燃燒速率 的英文怎麼說

中文拼音 [ránshāosùlǜ]
燃燒速率 英文
burning rate
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 速率 : speed; rate; tempo
  1. Abstract : in the research of internal combustion engine, recordingin - cylinder pressure and temperature is an essential technique to study the thermal cycle of internal combustion engine. the combustion analyzer developed in this study will give both the measurements at sampling points per crank angle or sampling cycle, calculate and show the real time parameters which decide the working process of internal combustion engine, such as pressure accelerating rate, indicateed mean effective pressure, cycle - to - cycle variation, heat release rate, etc. compared with the imported congeneric products, the analyzer has many advantages such as chinese interface, low price, easy operateing, convenience in maintainance and easy upgrading

    文摘:為了測錄內燃機缸內的壓力及溫度，開發了一種內燃機燃燒分析儀.該分析儀由國產高速數據採集卡及自行開發的控制軟體組成.它不僅能精確設置每度曲軸轉角內采樣點的個數和採集循環數，而且在採集過程中能實時計算和表徵內燃機工作過程的壓力升高率、平均指示壓力、循環變動率、放熱率等參數.經實際使用以及與國外產品相比表明，此分析儀具有全中文界面、價格低、操作簡單、使用維護方便、功能便於擴充等優點
  2. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  3. This simple treatment also rationalizes the observed insensitivity of burning rates to chemical factors and pressure level.

    這個簡單表達式也能解釋觀測到的燃燒速率對化學因素和壓力量級的不敏感性。
  4. It is important that the dependence of the burning rate on both the local reactant character and the local gas dynamic environment be adequately represented.

    恰當地表示燃燒速率隨局部反應物特性和局部氣動力環境的變化關系是很重要的。
  5. The investigation has declared that the fuel injection with bq fuel pump had higher injection pressure, bigger fuel supply rate and shouter fuel supply duration, which would cause the fuel injection quantity and the fule - air mixture to increase during ignition delay period, the pre - mixed combustion to become acutely, and finally result in increased power levels of noise

    研究表明，裝配bq噴油泵，噴油系統的噴油壓力較高，供油速率較大和供油持續時間縮短，使得滯燃期的噴油量增加，滯燃期內形成的可燃混合較多，預混燃燒劇烈，導致整機噪聲聲功率級增加。
  6. In this paper, firstly the macro parameter of the series connection app was comprehensively analyzed, among which the trajectory location of the bullet emission and the terminal velocity of the bullet were mainly analyzed, and the feasibility of the series connection app to cope with explosive reactive armor was demonstrated. and then the macro design about the head of the series connection app was made, among which a particular analyse about the bullet " s launching process was made, from which we concluded the relation between the thickness of the airproof loop and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the burning rate of the powder and the relation between the length of the bullet and the maximum pressure of the emission hole and the relation between the length of the bullet and the emitting time of the bullet, and the reasonable str ucture of the head of the carrier and bullet were designed, then the intensity of the head of the carrier was checked out using of the software of ansys

    本文首先對子母式穿甲彈總體參量作了全面的計算分析，其中主要分析了子彈射出的彈道位置和必要的子彈著靶速度，論證了子母式穿甲彈對付爆炸式反應裝甲的可行性，然後對子母式穿甲彈彈頭部進行了總體設計，其中主要對子彈的發射過程進行了詳細的分析，得出了母彈彈頭部發射孔內閉鎖環厚度與子彈飛離母彈速度的關系、子彈長度與子彈飛離母彈速度的關系、子彈長度與火藥燃燒率的關系、子彈長度與母彈彈頭部發射孔內最大壓力的關系以及子彈的長度與子彈發射所需時間的關系，設計出了合理的母彈彈頭部結構和子彈的結構，並利用ansys有限元分析軟體對母彈彈頭部的強度進行了校核。
  7. Abstract : aimed at the accident of chatching fire of a certain type of self - propelled antitank gun s chamber, the paper analyses the normal burning of powder and the efficiency of the gun s extracting device and other factors affecting the burning velocity, makes an improvement on the weapon system, and puts forward the requirements for using the gun under army conditions

    文摘:針對某型自行火炮實彈射擊中戰斗室彈藥倉內半可燃藥筒起火燃燒事故，通過對可燃藥筒完全燃燒的理論分析和火炮抽氣裝置結構效率分析以及可能影響藥筒燃燒速度的其他因素分析，提出武器系統及可燃藥筒改進意見，並對部隊條件下的使用提出了要求，對改善裝備性能，預防事故發生具有重要意義。
  8. The convective term is solved by ausm + ( a sequel to ausm which means " the advection upstream splitting method " ). the 7 species 8 steps model and 7 species 7 steps model of hydrogen / air is used in the hydrogen reacting flowfield, the 9 species 5 steps model of methane, the 10 species 10 steps model of ethane and the 10 species 13 steps model of kerosene are used in the hydrocarbon reacting flowfield, the results of the distributions of velocity, mach number, pressure, static temperature, total temperature, species mass fraction and the combustion efficiency are gained, and the numerical results of the pressure of hydrogen and methane are compared with those of the experiment

