激勵元件 的英文怎麼說

中文拼音 [jīlìyuánjiàn]
激勵元件 英文
exciting element
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 勵 : Ⅰ動 （勸勉） encourage; exert oneself Ⅱ名詞（姓氏） a surname
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 激勵 : 1 （激發鼓勵） encourage; impel; urge; inspire; excite; stimulate; put one on one s mettle 2 [電...
  1. The papers whose research object is the 7 - floor frame - structure with isolator - seismic layer, in which the isolator - seismic layer adopt some standard interlayer rubber isolator. by establish a 3 - dimension finite - element modal and use the a nalysis soft - ansys, we can make dynamic analysis on the structure. by analyses we can get some response characteristics of the structure sparked by the normal and rarely earthquake of 8 - degree fortify intensity, by the double - horizons seismic and by the vertical seismic

    本論文設計了一7層的具有隔震層的框架結構並以此為研究對象，其中隔震層採用標準件的夾層橡膠隔震墊，通過建立三維有限元分析模型，運用大型有限元分析軟體? ansys對結構進行動力響應彈塑性時程分析，得出了結構在8度設防烈度下的常遇水平地震和罕遇水平地震激勵下的響應特性、在雙向水平地震波激勵下結構的響應特性和在豎向地震波激勵下結構的響應特性。
  2. So here introduces a new method - the combination of boundary scan with deltascan, in which deltascan is applied to do short and open test in ict, so that the number of vectors used to test circuit short and open in boundary can be eliminated. all vector test, including boundary scan test, need to create test vectors

    任何邏輯元件的矢量測試，包括邊界掃描測試，都必須先生成測試矢量，然後用這些測試矢量作為輸入端的激勵信號，因此測試矢量是矢量測試的基礎，測試矢量生成方法的難易程度和測試矢量數目是邊界掃描技術能否在實際中應用的關鍵。
  3. Measurement of quartz crystal unit parameters - part 6 : measurement of drive level dependence iec 60444 - 6 : 1995 ; german version en 60444 - 6 : 1997

    石英晶體元件參數測量.第6部分:激勵電平相關性測量
  4. This study adopts active detection technique based on lamb wave to monitor damage in composite materials. pzt ceramics with the diameter of 8mm are bonded on the surface of fiberglass - reinforced composite material acting as both actuators and sensors to generate and collect lamb waves. the waves emitted interact with discontinuities and experience a change in their propagation characteristics when damage is generated

    本文採用lamb波主動監測技術，利用粘貼在復合材料板表面的壓電元件，通過選擇恰當的激勵信號，激勵出可進行lamb波分析的主動監測信號，進而對監測信號進行分析及模式處理，初步實現了二維結構的損傷定位。
  5. According to the principles of piezoelectric smart concrete structure health monitoring, a mathematic model of monitor system for static performances is discussed. then, the virtual waveform generator based on dds is designed using a data acquisition card and a pc to supply multiform excitation signals to piezoelectric elements in experiment. the theoretical analysis and experimental research demonstrate the performances of the waveform generated by the virtual instrument

    為了給壓電元件提供多種類型的激勵信號，根據直接數字合成原理，設計了利用數據採集卡和計算機實現dds波形發生的虛擬儀器，並對生成波形的各方面性能進行了理論分析和實驗研究，從理論和實驗兩個方面分析了這種波形發生方式所能取得的效果。
  6. The outputs of tests on the thin plate under different inputs have been investigated for testifying the system. different solutions have been compared according to the frequency - spectrum characters and structure modal parameters. it is indicated that the solutions in this paper are consistent with the solution of the fea methods

    以薄鋼板為實例，探討了不同激勵條件下，包括正弦穩態激勵、正弦慢掃描、單次錘擊和隨機錘擊激勵，薄鋼板振動系統的響應情況，以頻譜特性和模態參數為參考，將各種方法的求解結果作了比較，結果表明：本系統得出的結果與有限元解具有一致性。
  7. By the former experiment, we know that the fiber optic gas sensor with the pulse light of the blue light led can emit the steady fluorescence. so we can detect the density of oxygen through

    技術方案上採用數字脈沖激勵led藍紫光源照射敏感元件獲得穩定的熒光信號，再通過測量熒光壽命檢測氧氣濃度。
  8. Then the solving procedures of these bies by the rwg functions based moment method are elaborated, and the method of modeling complex objects built of arbitrary line, surface and volume structures is developed. in order to solve realize antenna and circuit problems, methods of adding excitations and concentrated loadings with moment method are deceloped, and matrix pencil ( mp ) method is used to deembeded the s prameters of antennas and circuits from the computed current distribution. some numerical results of practical complex antenna and scattering problems are presented to illustrate the veracity and effectiveness of the method

    在第一部分中，首先從電磁場的基本理論出發，基於等效原理和邊界條件以統一的方法建立了用於分析金屬、介質及金屬與介質混合結構的邊界積分方程，並歸納和比較了各類積分的適用范圍和優缺點;在此基礎上，給出了使用基於rwg函數的矩量法求解各種邊界積分方程的一般過程;研究了具有任意線、面、體組成的復雜結構的電磁建模方法，並給出了各種多面連接情況下基函數和未知量的選取方法;研究了使用矩量法分析電路、天線問題時集總元件和激勵源的處理方法，並基於矩陣束方法（ matrixpencilmethod ）提取了電路和天線問題的s參數;最後通過分析一些工程中的復雜金屬天線問題和具有「金屬與介質混合結構」的散射和天線問題驗證了方法的準確性和高效性。
  9. Figure 2 - 2 shows a typical electromechanical relay with the main operating elements labeled and a scheme for actuating the armature

