the dielectric 中文意思是什麼

the dielectric 解釋
電介質
  • the : 〈代表用法〉…那樣的東西，…那種東西。1 〈用單數普通名詞代表它的一類時（所謂代表的單數）〉 （a） 〈...
  • dielectric : adj. 非傳導性的，絕緣的，介電的。n. 電介質，電介體，絕緣體。
  1. The dielectric constants of pt / tb films were influenced by the lattice aberrance and crystal content

    Pt tb薄膜的介電常數受薄膜中鈣鈦礦相晶格的畸變和晶體含量的共同作用。
  2. The dielectric constants were relatively high either lattice aberrance was tiny or crystal content was large

    摻tb薄膜的介電常數在晶格畸變程度小時和在摻tb后使晶體含量出現最大值時都較高。
  3. The main results are shown as follows : 1. bt _ 4 doped with cuo could be sintered in a lower temperature, because cuo has a low melting point. there isn ’ t any other phase in the samples. the dielectric properties decreased because cuo was non - crystalloid

    本人工作的主要研究成果如下: 1 . bt _ 4摻雜低熔點的cuo能降低樣品的燒結溫度，沒有其他相生成，燒結后cuo以無定形態的形式存在，導致樣品介電性能降低。
  4. Within the remainder of the dielectric the net charge per unit volume remains zero.

    在電介質的其餘部分，單位體積的靜電荷仍為零。
  5. Testing the dielectric constant of liquid by taking a long sample

    長試樣法測液體介電常數
  6. Test method for the dielectric constant of pyroelectric materials

    熱釋電材料介電常數的測定方法
  7. This heating helps to break down weak spots in the dielectric that otherwise might pass through the electrode undetected, only to fail during a later spark or hipot test

    這熱量幫助擊穿電線絕緣較薄的地方?否則線材通過電極而沒有被檢測到?結果在以後的火花測試和高壓絕緣試驗將會失效。
  8. But the grain growth, grain semiconduction and grain boundary insulation were influenced by many factors, such as the type and contents of dopants, sintering temperature and so on. therefore, in this thesis the effect of the restore sintering temperature, the oxygenize temperature, the donor and acceptor dopant on the dielectric and varistor properties of devices were studied. with sem, the microstructure of srtio3 - based double function ceramic was analyzed

    而晶粒生長、晶粒半導化和晶界絕緣化受到多種因素的影響，諸如雜質的種類和含量、燒成溫度等，因此本論文研究了還原燒成溫度、中溫氧化溫度、施主和受主摻雜等對srtio _ 3基陶瓷的壓敏和介電性能的影響，並藉助于sem分析對srtio _ 3基雙功能陶瓷的微觀結構進行了分析。
  9. The relationship between the dielectric constant and density of the material may be described by quadratic equations

    密度與介電常量的關系可用二次方程序表示。
  10. Because of the restriction of the performances of the infrared materials, we decide that the hollow waveguide should have the structure of single layer dielectric coated metallic film according to the general analysis of process controllability and transmission capability. the dielectric we choose is silver iodide, made from silver and iodine, and the optimum thickness is about 0. 77um

    因材料性能的限制，通過傳輸性能以及工藝可控性綜合分析，確定製備的空芯光纖為單層電介質塗覆金屬膜結構，電介質膜定為碘化銀，理論厚度為0 . 77 m左右，由銀膜直接碘化得到。
  11. The research work presented in this dissertation provides an efficient approach to analyze the dielectric objects and metal - nonmetal composite objects ’ transient electromagnetic scattering phenomena, as well as a solid foundation for the further development in this subject

    本文的工作為分析介質體、金屬非金屬組合目標時域電磁散射現象提供了有效的方法途徑，也為運用時域積分方程求解結構更為復雜、尺寸更為電大的金屬非金屬組合目標的研究打下了堅實的基礎。
  12. The square root and the cubic root of the dielectric constants are linearly related to the volume ratios

    介電常量的二次及三次方根與密度成線性關系。
  13. And then the extended ipo hybridized with fem is employed for the analysis of electromagnetic scattering by dielectric coated, electrically large cavities with complex terminal. green ' s functions of the dielectric coated board is involved

    在此基礎上，將改進的ipo與fem相結合對工程實際中所常見的具有復雜幾何結構終端的電大尺寸介質塗敷腔體的電磁散射特性進行分析。
  14. Then use the finite element method to analyse the dielectric loaded resonant cavity, and get the generalized eigenvalue equation ax = k02bx, in matrix b includes the unknown r

    然後採用有限元分析的方法來分析介質加載諧振腔，並得到待求廣義特徵方程ax = k02bx ，其中b中含有未知數r 。
  15. According to the theory of light transmission, we derived the expression of rotation angle as a function of the dielectric constant conductivity of er fluid, and ( the angle between the electric vector of linearly polarized light and electric field ) from maxwell ' s equations and fresnel reflection, on the condition of several appropriate approximations and assumptions

    進而導出了非均相結構電流變液在外電場與光場交互作用下旋光角與（入射線偏振光振動方向與外加電場方向間夾角）及參數（為外加電場e 、分散顆粒介電常數、體積分數、絕緣油介電常數、位置矢量（ ? ）等量的函數）的西北工業大學應用物理系碩士學位論文摘要理論表達式。
  16. Introduction cl21s are non - inductively wound with meatllized polyester film stacked as the dielectric electrode with copper - clad steel leads and epoxy resin coating

    Cl21s為無感結構，用金屬化聚酯膜作電介質電極繞制而成，導線採用鍍錫銅包鋼線，使用環氧樹脂包封。
  17. 3. the solution for the distribution of potential internal the dielectric ellipsoid has been obtained by means of ellipsoidal coordinates, and has obtainted the expression of the polarization field strength in the dielectric ellipsoid, calculated the included angle value of polarization vector and the external field vector, making programe to compute to get the relation shetch between the included angle value of polarization vector and the external field vector and we have discussed the result and hold that the direction of polarization field strength with that of the external field don ’ t always strict antiparallel

    二、討論了帶電粒子在均勻電磁場中的相對論運動規律。三、討論了在均勻電場中電介質橢球體的極化規律。證明了電介質橢球內的極化場強方向與外電場方向並非嚴格相反，只有當外電場與電介質橢球的某一主軸平行或者當橢球體三半軸的大小都相等時，極化場強方向與外電場方向才嚴格相反。
  18. In order to demonstrate the dielectric properties of sto thin film, the sandwich - type capacitors and interdigitated capacitors were fabricated

    為了測量sto薄膜的介電性能，做成平板電容器和叉指電容器兩種結構的電容器。
  19. Insulating liquids - determination of the dielectric dissipation factor by measurement of the conductance and capacitance - test method

    絕緣液.通過測量電導率和電容量測定介電損耗系數.試驗方法
  20. Check whether the insulation resistance and the dielectric strength of the electric devices attached to the panel and equipment body are sufficient

    譯：檢查一下控電板和設備體上的那些電器設備，看看他們的絕緣電阻和絕緣強度是否合格。
分享友人
分享到 Line

分享到臉書