plating efficiency 中文意思是什麼

plating efficiency 解釋
出菌率，出斑率，接種率
  • plating : n. 1. （電）鍍，噴鍍；鍍金（術）。2. 鍍層；外覆金屬板；【造船】（全部）船殼板；（兵艦等的）裝甲。3. 【攝影】曬相。4. 懸賞賽馬。
  • efficiency : n. 1. 功效。2. 效率；效能；實力，能力。3. 【物理學】性能。
  1. The suitable additives recombination can not only improve considerably the quality of chromium coating, increase the brightness, current efficiency, dispersion ability and sedimentation velocity, but also enlarge the application scope of chromium plating technology

    採用適當的添加劑復合不僅可以顯著提高鍍鉻層質量，增加光亮度、電流效率、分散能力和沉積速度，而且可以擴大鍍鉻工藝范圍。
  2. Using contrast and orthogonal experiment methods, the effect of electrolyte formulae for varied concentration of cr03 and technology of chromium plating on coating property was studied systematically in this paper. primary factors and their interrelations, which influence the brightness of coating, the current efficiency, dispersion ability and sedimentation velocity of electrolyte were discovered

    本文採用對比試驗和正交試驗等方法系統地研究了低、中、高三種不同鉻酐濃度的鍍鉻液組成和鍍鉻工藝對鍍鉻層性能的影響，找到了影響鍍層光亮度、鍍液電流效率、分散能力和沉積速度的主要因素及其相互關系。
  3. According the key factors we find, we bring forward a new conception : multilevel suppressor and design a new high performance suppressor whose ion - exchange membrane has bigger areas and using three electrodes including one cathode ( anode ) and two anodes ( cathode ), at the same time we fill the suppression compartment with one kind of ion exchange resin which has moderate exchange capacity. according to our experiment ' s results, we find the new type suppressor has quite high working current efficiency and suppressing capacity. in most cases, the suppressor ' s current efficiency is over 90 % ; the suppressor can transform the naoh ( concentration : 200mmol / l, flow rate : i. oml / min, conductance : over 10000 i - i s cm " ) to pure water ( conductance : 8. 9 it s cm in chapter 3, the high performance suppressor is applied in determination some trace - amounts ions in plating solution, sewage. in this chapter, we also have a research on the gradient ion chromatography

    第二章首先以xyz - 1型電化學抑制柱為例，分析了電化學抑制柱的抑制過程得出影響抑制容量的主要因素主要是抑制柱的電流效率和離子交換膜的極限電流密度，因此採用中等交換能力的離子交換樹脂作為抑制室的填料以提高電流效率，在通常情況下電流效率可達到90以上；在選用同種離子交換膜的前提下，可通過增加離子交換膜的有效面積達到提高極限電流的目的從而提高抑制柱的抑制容量，因此提出了多級抑制的概念並據此研製了共電極式高容量電化學抑制柱，該抑制柱最高可將流速為1 . 0ml / min ，濃度為200mmol / l電導率超過10000 s ? cm ~ （ - 1 ）氫氧化鈉溶液抑制為電導率低至8 . 9 s ? cm ~ （ - 1 ）的純水，並且具有穩定性高、分析結果準確等優點。
  4. Improving the electroless plating process based on the work of the past decreases the series resistance from 0. 5 to 0. 1, increases the parallel resistance from 45 to 1119. 7, improves the filling factors from 49. 8 % to 66. 3 %, therefore the conversion efficiency comes to 8. 2 %

    機械刻槽電池電池結構的設計是依據bp公司的刻槽電池設計的，在以前工作的基礎上，進一步改變化學鍍工藝條件，是串聯電阻由原來的0 so降低到了0 iq ，並聯電阻由原來45q增加到了1119
  5. " induction period " was reflected the quality of electroless plating solution, and affected the efficiency of electroless plating, " induction period " was shortened with the increase of the concentration of nah2 ? o2 ? i - ho and coso4. it was shortened by increasing the ph and the loading of powder

    硫酸鈷和次亞磷酸鈉濃度的增加，鍍液的ph值升高，裝載量的增大，反應的孕育期變短；鍍速是反應時間與增重綜合作用的結果。
分享友人
分享到 Line

分享到臉書