適應溫度 的英文怎麼說

中文拼音 [shìyīngwēndù]
適應溫度 英文
adaptive temperature
  • 適 : 形容詞1 （適合） fit; suitable; proper 2 （恰好） right; opportune 3 （舒服） comfortable; well Ⅱ...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 適應 : suit; adapt; get with it; fit
  • 溫度 : [物理學] temperature
  1. The he was strongly inhibited by sbti and apmsf, and very sensitive to pmsf, lbti, and tlck, while not sensitive to chymostatin, bestatin, leupeptin, tpck, pepstatin, nem and iam. all these results imply that brine shrimp he was most probably a trypsin - type serine protease. the he could be strongly inhibited by edta in a dose - dependent manner, and 50 mmol / l edta exhibited more than 56. 5 % inhibition

    對孵化酶純化樣品進行生化性質和酶性質分析發現，鹵蟲孵化酶的最適反應溫度約為40 ，最適ph為8 . 5左右；該孵化酶對p - apmsf 、 sbti極為敏感，對pmsf 、 lbti和tlck也非常敏感，但對chymostatin 、 leupeptin 、 pepstatin 、 bestatin 、 tpck 、 nem和iam不敏感，表明該酶極可能是一種屬于胰蛋白酶類型的絲氨酸蛋白酶。
  2. The application of the air condition system, improved the small weather of the air condition space inside, bring us the comfortable temperature, degree of humidity environment

    空調系統的應用，改善了空調空間內的小氣候，給我們帶來了舒適的溫度、濕度環境。
  3. Our garden hose is non - toxic, resistance to high pressure, corrosion and tension, high - elastic, flexible, smooth and long service life. it is high adhesion between the outside and the inside layer without de - lamination, rubber - like elasticity, compact, easy in unwinding / rewinding and handly. widely applicable to irrigate plant and flower in agriculture, garden, park and household, also to clean car, bus, factory, animal. etc

    我廠花園管具有無毒，抗高壓，抗腐蝕，抗拉伸，高彈性，外形美觀，使用壽命長之優點，特點是內外壁之間粘合好，無縫隙，彈性猶如橡膠，輕便，易卷易放.廣泛應用於農業，園林，公園和家庭的植物灌溉及汽車，廠房，動物等的清洗.適用溫度: - 10至+ 60攝氏度
  4. As man lost consciousness prior to the breaking of the ice shields, all but a few humans lost the ability to modify the dna to adjust to the temperature change

    當人類在冰天破裂前就丟失意識時，除了一小部分人以外，所有人都喪失了調整dna來適應溫度變化的能力。
  5. Copper - nanosized tibi composites were prepared by in - situ process. the microstructure, mechanical and electrical properties, and dry sliding wear behavior and electric sliding wear of cu - nanosized tib _ 2 in - situ composites was investigated ; mostly task as follows : the thermodynamic data for the reactions between b and ti in the molten liquid of copper were analyzed, the copper matrix composites reinforced by in - situ tibi nanoparticles were prepared by reactions of 8263, carbon and titanium in copper - titanium melt, and copper - titanium, copper - boron in alloy melt, respectively, which controlled the reaction temperature, reaction time and solidification process. the rnicrostructure and mechanical and electrical properties of the in - situ composites were investigated by using optics microscope, tem and xrd

    本文採用原位反應法制備了cu -納米tib _ 2原位復合材料，在此基礎上分析了原位復合材料的微結構，進行了干滑動摩擦磨損和電接觸滑動磨損實驗，完成的主要工作如下：從熱力學的角度出發，分析了陶瓷tib _ 2顆粒在銅基體中原位生成的熱力學條件，並用電解銅、工業純鈦、 b _ 2o _ 3 、 c （還原劑）以及cu - ti 、 cu - b等合金為原料，通過控制適當的反應溫度、反應時間和快速凝固等工藝手段，制備了cu -納米tib2原位復合材料。
  6. The effect is studied systematically of various factors ( such asthe reaction temperature, water consumption, proportioning and continuous operation mode ) on the reaction process for the manufacture of potassium sulfate by double decomposition of potassium chloride and ammonium sulfate, and appropriate process conditions are determined for the conversion

    系統探討了各種因素（如反應溫度、水用量、配料比以及連續化操作方式）對以氯化鉀、硫酸銨為原料的復分解法制硫酸鉀反應過程的影響，確定了適宜的轉化反應工藝條件。
  7. The effect is studied systematically of various factors ( such as the reaction temperature, water consumption, proportioning and continuous operation mode ) on the reaction process for the manufacture of potassium sulfate by double decomposition of potassium chloride and ammonium sulfate, and appropriate process conditions are determined for the conversion

    系統探討了各種因素（如反應溫度、水用量、配料比以及連續化操作方式）對以氯化鉀、硫酸銨為原料的復分解法制硫酸鉀反應過程的影響，確定了適宜的轉化反應工藝條件。
  8. Abstract : the synthetic method of pentaerythrito naphthenate by n on - acid catalyst sno was studied. the influences of mole ratio of ethanediol and naphthenic acid, a mount of catalyst, reation time, reation temperature etc. on est erification were discussed and the suitable processing conditions were found

