瞬間計時器 的英文怎麼說

中文拼音 [shùnjiānjìshíqì]
瞬間計時器 英文
chronotron
  • 瞬 : Ⅰ名詞（眼珠一動; 一眨眼） wink; twinkling Ⅱ動詞（眨眼） wink
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 瞬間 : moment; instant; minute; wink; in the twinkling of an eye瞬間點焊 shot weld（ing）; 瞬間高壓試驗 ...
  • 計時器 : calculagraph; time meter; chronoscope; timer; time market; time totalizer; elapsed timer; running...
  • 計時 : reckon by time; timing; chronography
  1. In this method of measuring time - resolved spectrum, a special light beam modulator translates the time - distribution of an optical spectrum into a space - distribution of light intensity of the light beam, and the space - distribution spectrum is dispersed by a multi - spectrometer, then it is detected by an ordinary 2 - d ccd array detector

    瞬態時間分辨譜測量方法的主要思想：使用特殊光束調制器把光譜隨時間的變化過程轉化為光強的空間分佈，經色散后，以二維探測器接收並轉換光信號為電信號，用通用計算機控制採集並處理光譜數據。
  2. ( 3 ) the theory of morden optimal control is used for the controller design of the active vibration isolation system. two algorithms, instantaneous optimal control and linear quadratic gauss optimal control, have been discussed and compared. an instantaneous optimal closed - loop control algorithm in structural space is derived by using the newmark scheme

    （ 3 ）應用最優控制理論設計控制器，對瞬時最優控制和線性二次型gauss （ lqg ）閉環控制方法進行研究和對比，並導出構形空間內的瞬時最優閉環控制演算法。
  3. Measuring engine transient process data in ca1258p1k2l11t1 truck in accelerated mode, recording and analyzing the data, then analysis the test error. 4. building model and simulating two typical running mode ? fixed 6th gear acceleration with initial vehicle speed 40km / h and gear change acceleration starting with 2nd gear, comparing calculated result with test result, revising transient process simulation model and analyzing error between calculation

    本文基於ca1258p1k2l11t1載重卡車對ca6df2 - 26發動機的瞬變工況進行試驗和模擬計算，結果表明: 1 ） gt - power軟體可以很好的模擬、分析、預測發動機瞬變過程，模擬計算的結果與試驗結果很接近，試驗證明，預測分析指出的改進方向是正確的; 2 ）加裝電動增壓器可以降低整車使用油耗，改善低速煙度排放，縮短加速時間，改善整車的加速響應; 3 ） gt - power軟體預測分析配合發動機和整車試驗是分析、解決發動機瞬變過程的有力工具。
  4. Load test results are extensive and include, for example, a graph that shows the instantaneous values of counters over the duration of the test

    負載測試的結果較為廣泛，例如，它包括一個反映在整個測試運行期間計數器的瞬時值的圖形。
  5. The control tactics of space voltage vector are investigated, and the simplified algorithm which judges the sector location of reference vector and calculates switch operation time is put forward. by analyzing the current hysteresis control, the relation between switch frequency, and hysteresis bandwidth and input inductance of pwm rectifier is deduced. by applying instantaneous power theory, the principle of pwm rectifier power control is analyzed, and the direct power control by matlab toolbox through estimating active power and reactive power with virtual flux is realized, and the simulation results prove that it is correct

    對常用空間電壓矢量控制策略進行分析，提出了給定參考矢量所在區間判斷的簡化方法，以及電壓矢量作用時間的求取方法；分析了電流滯環控制策略，推導出開關頻率與滯環帶寬以及整流器輸入電感之間的關系；應用瞬時功率理論分析pwm整流器功率控制原理，通過虛擬磁鏈估計有功功率和無功功率，用matlab實現了直接功率控制，並驗證了該控制方法的正確性。
  6. Rational control of the pump ' s work and rest time is the key to solve the problem of void pumping. this essay gives theoretical analysis and cost comparison of every detective method, considers power detection as the most effective method, and puts forward several ways of power consumption and effectiveness power consumption at the same time. the designed electricity saving controller integrate all the above four methods, and it can work with different methods by switch between automatic and manual to broaden its accommodation

    解決油井空抽現象的關鍵是合理控制開機時間與停機時間長度，本文對各種檢測方法進行了理論分析及成本比較，認為功率檢測最行之有效，同時提出了功率檢測的幾種實現方法，即瞬時功率法、人工電耗法、設定功耗法及效益功耗法，所設計的節電控制器集以上四種方法於一身，可通過自動手動切換採取不同的功率檢測方法，使其適應范圍增寬。
  7. Based on the investigation with several voltage control methods, such as venturini method, instantaneous double - voltage synthesis method and space vector modulation method ( svm ), three new control strategies are put forward. firstly, a time - varying modulation coefficient svm method is proposed to improve mc ' s anti - disturbance performance under the asymmetry input voltage. secondly, a 5 - state switching strategy is presented for mc controlled by the svm method, which reduces the commutation number and switching losses remarkably

