液膜式 的英文怎麼說

中文拼音 [yèmóshì]
液膜式 英文
liquid film type
  • 液 : 名詞（液體） liquid; fluid; juice
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  1. As to the work about theory analysis, at first, the paper describes the atomizing and humidifying process of the centrifugal nozzle with firing pin type, high pressure and little aperture and liquid physical properties. later, combining with the structure characters of this kind of nozzle, the paper studies on the theory of the atomizing and humidifying process by three phases, which is water film forming phase, water film falling into pieces phase, and heat and mass transfer between water and air phase in turn

    理論工作方面，首先描述了撞針型高壓小孔徑離心式噴嘴的霧化加濕過程和液體的物理性質，然後結合撞針型高壓小孔徑離心式噴嘴的結構特點，將其霧化加濕過程分三個階段進行機理上的研究，這三個階段依次為液膜形成、液膜初次破碎及二次霧化、水與空氣的熱濕交換。
  2. A novel low mechanical hysteretic ceramic capacitive pressure transducer has been made, by using of ceramic sealing technology ; integrate circuit ( ic ) technology and thick film plane fixing circuit technology. this transducer is made of a deformable ceramic diaphragm and a ceramic base plate, between which has an air cavum. a coaxial gold electrode was fired onto the diaphragm and the base plate

    本文利用新型陶瓷技術、集成電路技術和厚膜平面安裝電路技術，採用零力學滯后的陶瓷和陶瓷密封材料進行設計製造了一種非充液乾式的電容式壓力傳感器，該壓力傳感器由較厚的陶瓷基體和較薄的陶瓷膜片構成，中間形成一空氣介質腔，在基座和膜片之間內置同軸的雙電極，組成兩個電容，當膜片承受壓力時發生位移，使電容量產生變化，經後置處理電路直接轉換為可輸出的直流電壓信號。
  3. It is composed of evaporator, vapor separator, preheater and a simple separator. the evaporator is climbing film

    本薄膜蒸發器機組由蒸發器汽液分離器預熱器三個部件和一隻簡易分離器組成，蒸發器為升膜式列管換熱器。
  4. Membrane filter elements - part 3 : testing for specific liquid flow rate

    膜式過濾器元件.第3部分:液體比流率的檢驗
  5. In chapter 2, an accurate modified reynolds equation is derived. the modified reynolds equation is solved numerically with the finite different method, the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the rectangular screw are obtained. at last, using numeral methods and coordinate graphs, the influences of rectangular screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第二章，首先推導了非牛頓流體的變形雷諾方程，化簡了雷諾方程，得出了矩形螺紋下有限差分方程；還推出了矩形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，最後用數值計算方法求解，通過坐標圖分析了矩形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  6. In this paper the flow field of falling film along the inner of vertical tube is simulated and it ' s the necessary base of the further research that includes characteristics of heat and mass transfer in the absorber under the fluctuant state. in this paper the ocean fisher ' s movement in the ocean is studied and the physical and the mathematical models of fisher are founded, then the expressions of the force caused by the movement are obtained. the expressions are combined with partial different equations of falling film under the static state, thus the mathematical model of the falling film under fluctuant state can be gained

    本文首先研究了船舶在海洋中的運動，建立了船舶搖擺運動的簡化物理模型和數學模型，得到了運動附加力的表達式；並在此基礎上將吸收管的運動附加力表達式代入靜止狀態下液膜流動的數學模型中，即得到了搖擺狀態下液膜流動的數學模型；然後對液膜流動的數學模型進行了簡化，在假定了速度分佈的條件下，得出了液膜流動的積分方程，經過以上簡化就將求解三維問題轉化成為求解二維問題；將積分方程離散化後用數值計算的方法模擬了整個流場。
  7. In this paper the flow field of falling film along the inner of vertical tube is simulated and it ' s the necessary base of the further research that includes characteristics of heat and mass transfer in the absorber under the fluctuant state. in this paper the ocean fisher ' s movement in the ocean is studied and the physical and the mathematical models of fisher are founded, then the expressions of the force by the movement are obtained. the expressions are combined with partial different equations of falling film under the static state, thus the mathematical model of the falling film under fluctuant state can be gained

    本文首先研究了船舶在海洋中的運動，建立了船舶搖擺運動的簡化物理模型和數學模型，得到了運動附加力的表達式；並在此基礎上將吸收管的運動附加力表達式代入靜止狀態下液膜流動的數學模型中，即得到了搖擺狀態下液膜流動的數學模型；然後對液膜流動的數學模型進行了簡化，在假定了速度分佈的條件下，得出了液膜流動的積分方程，經過以上簡化就將求解三維問題轉化成為求解二維問題；將積分方程離散後用數值計算的方法模擬了整個流場。
  8. Membrane filters - part 1 : testing for specific liquid flow rate for flat filter