    計算中通量項採用ausm +通量分裂格式，氫反應流場採用氫/空氣的七組元八方程模型和七組元七方程模型，碳氫反應流場採用甲烷的九組元五方程模型、乙烯的十組元十方程模型和煤油的十組元十三方程模型，得出了超燃發動機燃燒室流場的速度、馬赫數、壓力、靜溫、總溫和組元質量分數分佈及燃燒效率等性能參數，其中氫和甲烷的計算壓力分佈與實驗結果進行了比較。
  9. Via the analysis of heat balance computation model and the computation of online heat balance for industrial coal boiler, this dissertation researched overall input heat, efficient utilized quantity of heat, heat losing of discharge flue gas, heat losing of chemistry and mechanism incomplete combustion, heat losing of dispelling heat of boiler, heat efficiency, air superfluous coefficient, wind speed, wind quantity, computation of primary air circle cutting and whose influence on boiler combustion efficiency

    本文通過對工業煤粉鍋爐熱平衡計算模型的分析，利用在線熱平衡計算，研究了總輸入熱、有效利用熱量、排煙熱損失、化學不完全燃燒熱損失、機械不完全燃燒熱損失、鍋爐散熱熱損失、熱效率、空氣過剩系數、風速、風量及一次風切圓計算以及這些因素對鍋爐燃燒效率的影響。
  10. Mass burning rate

    質量燃燒速率
  11. A 2100 series diesel engine is modified into a spark ignited lpg dedicated engine. to improve power performance, economic performance, and emission performance and to enhance the power of the lpg engine, it is necessary to improve the combustion rate of lpg. it is realized by the application of a new kind of prechamber system

    對一臺2100柴油機進行了改造，使其成為火花點火式液化石油氣發動機，因液化石油氣燃燒速度低，為改善其動力性、經濟性、排放性和提高功率，有必要提高液化石油氣的燃燒速度，為此，設計了一種結構簡單、成本低廉的預燃燒系統，大大提高了燃燒速度，排放也得到改善。
  12. The simulations results show that the spoiler is available to make the fuel and the oxidizer coming from the former to stay in the cavity for a long time, to let the fuel and oxidizer mix and burn completely. since there is a high temperature zone forming by vortex in the middle of the motor, it required a restricted thermal protection. the plate with holes decreased the vortex function in the cavity, which could not promote the combustion efficiency, but to decrease temperature in the cavity and be benefit to thermal protection of the wall

    計算結果分析表明:擾流板可以使燃料和氧化劑在擾流腔內的滯留時間加長，促進燃料與氧化劑的摻混燃燒，提高燃燒效率，但由於渦流在發動機的中間部位形成了高溫燃燒區域，致使局部燃料和絕熱層燒蝕速率增大，加大了熱防護的難度;孔板結構減弱了擾流腔內迴流區的漩流作用，不能增加推進劑燃燒效率，但可以使擾流腔內的溫度降低，給壁面熱防護帶來好處。
  13. While the speed is very large, the fuel - air mixing behind the airstream is decreased and the span that the fuel flow in the second combustor is reduced, so the combustion efficiency is decreased, h ) if the fuel streams impinge with the airstreams directly at the air - inlet exit, it make against increasing the combustion efficiency, i ) increasing air - to - fuel ratio within proper range can increase the combustion efficiency

    增加燃氣噴射速度有利於增強迴流區強度，頭部燃燒溫度上升，但速度太大則會減弱燃氣同空氣在進氣道下游的摻混燃燒，減少燃氣在室內停留時間，燃燒效率降低； 8燃氣射流與空氣流在進氣道出口直接撞擊不利於燃燒效率的提高； 9在適當范圍內增大空燃比能顯著提高燃燒效率。
  14. In the alternate approach, the burning rate is expressed as a function of drop radius.

    在另一種方法中，燃燒速率表示為液滴半徑的函數。
  15. Burn - rate equation

    燃燒速率方程
  16. Area burning rate

    面積燃燒速率
  17. Burn - rate exponent

    燃燒速率指數
  18. Radiation - enhanced burning rate

    輻射增強的燃燒速率
  19. Explosives for civil uses - propellants and rocket propellants - part 4 : determination of burning rate under ambient conditions

    民用爆炸物.推進劑和火箭推進劑.第4部分:大氣條件下燃燒速率的測定
  20. Textile fabrics. burning behaviour. the 45 test determination of flame spread rate

    紡織織物燃燒性能45方向燃燒速率測定
分享友人
分享到 Line

分享到臉書