    文摘:介紹了用氧化亞錫非酸性催化劑催化合成環烷酸季戊四醇脂的方法，通過討論醇酸摩爾比、催化劑用量、反應時間、反應溫度等因素對該脂化反應的影響，從而確定了適宜的工藝條件
  9. Great difference in pressure for two flow made pressure wave system and it help to extend the delay time for gas in chamber, which increases combustion effusion. second, to increase combustion effusion, the inlet temperature of air and gas should be enhanced in the range of heat releasing in chemical reaction. third, the first work condition is unburned absolutely and the second work condition is burnt in shear layer of inlet and the end of down wall zone in straight segment

    對于壓力差很大的兩股氣流，所形成的壓縮波系的結構可以增加燃氣駐留時間，提高燃燒穩定性;為了提高擴散燃燒的效率，在保證能放熱的化學反應溫度范圍之內，應適當提高燃氣及空氣的來流入口溫度;燃氣噴嘴應居於燃燒室軸線上，是改進超音速燃燒室結構的一種思路。
  10. Laccase being catalyzer, the degradation mechanism of 2, 4 - dichlorophenol, 4 - chlorophenol and 2 - chlorophenol is studied. the effects of reaction time, ph, temperature, concentration of chlorophenols and laccase on the removal of chlorophenols are discussed in detail, as well as the optimum reaction condition

    採用漆酶為催化劑，研究2 ， 4二氯酚4氯酚和2氯酚的催化降解機理，探討了反應時間ph值反應溫度氯酚濃度以及漆酶濃度對其降解效果的影響和最適降解條件。
  11. The body usts itself to change of temperature

    身體能自行調節以適應溫度的變化
  12. The body quickly adjusts itself to changes of temperature

    身體能很快自行調節以適應溫度的變化。
  13. The body quickly adjusts itself to changes of （ in ） temperature

    身體能很快地自行調節以適應溫度的變化。
  14. " there is little to no evidence that corals can adapt fast enough to match even the lower projected temperature rise, " said the report

    報告中還說： 「目前沒有證據表明，珊瑚能夠盡快適應溫度的上升，即使預期的上升幅度比實際情況偏低。 」
  15. Finally, stc structure is used to form a composite neural networks adaptive control system of temperature and ga is also applied to train nn controller

    最後，應用自校正控制結構組成復合神經網路自適應溫度控制系統，並對神經網路控制器進行了訓練。
  16. Is characterized by colour digital display with 4 probes, ultrasonic induction, accuratedetection and entering back action, automatic start of anto - collision indication system, digtal display with location, perspective of barriers position and easy installation, which improves substantially the car s practicability, that is it is not disturbed in rain ang nighe, performing its advantages for it s against the disturbance of the strong electromagnetic waves. it is applied to the temperature in the range of - 40 85. it is also characterized by the three - grade dulcet for foretelling, colour digital indication, anti - vibration protection device, durable damp - proof treatment, inserting installation, original configuration, beautiful appearance and firmness. it also adopts anti mal alarm technology. it is specially produced, and its quality is ensured

    數碼四探頭彩色顯示超聲波感應，偵測準確進入倒檔，自動開啟防撞提示系統數碼加方位顯示，效果能透視障礙物位置安裝容易，大大提高原車實用性能不受雨天黑夜等影響，盡顯優勢抗強電磁波干擾適應溫度寬40 85三級悅耳預
  17. The mlps method was simple process, it could react in room temperature. the method was very suitable for industrial production of superfine powder

    該法操作簡單，反應溫度低，產品粒度分佈均勻，適用面廣，適合工業化生產。
  18. Hydrothermal synthesis is an effective route for the synthesis of transition metal vanadium oxide. tubular vanadium oxide can be synthesized by adjusting the ph of reaction system, regulating the ratio of reactants and controlling the reaction temperature

    通過合理的調節反應物配比、調節體系的ph值、選擇合適的反應溫度，可以得到具有管狀結構的釩酸鹽晶體。
  19. The structures of these prepolymers were characterized by fourier transform infrared ( ftir ) spectra. some influencing factors such as operation fashion, reaction temperature and catalyst on synthetic reactions were studied. through some repeated experiment, the optimum conditions of synthetic reactions were got

    對影響合成反應的諸多因素如加料方式、原料配比、反應溫度、催化劑、阻聚劑等方面進行了研究，分別得到了適宜的合成條件，經過大量重復性實驗，驗證了這些合成條件的可靠性。
  20. In the section of non - pressing sintered, the influence of different raw material system and sintered temperature on the phase composition of the material were studied. and two conclusions were achieved. the one is that it is good for phase composition design and control because the final phase composition of the material fabricated by ti, sic and c raw material system is comparatively stable

    在無壓燒結階段，研究了原料體系與工藝制度對材料物相組成的影響，結果表明使用ti 、 sic 、 c的原料體系得到的材料最終物相組成比較穩定，有利於進行材料組成設計與控制； 1500得到的材料中的雜質相含量較少，是比較合適的反應溫度。
分享友人
分享到 Line

分享到臉書