    膜式過濾器.第1部分:扁平過濾器液體比流量的檢驗
  9. Refrigerated light hydrocarbon fluids. calibration of membrane tanks and independent prismatic tanks in ships. physical measurement

    輕質碳氫化合物製冷液.船上薄膜式罐和柱型罐的標定.物理測量法
  10. In chapter 4, the modified reynolds equation is solved numerically with the finite different method, and the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the serrate screw are obtained. at last, using numeral methods and coordinate graphs, the influences of serrate screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第四章，首先求出鋸齒形螺紋下數值計算所需的有限差分方程，再推出了鋸齒形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，最後用數值計算方法求解，通過坐標圖分析了鋸齒形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  11. The design and application of mono - effective falling film evaporator in liquid milk

    單效降膜式蒸發器在液態奶生產中的設計及應用
  12. By theoretical analysis and experimental investigation to the exasperate position of the heat transfer in the umbrella - plate falling film evaporator, the exasperate experimental formula of the heat transfer was obtained. with the same reynolds, the high - point heat flux density of umbrella - plate evaporator is higher than vertical - plate evaporator could be observed from above formula, which maked out that with little reynolds liquid film was not easy to break

    在實驗條件下得出了傘板式降膜蒸發器小流量下液膜破裂的實驗關聯式，此關聯式表明極限熱通量隨臨界雷諾數增大而增大，在相同的臨界雷諾數下，傘板蒸發器的極限熱通量大於直板形蒸發器的極限熱通量。
  13. Research on dynamic pressure calibration based on hydraulic blasting film

    液壓爆膜式壓力動態校準方法研究
  14. Refrigerated light hydrocarbon fluids - calibration of membrane tanks and independent prismatic tanks in ships - physical measurement

    輕質碳氫化合物製冷液.船上薄膜式罐和柱型罐的標定.物理測量法
  15. The clinical value of thinprep cytology test for diagnosis of cervical lesions

    膜式液基超薄細胞檢測診斷宮頸病變的臨床價值
  16. The influence of difference in temperature, reynolds number of film and prandtl number to the heat transfer performance on the evaporation side was discussed via the uniform wall temperature experiments. by analyzing above influence factors, the character of umbrella - plate evaporator which is fit for evaporation under little difference in temperature and fit for evaporating heat sensitivity materiel could be obtained

    通過恆壁溫實驗探討了傳熱溫差、液膜雷諾數、普朗特數這些主要因素對傘板式降膜蒸發器傳熱性能的影響，通過對以上影響因素的分析，得出了此種結構的蒸發器特別適用於小溫差情況下的蒸發，而且特別適用於熱敏性物料的蒸發等特性。
  17. Based on the j c chen double mechanisms superposition model, the experimental formula of the heat transfer coefficient on the evaporation side in the smooth tube was obtained. considering the influence of spring to the falling film, the formula of heat transfer coefficient on the evaporation side in the vertical tube with spring inserts was obtained. the predicated heat transfer coefficient through this two formulas was finely accord with the experimental result, and the error was basically under 10 %

    在jcchen雙機理加和模型的基礎上，得出了光管降膜蒸發側傳熱系數的實驗關聯式，並考慮了螺旋線對降落液膜的影響，得出了管內插入螺旋線的降膜蒸發側傳熱系數關聯式，這兩個關聯式預測的傳熱系數與實驗值吻合良好，誤差基本在10以內。
  18. In chapter 3, the modified reynolds equation is solved numerically with the finite different method, and the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the trapezoidal screw are obtained. at last, using numeral methods and coordinate graphs, the influences of trapezoidal screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第三章，首先求出梯形螺紋下有限差分方程，然後推導了梯形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，並用數值計算方法求解，通過坐標圖分析了梯形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  19. Design and application of single - effect falling - film evaporator in production of liquid milk

    單效降膜式蒸發器在液態奶生產中的設計及應用
  20. In the laminar flow regime, a analytical mathematical model is obtained by analyzing the film flowing in the wavy wall tube. in the turbulent flow regime, mathematical model almost ca n ' t be obtained directly because the turbulent flow in wavy wall tube is very complex, the model is obtained by quoting some results which are theorized by other studiers. in the part of experimental study, the flow form in the wavy wall tube is observed by transparent quartz glass wavy wall tube apparatus, the evaporation experiments are carried out in a 3 meters steel wavy wall tube, using glucose as the medium, heat transfer is invested, the heat transfer correlations of wavy wall tube evaporator are obtained

    數學模型的建立過程中，對于液膜層流流動，直接對波形管內的降落液膜進行理論分析，得出液膜層流流動下數學模型的解析式；對于液膜湍流流動，由於湍流流動的復雜性，再加上所採用的波形管對湍流流動的影響，直接對降落液膜進行理論分析建立數學模型是極其復雜的，通過採用以前一些研究者得到的理論分析與實驗結果，並引入與波形管的形狀特徵參數有關的修正系數k ，建立液膜在湍流流動下的數學模型。
分享友人
分享到 Line

分享到臉書