故。
  6. Moreover, this smoke agent has some other characteristics i. e. large loading density, better insulation, better performance enduring high and low temperature, better compatible and stable performance

    該發煙劑還具有裝填密度大，不導電，耐高、低溫性能、相容性和穩定性能良好等特點。
  7. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
  8. Two test methods are employed : one is loading the samples before thawing, and the other is loading the samples after completely thawed. the coefficient of thaw settlement as a function of granule, as a function of water, and also as a function of dry density are protracted ; besides, the consolidation coefficient of thawed samples as a function of granule, as a function of water, and as a function of dry density are protracted. we can discover from the test results that the thaw - settlement coefficient and the consolidation coefficient of thawed samples are mainly relevant to the granule, dry density and the water content they have little to do with the geology and geography factor of the frozen soils

    為了研究季節凍土區工業民用建築的基礎淺埋穩定性問題，特開展了有關季節凍土的融化壓縮特性的研究，先後在內蒙古農業大學三個比較典型的建築地點取了將近三百個試樣，在室內進行試驗，採取兩種試驗方法即先融化后壓縮試驗法和同時融化壓縮試驗法，通過對這三個不同地點的兩種不同的試驗方法的試驗結果進行對比分行，分別繪制了融沉系數與凍土的含水（冰）量、干容重以及顆粒級配的關系曲線;融化壓縮系數與凍土的含水（冰）量、干容重以及顆粒級配的關系曲線，由試驗結果發現凍土的融沉系數和融化壓縮系數都與凍土的含水量呈正向相關關系，可近似的用線性方程來表示;兩種實驗方法的總沉降量與凍土的含水量呈正向相關關系，與凍土的干容重呈反向相關關系，也可以近似的用線性方程來表示。
  9. During loading the rice, the input rice weight keeps a good linear relationship with the grain depth detected by the ultrasonin sensor with the detected grain depth to estimate the stored rice volume, the weight of stored rice can be predicted by multiplying rice bulk density

    結果顯示對于進料量的估算，如果準確度的要求是在7 % ，不論是選擇上述任一種測量方式或是估算的方法都會合乎其要求；而出料量之估算因稻穀流動的方式差異較大，有待進一步研究改良。
  10. And a post - liquefaction test method has been put forward, in which the cyclic loading and the static loading courses are both controlled by stress mode. this method reflects the in - situ conditions well and truly, and a lot of tests have been done using this method. in these tests the effects of confining pressure, relative density, liquefaction severity etc. have been thoroughly investigated

    主要工作內容如下：參與研製了振動扭剪全自動多功能三軸儀，並利用其獨特試驗功能設計了一套飽水砂土液化后特性的試驗方法，試驗過程中模擬地震作用的動加載過程及模擬大變形發生的靜加載過程均採用應力控制的方式進行，試驗方法跟現場條件更為接近並用該試驗方法對相對密實度、固結壓力、液化度等對液化后變形特性的影響進行了研究。
  11. No matter what the relative density, confining pressure, liquefaction severities are, the post - liquefaction deformation will show the same characteristic. the factors mentioned above have their own affecting ways. a lot of tests have been done to investigate the reconsolidation characteristics of sand after dynamic loading

    砂土液化后模量隨應變增加而增大的特性與常規三軸試驗中模量隨應變增大而減小的特性不同，相對密實度、液化度、初始有效固結壓力等都以特定的方式對影響著液化后的變形特性。
  12. Powder loading density

    裝藥密度
  13. Unknown displacement and electric potential jumps in the integral equations are approximated with a product of fundamental density function and polynomials, in which the fundamental density function reflects singular behavior of electroelastic fields near the crack front and the polynomials can be reduced to a real constant under uniform loading

    超奇異積分方程中的未知位移間斷和電勢間斷近似地表示為基本密度函數與多項式之積，其中基本密度函數反映了橢圓片狀裂紋前沿電彈性場的奇異性，而多項式在均布載荷作用下可用一個常數來表達。
  14. In the paper, firstly, present the formulation and application of proper orthogonal decomposition of covariance and cross - power spectral density matrices are presented in the analysis of wind load effects on structures. then the dynamic response of linear structures subjected to random loads is analyzed by a technique called double modal transformation ( dmt ) that is expressed through a double series whose terms depend on structural and loading modes

    本論文中首先通過求相關矩陣和互功率譜密度矩陣特徵值問題給出了本徵正交分解的公式，並利用pod與結構模態相結合的雙模態方法來分析結構的動態響應，主要討論了截斷高階荷載模態對風致響應的影響。
  15. The following contents were discussed in detail : ( 1 ) effects of small particle content of the samples on the compaction characteristic of rock - salt ; ( 2 ) the value distributions of compressive strength of nature rock - salt ; ( 3 ) the effects of grain size, dry density and water content on compressive strength ; and ( 4 ) the development regularity of dynamic strain of rock - salt under traffic cyclic loading

    主要探討了巖鹽試樣中細粒含量比例對試樣壓實特性的影響規律；天然巖鹽抗壓強度的大小分佈，以及巖鹽抗壓強度與粒徑、干密度、含水量的關系；交通循環荷載作用下，巖鹽的動應變發展情況等。
  16. It is an effective new processing way for loading of the solid rocket motor with high loading density, high propellant mass fraction propellant

    為今後高裝填密度、高質量比的發動機裝藥開拓出一條新途徑。
  17. The numerical simulations of loading processes of flier - plates show that the loading history of the flier - plate designed with wave impedance as design parameter is significantly different from that of the flier - plate designed with density as design parameter and the former is expected to have better quasi - isentropic characteristic, which indicates that it is very essential to use wave impedance as design parameter directly to design the wave impedance distribution of flier - plate

    而以波阻抗作為設計參數，所得飛片的擊靶波形隨時間的變化更加平緩，有望獲得更好的準等熵壓縮性能。因此，直接採用波阻抗作設計參數，實現梯度飛片波阻抗分佈的精確設計是非常必要的。
  18. Abstract : based on the analysis of the pressing properties of loading materials for initiating explosive device, a system of automatic explosive pressing device was developed with the theory of intelligent control, so the automation of the pressing process was achieved, and the density identity of loading materials was enhanced significantly

    文摘:在分析火工品藥劑壓藥特性的基礎上，結合智能控制理論，研製了一臺自動壓藥機系統，實現了壓藥工藝過程的自動化，大大提高了壓藥密度的一致性。
分享友人
分享到 Line

分享到臉書