transition temperature 中文意思是什麼
transition temperature
解釋
變態溫度- transition : n 轉變，演變，變遷，變化；飛越；過渡期；【音樂】變調，轉調；【修辭學】語次轉變；【語法】轉換；【...
- temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
-
As one of the most important applications, cmr bolometer is fabricated using the lacamno3 films, which has a metal - insulator transition temperature at 300k. the archetypal bolometer is fabricated after the film is photolithographed, evaporated au electrodes and fixed
以製作室溫超巨磁電阻測輻射熱儀為目標，將t _ （ mt ） 300k ， tcr 5的薄膜進行光刻、電極製作、封裝等處理製作測輻射熱儀原型器件。 -
Niobium is the metallic element with the highest transition temperature.
鈮是轉變溫度最高的金屬元素。 -
Dsc for the nanocomposites showed the glass transition temperature ( tg ) of the nanocomposites increases slightly as the mmt content increases. water absorption velocity and water retentivity under pressure tests showed the addition of montmorillonite ( mmt ) can improve the beginning absorption velocity and water retentivity for pure superabsorbent resin
吸水速率和加壓保水能力測試表明，一維納米級蒙脫土片層的引入能在一定程度上提高高吸水性樹脂的初期吸水速度和加壓下的保水能力。 -
5, both melting point ( tm ) and isotropization temperature ( tj ) of all the three series compounds change regularly with the carbon numbers of the end alkoxy group increased. there is a gradual increase in smectic phase length and in the smectic - nemetic transition temperature. at the same time there is a gradual decrease in nemetic phase length
五，三個類型化合物16ia至16id 、 16ila至16lid 、 17ia至17id 、 17ila至17lid 、 18ia至18id和18ila至18lid的熔點和液晶態的清亮點均化合物分子中末端烷氧基增大逐漸降低；近晶相的溫度范圍和近晶相一向列相轉變溫度逐漸增大，而向列相的溫度范圍遞減。 -
If the surfaces of baso4 particles were not modified with couplant, the interface was clear with a very small adhesive force ; while the surfaces modified, the interface was fuzzy with a strong adhesive force. the glass transition temperature ( tg ) of baso4 / tpu blend was obtained by dma
當baso _ 4表面未用偶聯劑處理時， baso _ 4 / tpu共混體系相界面清晰，界面粘合力較小；當baso _ 4表面用偶聯劑處理后， baso _ 4 / tpu共混體系相界面模糊，界面粘合力強。 -
It is found that the enhancement of the long - range interaction will result in the increment of the phase transition temperature, the increase of the critical transverse field and the decrease of the critical size
採用超越平均場理論計算了長程相互作用對鐵電薄膜的物理性質的影響，發現長程相互作用的增強將使鐵電薄膜的居里溫度升高、臨界橫場增大、臨界尺寸下降。 -
The crystallization and melting behavior of mellocene - catalized branched and linear polyethylenes of low molecular weight was studied. it was found that the crystalline lattice of branched polyethylene is larger than that of linear polyethylene because of the existence of branched chains. the melting behavior of branched polyethylene is similar to that of linear polyethylene since the branched chains can not enter the lattice. however, the crystalline behavior of low molecular weight branched polyethylene is the same as that of high molecular weight linear polyethylene, but different with that of low molecular weigh linear polyethylene. kinetics theory analysis evidenced that the transition temperature of growth regime of the branched polyethylene is about 20 lower than that of linear polyethylene with the same molecular weight. it may be attributed to the existence of short branched chains
研究了金屬茂催化的低分子量支化聚乙烯和線性聚乙烯的結晶及熔融行為，發現支化聚乙烯的結構與線性聚乙烯相同為正交結構，但晶格略有膨脹.支鏈的存在對熔融行為影響不大，兩種聚乙烯的熔點均隨結晶溫度的升高而非線性增加，表現出低分子量樣品的共同特徵.但支鏈的存在對結晶行為卻有很大的影響，主要是由於支鏈的存在降低了晶體的結晶速率從而影響結晶過程，使得低分子量的支化聚乙烯的結晶行為與高分子量線性聚乙烯的結晶行為相似而與低分子量的線性聚乙烯不同.動力學分析表明，低分子量的支化聚乙烯的結晶生長方式的轉變溫度比同等分子量的線性聚乙烯降低了約20 -
Standard method for conducting drop weight test to determine nil ductility transition temperature of ferritic steels
鐵素體鋼的無塑性轉變溫度落錘試驗方法 -
Then by means of heterocoagulation and encapsulatin, on controlled condition the superfine powders of caco3 and tio2 were coated with different nonaparticles ps. the composite particles with core / shell structure were prepared by heating the composite particles above the glass transition temperature of ps
然後根據異相凝集-包埋法原理對具有不同表面電性的微米級的caco _ 3和tio _ 2進行包埋復合，制得以無機粒子為核，有機粒子為殼層的包覆型有機?無機復合粒子。 -
The experimental results show that water jet impingement induces higher heat flux, higher critical temperature and narrower transition temperature range
