燃油流 的英文怎麼說

中文拼音 [rányóuliú]
燃油流 英文
fuel flow
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 燃油 : fuel oil燃油艙 [船舶工程] oil bunker; oil fuel tank; 燃油閥 fuel valve; 燃油鍋爐 oil burning boil...
  1. The faster fuel movement through the high-speed system causes more air to bleed into the system.

    經過高速系統的較高速的會引起較多的空氣滲入系統。
  2. Drafting can reduce lap times during a race and may have a minimal fuel - saving benefit

    可以提高圈速,也許還有一點點節省的功效。
  3. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的變性影響等特性,在霧化燒中逐步引起人們的重視,尤其在重渣等高粘度液體的霧化過程中逐步顯示出其優越性,但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨,將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手,討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響,並通過具體的實驗,根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律,以便找到超聲霧化的一些規律,豐富對超聲霧化機理的研究,對超聲霧化噴嘴的設計具有一定的指導意義。
  4. The portion of the carburetor air horn that reduces pressure to cause fuel to flow is called the venturi.

    減少引起燃油流動壓力的化器空氣喇叭口部分稱為喉管。
  5. Investigations also show that the catalyst shows good heat resistance in the presence of water and demonstrates high capability for mitigating sox poisoning. in the end, a novel way controlling combustion is employed in a 1. 342l s. i. engine, in which lean - burn, fast burn ( tumble ) and delay ignition make the engine provide much cleaner exhaust gas than that of a conventional premixed s. i. engine

    最後綜合採用機內凈化和排氣后處理并行策略,即稀、快(滾) 、推遲點火的可控燒新方案,結合分子篩稀催化器,在稀發動機典型工況下,在保證經濟性較原機改善14 . 8 %時, nox的排放大幅降低。
  6. If air-bleed passages become plugged, they may cause the float bowl to be emptied after the engine shuts off.

    如果空氣滲入通道堵塞,在發動機熄火后,會導致浮子室中的燃油流盡。
  7. Under the proposal, trade declaration charges would be reduced and duties on fuel would also be reduced to enhance the competitiveness of the logistics trade

    在建議下,報關費汽及飛機稅均會被調低,以加強物業的競爭力。
  8. Aircraft fluid installations. in - service interchangeability. flanges for level indicators, fuel pumps, etc.

    飛機的體裝置.使用的互換性.液面指示器泵等用法蘭
  9. This thesis has researched the rheology and combustion characteristic of still residue when it is used as fuel in oil - fired boiler

    本文研究並解決了黑腳用作小型鍋爐料時涉及到黑腳的變特性、燒特性。
  10. This additional fuel matches the additional air flow through so that the proper air-fuel ratio is maintained.

    增多的與增多的空氣混合,因而保持了合適的空-比。
  11. Makers of quality custom molded fiberglass products for water and wastewater treatment. product range includes flumes, shelters, weirs, odor control hoods and baffles

    -銷售爐頭,閥門,調節閥,助風機及其它-空氣調節閥,節閥,切斷閥,減壓閥等產品。
  12. If fuel does attempt to feed back, the pressure of the fuel forces the ball to seat, blocking the line.

    如果要倒,則的壓力就迫使小球落座,堵住管路。
  13. A fuel too volatile for the outside temperature, or a missing restrictor in the vapor line, will also cause improper engine idling.

    就外界溫度而言,的揮發性過高,或蒸汽管路中的節器有故障,也會使發動機的怠速不穩。
  14. An experimental study is carried out on the effect of following factors on the combustion performance of a vehicle fuel heater : geometric parameters ( the number, diameter, distribution and direction of combustion chamber intake holes ) and intake and exhaust pressures

    摘要對車用加熱器燒室進氣孔徑(通面積) 、孔的分佈、孔的方向等幾何參數和進排氣壓力對加熱器燒性能的影響進行了試驗研究。
  15. Investigation on unusual eddying tube type fuel perheater

    異形凹槽旋管式預熱器的研製
  16. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案:主風機為燒器提供燒所需的一次、二次進風量及冷卻風量;模擬實驗臺出口煙氣熱量是通過調節風機的轉速、風門開度及量來改變;實驗臺的量測量採用風機動力性能測試標準中量方法等。
  17. First, the working principles of the combustion control system of marine main boiler in present use and its disadvantages are discussed in the paper ; in the light of the structure and motion traits of marine main boiler, the combustion control systems of single and double cross amplitude limits are designed. at the same time, the schematic diagram of system and recovery curves of some relative parameters are given, the system working principles and its advantages and disadvantages are discussed. based on the combustion control system of dual - crisscross amplitude limit, by selecting the independent variable, the fixed offset is improved into variable offset, the combustion control system of variable offset dual - crisscross amplitude limit is designed

    首先討論了目前船用主鍋爐燒控制系統的工作原理及存在的不足;針對船用主鍋爐的結構及運行特點,設計了單交叉限幅燒控制系統和雙交叉限幅燒控制系統,同時給出了系統原理圖及有關參數的過渡過程曲線,討論了系統工作原理及優缺點;在雙交叉限幅燒控制系統的基礎上,將固定偏置經過自變量的選取,改進成變偏置,設計了變偏置雙交叉限幅燒控制系統,給出了系統原理圖及有關參數的過渡過程曲線,同時也給出了空氣壓力和燃油流量正負偏置函數與變偏置折線函數的關系式。
  18. Air - inlet simulation experiment has been carried out, through which total temperature and pressure simulation rule has been made clear, and the auto control of the fuel rate and air pressure has been realized

    利用本文建立的測控系統,進行了多次進氣模擬試驗研究。初步摸清了進氣溫度模擬和進氣壓力模擬的規律,實現了燃油流量和進氣氣壓力的自動控制。
  19. The system included 2 rotational speed measurement channels, oil flow measurement channels, 8 pressure measurement channels, which are based on pci bus in a industrial computer. the system software realized functions of which parameters are measured and states are monitored

    整個系統包括轉速測量通道2個、燃油流量測量通道2個、壓力測量通道8個,基於pci總線,在工控機上運行,由相應的系統軟體實現參數測試與狀態監視。
  20. The measurement system is based on pci bus and designed to integral measure the engine ’ s parameters such as pressure, engine rotate speed, air flux, etc. the system is very important in evaluatiang 、 ameliorating and repairing airplane engine because it provides relevant exam data for the airplane engine design

    該測試系統基於pci總線,對發動機的脈動壓力、轉速擺動、燃油流量等參數進行綜合測試,為航空發動機的研製提供相應的試驗依據,對發動機的性能評估、技術改造、故障維修等具有十分重要的意義。
分享友人