powder compression 中文意思是什麼

powder compression 解釋
粉末壓制
  • powder : n 1 粉，粉末。2 （搽臉的）香粉；牙粉；發粉。3 （一服）藥粉；粉劑；散。4 塵土，泥屑；雪糝。5 炸藥...
  • compression : n. 1. 壓縮；壓緊；濃縮，緊縮。2. 加壓；壓抑。3. （表現的）簡練。4. 應壓試驗。
  1. The quality requirement is very high on expressway soft foundation improvement compared to the super pre - loading and the jet - powder pile, the vacuum - heaped load combining pre - compression is cheaper and its intensify effect is distinct

    高速公路軟基處理質量要求高，與傳統等超載預壓和粉噴樁加固軟基相比，真空堆載聯合預壓加固效果明顯，費用低。
  2. The study of the influence of the nonaxisymmetrical load in the progress of bamboo - fibre powder compression moulding with finite element

    非軸對稱載荷對竹纖維粉體模壓成形影響的有限元研究
  3. The powder reaction and the composite and condone reaction are thought to be the main reasons to get the high property. by mathematically analyses ratio - strength of concrete that ground high - ti bfs contribute to the strength of concrete are varied with amount of powder in hpc. the more amount of powder is above 20 percent, the compression strength reduce gradually

    同時，在本實驗的范圍內，微粉對高鈦礦渣混凝土強度貢獻率隨摻量的增加而增加；但強度值與摻量之間存在最佳摻量20 ，超過20時混凝土強度隨礦渣微粉摻量增加而下降。
  4. The stirred fluid and beads have multidimensional circulation motion and self - rotation for the stirrer rotation in the grinding chamber of a stirred media mill. high intensity motion is caused by multi - direction displacement of fluid and beads. the powder is comminuted by compression caused by beads gravity and helical turn for rubbing, impacting and shearing

    攪拌磨磨筒中，在攪拌器的攪動下，物料與磨介作多維循環運動和自轉運動，從而在磨筒中不斷地上下、左右相互置換位置產生激烈的運動，由磨介重力以及螺旋迴轉產生的擠壓力對物料進行摩擦、沖擊、剪切作用而粉碎。
  5. Powder treatment of kiln firing mister and compression molding

    窯業噴霧塔及壓製成型製程之粉塵處理。
  6. By using the high pure alumina micro - powder ( > 99. 0 % ) and the polymorphous alumina fiber as materials, by adding alumina sulfate as the binder or polypropylene - amide as the disperser respectively, through mixing, dispersing, and compression molding, at different temperatures of 1200 c, 1350 c, 1400 c, 1500 c, and 1550 c with no pressure, the alumina fiber - alumina composites were made

    本試驗採用高純氧化鋁微粉（ 99 . 0 ）和多晶氧化鋁纖維為原料，分別加入硫酸鋁和聚丙烯酰胺作結合劑和分散劑，經混合、分散、壓力成型及在1200 、 1350 、 1400 、 1500 、 1550下無壓燒成制得氧化鋁纖維? ?氧化鋁復合材料。
  7. It was found that active carbon powder and alloy steel powder can alter the composition and the structure of the interlayer efficiently in the technique of alloyed centrifugal - shs technology, which can manufacture compound pipes. they can change the interlayer from pure iron layer into carbon steel or alloy steel layer, then enhance the compression strength of the compound pipes

    研究結果表明，在採用合金化離心shs技術制備復合鋼管的過程中，活性碳粉和合金鋼粉末的加入可有效地改變過渡層的成分和組織，使過渡層由純鐵層變為碳鋼層或合金鋼層，進而提高了復合鋼管的抗壓性能。
  8. Metallic powder - determination of green strength by compression of cylinder compacts

    用圓柱形壓坯的壓縮測定壓坯強度的方法
  9. Two types of the equivalent mode of concrete compression zone were discussed and the corresponding formulae to calculate normal section strength of unbonded prestressed composite beams with reaction powder concrete were given. the calculating results tend to be conservative

    結果表明，現有公式在計算rpc預應力疊合梁的斜截面開裂荷載及斜截面抗剪強度時，是偏於保守的。
分享友人
分享到 Line

分享到臉書