水冷實驗數據分析結果表明：射流能提高熱流密度和臨界溫度，縮小過渡區溫度區間。 -
It is found that the pyroelectric coefficient and susceptibility increase with the decrease of the magnitude of the long - range interaction and the interfacial coupling when the temperature is lower than the phase transition temperature
我們發現，在相變溫度以下，隨著雙層薄膜的界面耦合的減弱，鐵電雙層薄膜的熱電系數和介電極化率增加。 -
Standard method for conducting drop - weight test to determine nilductility transition temperature of ferritic steels
鐵素體鋼的無塑性轉變溫度落錘試驗方法 -
Test method for conducting drop - weight test to determine nil - ductility transition temperature of ferritic steels
測定鐵素體鋼非塑性轉變溫度的落錘試驗方法 -
By reducing bromine content and adding aluminum hydroxide in the surface of substrate for the printed circuit board, comparative tracking index ( cti ) of the substrate is improved significantly, meanwhile the size stability, heat resistance, the glass transition temperature of the substrate are improved too
摘要通過降低印製電路板的基板表層的嗅含量並加入氫氧化鋁，顯著提高了基板的相比漏電起痕指數（ cti ） ，並同時提高了基板的尺寸穩定性、耐熱性、玻璃化溫度。 -
National key laboratory of advanced composites ( lac ) in beijing institute of aeronautics materials ( biam ) has developed a new medium temperature curing epoxy resin system, of which the glass transition temperature is 119. 88, for resin transfer molding ( rtm ). in order to investigate the relation between viscosity and time - temperature, the rheological behavior of the system was studied by dsc and viscosity experiments. a rheological model based on the dual - arrhenius equation was established and used to simulate the rheological behavior of the resin, which was in good agreement with experimental data
本文表徵了北京航空材料研究院先進復合材料國防科技重點實驗室樹脂組新開發出的rtm用中溫固化環氧樹脂體系3266 （玻璃化轉變溫度為119 . 88 ）其粘度隨時間、溫度的變化關系，在粘度實驗和dsc熱分析實驗的基礎上，對用於rtm工藝的該環氧樹脂體系的化學流變特性進行研究，並根據雙阿累尼烏斯方程建立樹脂體系的流變模型。 -
Test results show that that the breakcown voltage and heat distortion temperature the encapsulating materials of epoxy resin with hgh are famously improved, but the the addition of hgh, the viscosities of the epoxy resin - hgh system is higher compared with that of the others and the encapsulating process is effected. nano - sio2 improves the mechanical properties of encapsulating materials of epoxy resin, impact strength reaches 27. 64kj / m2 from 13. 95 kj / m2, flexural strength reaches 136. 68mpa from64. 95 mpa. by addition of the montmorillonite, glass transition temperature and heat distortion temperature of the encapsulating materials are 13. 2 and 16 higher than that of epoxy re
結果表明，活性硅微粉對環氧灌封材料的熱變形溫度和電學性能提高較為顯著，尤其在浸水后，電學性能降低幅度很小，西北工業大學碩士學位論文但活性硅微粉用量較大，材料的工藝性能明顯降低;納米5102對環氧灌封材料具有顯著的增強和增韌作用，沖擊強度、彎曲強度由原來的13 . 95kj / mz和64 . 95mpa分別提高到27 . 64kjzm2和136 . 68mpa 。 -
Ii ) with the increase of the long - range interaction and the interfacial coupling, the pyroelectric coefficient before the phase transition temperature decreases
另外，隨著長程相互作用以及界面耦合強度的增強，相變溫度以下的熱電系數明顯減小。 -
We obtain that i ) with the increase of the phonon - pseudospin interaction and the thickness of the superlattice, the phase transition temperature of the superlattice will increase. ii ) the increase of the phonon - pseudospin interaction leads to the change of the number of the pyroelectric peaks in the temperature curve of pyroelectric coefficient and to the change of the pyroelectric coefficient
研究發現，聲子與贗自旋的相互作用會影響鐵電超晶格熱電峰的數目以及熱電系數的溫度曲線的形態，而且聲子與贗自旋耦合作用的增強以及超晶格尺寸的增大都會使整個材料的相變溫度增加。 -
An anomalies in the dielectric constants and loss tangent have been observed experimentally in the ferroelectromagnet near the antiferromagnetic transition temperature, indicative of a coupling between the ferroelectric and magnetic ordering, but the nature of the mechanism of magnetoelectric coupling and the form of interaction is still an important and debated issue
而另一類是鐵電磁體，它除了具有一般磁電體的性質外，還由於固有的本徵磁有序和鐵電有序的耦合使之存在自發的磁電效應。實驗上已經發現了由於自發的磁電耦合導致的介電異常和損失正切。 -
We find that i ) with the increase of the long - range interaction, the interfacial coupling and the thickness of one period, the phase transition temperature of the ferroelectric superlartice increases
我們發現，隨著長程相互作用和界面耦合作用的增強以及鐵電超晶格尺寸的增大，整個材料的相變溫度升高。
分享友人