zone heat 中文意思是什麼

zone heat 解釋
區域熱
  • zone : n 1 【地理】（地）帶。2 區域，范圍，界。3 〈古、詩〉（腰）帶。4 圈，環帶。5 【數學】（球面）帶；...
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  1. As the return of flow is being, one side the heat gain of higher zone will be lead back, on the other hand, the heat has been transmitted to upside also will return, so the heat gain will incr ease. the methods of using numerical simulating has been used to analyze the factors influecing convecting transfer heat in this paper

    實際運行時由於空氣的回返，一方面會把上部的得熱帶回工作區，另一方面也會把下部已傳送上去的熱量又帶回，從而增加了下部的得熱量，本文就影響對流熱轉移量的因素利用數值模擬的方法做了一初步的研究。
  2. Relationship of laser light guided fiber and heat zone by laser irradiation

    激光間質熱療法中光纖終端形狀對加熱區域影響的研究
  3. Because of the large stuff of silicon, complex structure of furnace and expensive cost, computer simulation is a best way to optimize design. in order to study the new heat system, we have calculated the heat zone of 200mm solar cell czsi growth

    由於拉晶過程中投料量較大，爐體結構復雜、造價昂貴，所以計算機數值模擬對于優化單晶爐設計是一種重要的工具。本論文用有限元方法對改造后單晶爐的適合的熱場進行了數值模擬。
  4. We adopt new production process of cold ends, so our sic heating elements have excellent specific rate of heat zone resistance and cold end resistance, saving energy, long life, avoiding over - temperature of cold ends to damage the furnace body. the commercial name of our sic heating elements is songshan silca heating elements

    我們的碳化硅電熱元件採用新的冷端部生產工藝，具有優良的熱冷端電阻比，節能、壽命長，同時避免了因冷端部溫度過高對爐體造成的損害。
  5. It has issued residential buildings energy design standard for heating zone hot summer and cool winter zone and hot summer and warm winter zone. for heating zone, the method of effective thermal transmittance based steady heat transfer is used for the energy consume calculation, for hot summer and cool winter zone and hot summer and warm winter zone, the method based dynamic heat transfer must be used for the energy consume calculation

    對居住建築，我國已頒布了包括採暖地區、夏熱冬冷地區、夏熱冬暖地區三個節能設計標準，對北方寒冷地區，用建立在穩態傳熱基礎上的有效傳熱系數法進行能耗計算；對夏熱冬冷地區、夏熱冬暖地區，圍護結構受室外動態溫度和太陽輻射熱的綜合作用，明確應採用動態方法計算圍護結構傳熱。
  6. Tailor - welded tube in hydroforming and influence of the heat affected zone on bulge forming

    焊縫管液壓成形技術及熱影響區對成形的影響
  7. Microstructure and toughness of welding coarse - grain heat affected zone in ti - v - nb microalloy pipeline steel

    微合金管線鋼焊接粗晶區組織及韌性
  8. Regressed the experimental date with linear use minimal dual multiply method. got the empirical equation of heat transfer and flow resistance in laminar, transitive and turbulent zone

    Reb隨肋高h 、肋軸向間距pt的增大而減小，隨肋寬的增大而增大。
  9. Method of taper hardness test in weld heat - affected zone

    焊接熱影響區錐形硬度試驗方法
  10. Testing method of maximum hardness in weld heat - affected zone

    焊接熱影響區最大硬度的試驗方法
  11. Generally, intensity of welds in fsw exceeds heat affected zone

    通常情況下，摩擦攪拌焊的焊縫強度超過熱影響區。
  12. Weldability testing - testing method of maximum hard ness in weld heat - affected zone

    焊接熱影響區最高硬度試驗方法
  13. Heat affected zone, haz

    熱影響區
  14. Weld hardness is controlled ( including the heat - affected zone ) and maintained below 200 hb

    焊接硬度控制在（包括熱影響區域） 200hb以下。
  15. Using the heat of welding to vapour water, cooling rates are lowered on the weld bead and heat - affected zone

    利用焊接時的加熱使水汽化，不僅使焊道而且使熱影響區的冷卻速度減慢。
  16. Bpec established in 2003, which is a joint venture outside in home, the factory located in the juliang street no. 21 of cheng - an economic development zone inhebei, it regards producing and selling steel to a con - struction piece, the equipments of heat and it is series products as the contents primarily

