顯式數值法 的英文怎麼說

中文拼音 [xiǎnshìshǔzhífǎ]
顯式數值法 英文
explicit numerical technique
  • 顯 : Ⅰ形容詞1 （明顯） apparent; obvious; noticeable; evident 2 （有名聲有權勢的） illustrious and inf...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 數值 : numerical value; numerial number; figure; magnitude; value數值表 numerical tabular; 數值天氣預報 ...
  1. Simulation of penetration test of armoured plate is presented by explicit dynamics algorithm

    摘要採用顯式動力學演算法對裝甲材料侵徹試驗的過程進行數值模擬研究。
  2. And the explicit finite difference method, the combining method of the central difference method and newmark s constant average acceleration method, and the transmitting boundary are used. by comparing the acceleration determined by the several methods of the displacements or velocities, a computing method of acceleration employed the one side difference of velocity is more practicality in this research. corresponding to normal incidence of the body waves, p waves or svwaves, and rayleigh surface waves, two two - dimensional finite difference programs are compiled to compu te the dynamic response of two - phase media

    以土力學模型為基礎，利用以土骨架和孔隙流體的四個位移為基本未知量的數值方法去模擬二維飽水介質中的地震波傳播，採用了顯式差分方法（中心差分法和newmark常平均加速度法結合）和透射邊界，通過比較利用幾種差分格式求解的加速度結果，發現一種用速度單邊差分求解加速度的方法在本文研究中較為實用，分別編制了體波（ p波或sv波） 、 rayleigh面波輸入時求解兩相介質動力響應的兩個二維數值分析程序。
  3. Theoretical analysis and numer - ical experiments show that bdf method of order two is indeed superior to the commonly used backward euler method and crank - nicolson scheme

    理論分析和數值試驗表明該方法明顯優于以往常用的向後euler法及grank - nicolson格式。
  4. The assimilation scheme uses a blending approach based on optimal linear interpolation. the improvement is 45 % for the phase - lag of s2 after assimilating the altimetric data of the crossover points, while the correction for the diurnal constituents is not so good as for semidiurnal constituents

    利用基於最優插值法的混合法將交叉點的調和常數同化到動力模式中，同化后s _ 2分潮的遲角精度改進最大，可以改進45 ，結果顯示高度計資料的分析結果對模式結果的精度影響很大。
  5. The theoretic calculating method of the maximum and the minimum water level in the differential surge tank has been derived firstly. also the explicit method of calculating surges in the differential surge tank has been deduced firstly by use of thaler series expansion. the calculating method of section of the well and the effective impedance hole in the surge tank has been gived

    根據差動式調壓室的基本微分方程，首次推導出了差動式調壓室涌浪幅值的理論計算公式；並同樣利用泰勒級數展開方法推導出了差動式調壓室水位波動的顯式計算式；導出了差動式調壓室大井面積和有效阻抗孔面積的計算方法。
  6. As an example, the implementation of the laplace equation with the gridless method has been presented at first and the resulting large scale matrix equations are solved by gmres algorithm. the numerical simulations of the flows over a cylinder are tested successfully with clouds of different scales, which shows the " cloud " effects on the computational accuracy

    本文先以代表定常不可壓位勢繞流的laplace方程為例，研究了laplace方程的無網格離散形式，並運用gmres高效演算法對其快速求解，數值模擬了典型的圓柱繞流；並通過不同點雲尺度的數值模擬，顯示出點雲尺度對計算精度的影響。
  7. In this paper, the upwind scheme and the central scheme are presented for solving 3 - d n - s equations using the cell - center finite volume spatial discretization and four - stage runge - kutta time stepping scheme, with standard convergence acceleration techniques such as local time stepping and implicit residual smoothing

    在n - s方程的數值計算上，採用了中心差分格式和迎風格式，用格心格式的有限體積法進行了空間離散，用四步龍格?庫塔法作顯式時間推進，並採用了當地時間步長和隱式殘差光順等加速收斂措施。
  8. To overcome the disadvantages of pseudo - compressibility algorithm, four - order artificial dissipation term is added to the right of the differential equation, and the recommended formula is offered for the choice of the artificial dissipation coefficient

    為了克服人工可壓縮方法可能帶來的數值振蕩，本文在離散方程的右端顯式添加四階人工耗散項，並就人工耗散系數的選取給出了推薦公式。
  9. In this paper the response surface method ( rsm ) is introduced into the structure optimization of linear fire work departing installation, which make the target fuction explicit, adopt the big finite element procedure to numerically simulate the departing process of the fire work departing installation instead of the expensive substance experiment, establish reasonable optimization model and resolve it, the final result is satisfied, and analyse the question presented during optimization process in detail

    本文把響應面方法引入到線性火工分離裝置的結構優化中，使得優化模型中的目標函數顯式化，採用大型有限元軟體對線性火工分離裝置的分離解鎖過程進行數值模擬，代替了代價昂貴的實際試驗，建立了科學合理的優化模型並求解，最終得到令人滿意的優化結果，並對優化過程中出現的問題進行了細致的分析。
  10. The explicit finite element method ( fem ) based on the varying time - step was selected to analyse the dynamic roll - pass process ; the nodes on the leading face of the steady - state elements set was extracted and projected onto a plane to give the required mesh, also called the origin mesh ; the implicit fem was selected to analyses the inter - pass transient thermal process ; a geometric part from the mesh was generated and meshed by using the quadrilateral elements, a heat transfer analysis was selected to transfer the node temperature data ; a new model was created by using hexahedral elements, mapping the node temperature and the equivalent plastic strain on the integration points