    圖2 - 2所示為一個典型的機電式繼電器，其中標出了主要的工作元件以及激勵樞軸機構的示意圖。
  10. And one of the basic difficulties lies in the complexity of the fault models in the analog system since both the input stimulus and output response are continuous variables, and the parameters in the circuit components are also continuous too

    難點之一是模擬電路中的輸入激勵和輸出響應都是連續量，電路中元件的參數通常也是連續的，所以模擬系統中的故障模型比較復雜，難以作簡單的量化。
  11. Provision is made for connection of sense wires for 6 - wire circuits, these connections being commoned to the load cell excitation terminals on the ze10. 006 pcb

    如果這些連接與ze10 . 006印刷線路板的激勵終端上的測壓元件連接，也可以提供六線迴路的傳感器線路連接。
  12. The dissertation presents an automatic flow to characterize and model cells accurately and quickly by the stimulus reduction algorithm, the input signal driving algorithm, the characterization point dynamic insertion algorithm, the result table optimization algorithm and input signal integrity analysis algorithm, which reaches the advanced level in this field

    本文給出了深亞微米工藝條件下單元工藝參數提取和建模的完整流程，該流程能快速精確地完成單元工藝參數提取和建模。文中提出的激勵波形約簡演算法、輸入信號驅動演算法、測試點動態插入演算法和結果表優化壓縮演算法等，達到了國際同類研究的先進水平。
  13. Moreover, multiple frequency stimulation method can increase consumption of ic obviously and surface diffuse reflection method can improve surface emission coefficient of ic availably

    混和信號激勵法能明顯增大三極體放大電路耗散功率，特別是第一級耗散功率；增頻激勵法能有效提高ic耗散功率；表面漫射法能有效增大元器件的發射系數。
  14. The stochastic structure and stochastic intelligent truss structure are taken as research object in this paper. the analytical model and method of the structural dynamic characteristic are investigated. when the applied forces are random excitation or random process ( stationary random process or non - stationary random process ) excitation, the structural dynamic response, the active vibration control for the intelligent structure, the optimal placement of the sensor and the actuator and the optimization of the feedback gains of the closed loop control system for the intelligent structure, and the effects of the structural parameters on the active vibration control et al are all studied systemically

    本文以隨機結構和隨機智能桁架結構為對象，對結構動力特性分析模型與求解方法進行了研究；對結構在隨機力或隨機過程（平穩隨機過程或非平穩隨機過程）激勵下，結構的動力響應、結構的振動主動控制、智能結構中作動和傳感元件配置位置與閉環控制系統增益優化、結構參數對振動主動控制效果的影響等問題開展了全面而系統的研究。
  15. Considering of flexible installing of machines, which were supported by multi - mounts and disturbed by multi - excitations in engineering practice, a general dynamic model for the complex active - passive flexible isolation systems is presented. the mobility approach is extended to the analysis of the active isolation systems, and the power flow transmitted into the plate - like foundation of the systems is studied using substructure mobility synthetic technique. then the active control strategies of the power flow are discussed from the viewpoint of insertion loss, and the transmission mechanism is revealed for the flexible coupling isolation systems which comprise active elements

    綜合考慮工程實際中多激勵、多支承機組的柔性安裝問題，建立了主被動復雜柔性隔振系統的統一動力學模型，將導納方法推廣到主動隔振分析中，採用子結構導納綜合法對彈性板基礎上主動隔振系統的傳遞功率流進行了分析，並從插入損失的觀點探討了功率流的主動控制策略，揭示了含有主動作動元件的柔性耦合系統的功率流傳遞機理
  16. When the laser facilities are in operation, the position and direction of all the beams are subject to change due to the optical structural drifts excited by multiple input sources. these changes will influence the precision of the beam propagation and finally the focal spot positions on targets which are strictly dictated by the requirements of plasma physics experiments

    這些激光裝置在運行過程中，光學元件結構在外界激勵因素作用下容易產生漂移，使光束位置和方向發生改變，影響光束打靶定位精度，無法滿足精密物理實驗要求。
  17. 2. 45 in march 1999, the government proposed, in the civil service reform consultation document, to progressively introduce elements of a performance - based rewards system into the civil service with a view to providing additional tools to motivate and reward for excellent service

    2 . 45一九九九年三月，政府發表公務員體制改革諮詢文件，建議把工作表現獎賞的元素，逐步引入公務員體制內，以激勵和獎賞表現出色的人員。
  18. 5. the excitation sources that can cause motion of the optical elements and its relations are studied and analyzed. based on stability of optical component, the stability allocation theory and methodology for accounting for excitations are presented

    5 、分析和確立了影響光學元件穩定性的激勵源及其相互關系，並基於光學元件穩定性指標要求，探討了激勵源穩定性指標分配所採用的理論和方法，為系統分析和研究大型固體激光裝置光學元件穩定性提供了理論基礎。
  19. Resonant frequency at which the unloaded transducer without force translation parts oscillates after shocklike excitation in the direction of the measuring axis, whereby the basis intended for securing it is coupled to a sufficiently large mass

    沒有力平移元件的空載轉換器在測量軸方向上受到類似震動的激勵下會產生震蕩。在基本共振頻率下會對固定基礎造成很大傷害。
  20. Then, global coordination controller is designed through rule base. thus, a hierarchic controller of the coupled system, which consists of execution level, coordination level and organization level, is finished. in order to improve sensing and actuating performance of pzts, auto configuration of pzts function is presented and corresponding circuit is completed

    另外，為了充分地利用壓電元件的傳感能力和驅動能力，在傳感器和執行器的優化配置中，提出了根據外部激勵和柔性結構本身的振動狀況來對壓電元件的功能進行自動配置的思想。
分享友人
分享到 Line

分享到臉書