    邯鄲博佩克成套設備工程技術有限公司，成立於2003年，是一家中外合資企業，廠址位於河北成安開發區聚良大道21號，以生產和銷售鋼架結構件、暖通設備及其系列產品為主要經營內容。
  17. The thesis begins with computational analysis to the aerated concrete wall thermal performance. the aerated concrete is proved to have good performance in heat - insulate and heat - conserve as single wall. the index of dew - condensing is within allowing range, thermal performance totally can meet energy - conserving standard requirement in hot summer and cold winter zone

    本文首先對加氣混凝土墻體熱工性能進行計算分析，論證其作為單一墻體，夏季隔熱、冬季保溫性能都很優良，墻體結露指標也在允許范圍之內，熱工性能完全可滿足夏熱冬冷地區節能標準要求。
  18. Aiming at such problems in combustion system of homemade middle and miniature boiler, as a complex system with the character of dead zone, time variation, serious non - linearity, large time delay, coupling and a lot of disturbance, this paper presents a new set of optimal control resources. by using well - matched control method on system, stable automatic running is realized. having the serious divulgence coals difference a lot from each other in character, instability of chemistry, value of lowest emission of heat, home - made boiler controller is not at all ideal. instead of traditional model that controls the ratio based on proportional control or with the correct signal of the amount of oxygen, this paper, combined with intellect control theory - - fuzzy control and self - optimizing concept, propounded a kind of fuzzy self - optimizing controller to be used in air supplying system of the boiler, and expatiates on the idea of dividing the control process into two parts, dynamic and static to realize, thus meets the demand of homemade boiler economic running

    本設計針對國產中、小型電站鍋爐燃燒系統參數時變、嚴重非線性、干擾因素復雜、耦合嚴重、模型不易確定的特點，提出多變量協調控制方案，解決了系統可控性差，難以實現穩定自動運行的問題；在此基礎上，改變以往以煙氣含氧量控制送風的傳統模式，針對國產電站鍋爐設備主體及一、二次送風迴路泄露嚴重，煤種混雜、成分不穩定、燃燒發熱值低、燃燒效率不高等問題，應用智能控制理論中的模糊控制技術，結合自尋最優控制的思想，設計了一種模糊自尋優控制器，應用在電站鍋爐送風控制系統上，並闡述了動靜態兩種實現途徑，通過在線優化風煤配比，實現最佳經濟燃燒，切實保障了鍋爐的經濟運行。
  19. Located in shangxi town of yiwu city, is a pvc blowing toys handbags factory with a large scale founded in 1985, it enjoys 16 - year s history, the factory covers an area of 11000 sq. m including huangshan development zone, owns 130 sets of large, medium small high - frequency heat - combining machines which form the firstclass printing production line in the same line. moreover, there are more than 200 skilled workers and a group of technicians with many years experience of production and ad - ministration served in factory. our factory has set up a good market image and established excellent brand reputation in passed years

    始建於1985年，至今已有16年的歷史。本廠佔地面積約11000平方米含黃山開發區。有大中小高頻熱合機130臺，在同行是一流印花生產線， 200多名熟練生產工人和一批具有多年生產製造管理經驗的專業人士，多年來我廠樹立了良好的市場形象，並建立了良好的品牌信譽。
  20. Abstract : there are offered many ways how to improve work of a spark plug. but one of the m ost important problems has not been solved yet. this is a thermal mode operation of a spark plug. the ideal spark plug should be instantly heated at the moment of occurrence of a spark and instantly cooled down in expectation of the foll owing electrical pulse. thus it balances between preservation of heat for self ? c leaning from scale and its removal in avoidance self ? ignition. in this article a uthor managed for this time to offer a spark plug with capability “ self ? regula tion ” of heat flux removed from a zone of ignition. essence of the offer is a t ip ， which is transparent for heat flux. it is produced from single crystal of sap phire

    文摘:在如何提高火花塞的工作質量方面有多種方法，但是其中最重要的一個問題還沒有得到解決，那就是火花塞工作的熱學模型問題.理想的火花塞應該能在點火的瞬間被立刻加熱，並且在接下來的電脈沖過程中迅速冷卻，由此在熱量的存儲與散發之間取得平衡，以避免自點火.本文力圖展示一種具有自動調節源於點火區域熱流能力的火花塞，其技術的關鍵是頂部絕緣體材料，它是由藍寶石單晶製作，而非傳統的氧化鋁陶瓷
分享友人
分享到 Line

分享到臉書