    利用基於變步長中心差分格式的顯式積分方法分析瞬態軋制過程；提取穩態單元集節點形成截面網格；利用隱式積分方法分析軋制道次間隙瞬態溫度場；對型鋼斷面進行平面四邊形網格劃分並映射節點溫度數據；利用六面體單元構建有限元分析模型，映射單元節點的溫度、積分點的等效塑性應變，進行數值分析。
  11. ( l ) the three - dimensional equations for tidal flow are derived from the navier - stokes equations based on some assumptions. the model is based on the vincenzo casulli method, and semi - implicit finite difference scheme has been used

    （ 1 ）從navier - stokes方程上經過假設和簡化得到的三維潮流控制方程，以vincenzocasulli法，採用半顯半隱差分格式，建立了一個三維潮流數值模型。
  12. Displays numeric values in scientific exponential format

    以科學記數法（指數）格式顯示數值。
  13. The final results obtained in this paper contained that the optimal interpolation scheme highlighted by the covariance that the correlation between different time and the correlation between different place being considered ; that the simplification of kalman filter with the singular - value decomposition ( svd ) and the direct construction of state transition matrix pfeceded with " inverse vector expression " ; and that the analysis of t / p data and its blending with theoretical model

    這些成果包括：建立考慮了時間相關的方差矩陣和時空相關的最優插值演算法；對卡爾曼濾波演算法進行了svd簡化以及建立了顯式的狀態轉移矩陣；將t p實時衛星數據進行調和分析並與數值模型進行同化處理。
  14. After that in chapter four, a axisymmetric hybrid stress finite element for piezoelectric media is presented on the optimization condition for the coupling of electrical and elasticity. it ' s practicable and rational in the numerical example. in the fifth chapter, we study the p - version hybrid stress fem

    本文還研究了基於升階譜的雜交應力元方法，建立了一系列p 5的高階雜交應力單元列式，數值計算結果顯示採用正確的高斯積分，將使得本方法切實可行，同時兼有升階譜和雜交元的優勢。
  15. Three finite - difference methods, i. e., stagger grid, implicit and explicit algorithms, are analyzed in detail. multi - grid algorithm is firstly introduced in elastic wave simulation, to solve for the stability problem inherent in stagger grid and implicit algorithm, also for the efficiency problem inherent in explicit algorithm, and the precision, stability and efficiency for simulation of elastic wave arc increased by multi - grid method. phase - delay method is provided to effectively absorb boundary reflection and increase efficiency for wave motion simulation, based on phase delay and amplitude decaying features along wave propagation

    在水平分層介質接收函數的波形反演研究的基礎上，本文系統闡述了非均勻介質中彈性波傳播數值模擬常用的三種有限差分方法：顯式差分、隱式差分和交錯網格法，首次將多重網格演算法應用於彈性波方程的數值模擬問題，克服了交錯網格法和顯式差分法穩定性差，以及隱式差分法計算效率低的缺點，大大提高了彈性波數值模擬的精度、穩定性和計算效率。
  16. Numerical fluxes considered in the explicit portion of the algorithm were evaluated by an implicit high - order compact scheme to augment stability. meanwhile, an implicit high - order compact numerical filter was used

    顯式一邊的空間導數採用具有較高精度和良好數值穩定性的隱式高階緊致差分格式，同時採用適于低馬赫數流動計算的隱式高階數值過濾方法。
  17. By means of the precise integration method with lagrangian interpolation the trajectory of the shaft center, the poincare mapping and the bifurcation graphs are numerically given. the results predicted by the floquet theory are checked and the long - term dynamic behavior of the system is predicted. it is shown that the system has rich nonlinear behaviors at some m combination of the four parameters, for examples, multi - frequency subharmonic resonance, as well as chaos phenomenon from doubling bifurcation and twice hopf bifurcation

    通過lagrange插值精細積分法數值給出系統的軸心軌跡圖、 poincar映射圖、分叉圖，檢驗floquet理論預測結果並預測系統的長期性態，顯示系統在四個參數組合的某些范圍內具有豐富的非線性特性，還存在多形式次諧波解，以及由倍周期分叉、二次hopf分叉通往混沌的現象。
  18. L - stable explicit one - step method for solving stiff ordinary differential equation and its numerical experiments

    穩定的顯式單步法及數值試驗
  19. In this thesis a numerical model to solve the planear 2 - d depth - integrated flow ( dif ) has been established with irregular body - fitted mesh finite volume method and explicit maccormack predictor - corrector method and applied to the study of damming caused by a bridge pier under 14 working conditions varied with the combination of different pier shape. flow rate and contraction ratio

    本論文採用非規則貼體網格有限體積法和顯式maccormack預測-校正法求解平面二維水深積分方程，對明渠水流運動的數值模擬方法進行了研究，並且應用該數值模型計算了14種不同的橋墩體型、來流、收縮比的組合工況下的橋墩壅水問題。
  20. In this thesis, the unloading region of a typical cross section of shiplock slope of tcp is given, that is 15570 according toin - situ test and geological survey. considering the effects of excavation unloading, numerical analysis for shiplock slope is made by fem and flag. using the theory and software described in this thesis, the excavation analog and the stability analysis of the typical cross section of the three gorges shiplock high slope has been carried out

    本文選取三峽工程永久船閘邊坡的典型剖面15570剖面，根據現場試驗和地質調查確定的卸荷范圍，考慮卸荷帶巖體力學參數隨開挖過程而變化，採用二維彈塑性有限元法、二維彈塑性顯式有限差分法進行了邊坡施工開挖數值模擬。
分享友人
分享到 Line

分享到臉書