    在分析了venturini控製法、瞬時雙電壓法、空間矢量法等電壓控制方法的基礎上，提出了在非對稱輸入條件下矩陣變換器空間矢量法的時變調制比改進控制策略，提高了變換器的抗干擾性能；對空間矢量法的開關策略進行了研究，提出了新型5狀態開關策略，在保證其他性能不受影響的條件下，減少了變換器的換流次數和開關損耗；提出了一種矩陣變換器單電壓合成的新方法，它不僅使得變換器的控制簡單，計算量減少，而且使得開關損耗達到最少。
  8. The following algorithms have been proposed and tested in the thesis : 1 frequency selective fading : combine the isomorphism between the input space and the output space and propose a new approach to blind equalization of the channel. compared with conventional methods, the new approach offers lower computational complexity, better performance, and more robust against the over - determination of the system order ; 2 time selective fading : a new approach to the equalization of time selective channel based on the zero - forced equalizer is proposed which is more simple in its structure of algorithm ; 3 time - varying channel : using the instantaneous mean value changes of the output signal to extract the information of channel variations and model it using ar model, kalman filter is then employed to track channel variations, it bears faster ability in tracking the variation of tv channels ; based on the isomorphism between the inputs and the outputs and some of the approaches using in mimo system, a new algorithm of equalization of simo time - varying channel is proposed, which also share the merits of being robust against the over - determination of the system order ; model the time - varying channel using the multi - resolution decomposition wavelets, and then a blind identification method based " on the model is proposed ; at last, a new model for equalization and identification of mimo system is proposed

    主要工作在以下幾個方面： 1 、針對頻率選擇性衰落通道：結合輸入輸出空間同構關系提出一種新的頻率選擇性通道均衡方法，與傳統方法相比，該方法計算量更小，收斂速度更快，性能更優，且對系統階次的過確定表現穩健，具有實際均衡應用價值； 2 、針對時間選擇性衰落通道：提出一種基於迫零均衡的時間選擇性通道均衡方法，演算法結構簡單； 3 、針對時變色散通道：利用瞬態均值曲線提取通道時變信息，對之ar建模，利用卡爾曼濾波器跟蹤時變通道抽頭變化，可以快速跟蹤通道變化；基於輸入輸出空間之間的同構關系以及多輸入多輸出系統的處理方法，提出了新的單輸入多輸出色散時變通道均衡與識別演算法，同樣具有對通道階次過確定保持穩健的優點；結合小波多解析度分析提出一種基於小波模型的通道盲識別演算法；研究時變的多輸入多輸出系統的盲均衡與盲反卷積問題，給出一種時變系統處理模型。
  9. The key technology of measuring time - resolved spectrum is to design and make the special light beam modulator that is used to the time - resolved spectrum detecting

    瞬態時間分辨譜測量方法的關鍵技術：設計和研製了專用於時間分辨譜採集分析的光束調制器。
  10. Not interfered electromagnetically, the traditional metering method of the water gauge does not change ; the sensor has no iron nature and magnetic goods and materials material

    不受電磁干擾，水表傳統的計量方式不變，傳感器沒有鐵性和磁性物資材料。抄表時瞬間提取數據，故不受電磁干擾影響。
  11. In basic action layer ' s designing, it uses a fuzzy - pid control algorithm that brings the system with a good dynamic and static performance. in the whole decision - making process, the protean situation on the competition ground is expressed by an artificial intelligence method for describing the state space that is constituted by selecting a small number of discrete representative states. desired actions are set for every robot based on the tasks of the system and the strategy

    其中在進行基本動作層的設計時，採用了模糊控制與pid控制相結合的智能控制演算法，使系統具有良好的動、靜態品質；而在進行整體決策時，採用了人工智慧的狀態空間表示方法，在比賽場上瞬息萬變的態勢中選擇少量的具有代表性的離散狀態來構成狀態空間，再根據系統需要完成的任務，為機器人確定有限的動作集合，並通過決策推理，給每個機器人選擇合適的動作，從而決策得出機器人的左右輪轉速值，實現對系統的實時控制。
  12. In this paper an fault simulator for iddt testing is presented, which can detect concurrently the multi - faults. due to the subtle error among equipment manufacturing, the gate delays of circuits are not the same but range within limits. which induces the uncertainty of the waveform transforming time

    本文從故障激活的條件入手，利用五值邏輯，對瞬態電流測試中的延時變化進行波形分析和波形計算，採用並發模擬演算法，編程實現了一個iddt測試的故障模擬器。實際電路中由於製造工藝的限制，邏輯門的延時並不相同，而是在一定范圍內變化，引起波形變化的時間不確定。
  13. Depending on how a counter is defined, its value might be the most recent aspect of resource utilization, also called the instantaneous value, or it might be the average of the last two measurements over the period of time between samples

    根據計數器定義方式的不同，它的值可能反映的是最近的資源利用情況，又稱「瞬時值」 ，也可能是上兩次度量值在兩次樣本之間的那段時間內的平均值。
  14. This paper has devised a plug - in data acquisition ( daq ) system based on isa bus and developed a real - time testing software with the platform of the graphic programming language - labview, which has test data ' s real - time sampling, analysis and processing, instantaneous plot saving, plot reoccurrence, data saving to disk and reading from disk functions and so on

    本課題設計了基於isa總線的內插式數據採集（ daq ）系統，並以圖形化高級語言labview為平臺編制了虛擬儀器實時測試軟體，實現了數據的實時采樣、實時分析處理、瞬間圖形存儲、圖形再現、數據存盤和讀入等功能。
分享友人
分享到 Line

分享到臉書