火焰量熱計 的英文怎麼說
中文拼音 [huǒyànliángrèjì]
火焰量熱計
英文
flame calorimeter-
It is very difficult to analyze flame radiation in the cylinder of a diesel engine by theoretical method since flame radiation is a function of many parameters, such as the combustion process, the geometrical description of the chamber, the soot formation and oxidation processes, the soot radiant temperature and soot absorption coefficient. the radiant property of the flame in a cylinder is dependent on the combustion process. but the thermodynamic state of real engine cycles can be analyzed from the pressure - volume diagrams in the cylinder. thus a new thermodynamic computational model is set up for the flame radiation in the cylinder of a diesel engine based on the indirect relationship between the flame radiation and the pressure - volume diagram of the combustion process in this paper. the flame radiant heat flux in the cylinder of a di diesel engine is calculated with the variation of crank angle by this model. compared with measured values, the result of the computational values shows the model is available to represent the effects of flame radiation
柴油機缸內的火焰輻射受諸多因素的影響，用理論分析法來確定它是相當困難的，由於柴油機缸內火焰輻射特性依賴于缸內的燃燒過程，而燃燒過程中的實際熱力狀態又可用示功圖來分析，因此藉助於火焰輻射與缸內熱力參數之間的這種間接關系，建立了一種計算柴油機缸內火焰輻射傳熱的新模型，利用該模型對一臺直噴柴油機缸內火焰輻射熱流量隨曲軸轉角的變化情況進行了計算，將計算結果與實測結果進行了比較，表明該模型能較好預測缸內火焰輻射傳熱量。In this thesis, designing " a " furnace arch by applying momentum synthesis and applying the laminar coal supply device to improve the burning in furnace, the operation duty of chain boiler, the thermal efficiency of boiler, are studied, according to the problems of the irrationality on boiler proper frame and the disproportion on system disposition in the design and the operation of chain boiler
本文根據鏈條鍋爐設計和運行中存在鍋爐本體結構上的不合理、系統布置上的不匹配等問題，研究了利用動量合成法設計「 」型火焰爐拱，以及利用分層給煤裝置來強化爐內燃燒，改善鏈條鍋爐運行工況，提高鍋爐熱效率。The result of investigation on drags of cavities under combustion condition, with different injection schemes and fuel equivalence ratio, indicates that it is smaller than it ’ s of cold flow, and decreases with increasing fuel equivalence ratio, and could be converted into the
研究發現:凹腔火焰穩定器熱試阻力小於冷流阻力，並隨著當量比的增加而減小，最終會表現為正推力。綜合論文研究成果，提出了多凹腔燃燒室設計技術。Calculating method and utilization guides for waste heat resource ' s quantity of industrial boiler ' s and flame heating furnace ' s waste gas
工業鍋爐及火焰加熱爐煙氣余熱資源量計算方法與利用導則分享友人