顯影液配方 的英文怎麼說

中文拼音 [xiǎnyǐngyèpèifāng]
顯影液配方 英文
developer formula
  • 顯 : Ⅰ形容詞1 （明顯） apparent; obvious; noticeable; evident 2 （有名聲有權勢的） illustrious and inf...
  • 影 : Ⅰ名詞1 （物體擋住光線后映出的形象） shadow 2 （鏡中、水面等反映出來的物體形象） reflection; image...
  • 液 : 名詞（液體） liquid; fluid; juice
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 顯影 : [攝影學] develop
  • 配方 : 1. （配藥） make up a prescription; fill a prescription2. （配製方法） formula; recipe; ingredient
  1. In this paper, the effects of fly ash, cement, lime, fine sands, foam agent, w / c ratio and additional agent on foamed concrete were studied by experiments, the best combination ratio of fly ash foamed concrete whose density varies from 551kg / m3 to 650kg / m3 was obtained through orthogonal test design, the foam agent quantity and the fly ash quantity effect the fly ash foamed concrete greatly, so the author selected them as independents to establish duality linear regression equations, the equations were quite ideal through the test of model summary r. moreover, the author also did some experiments about the water resistance of magnesium oxychloride cement fly ash foamed concrete, the outcome showed that phosphoric acid has good effect on water resistance, and its appropriate quantity was found

    本文通過試驗研究了粉煤灰、水泥、石灰、細砂、發泡液、水灰比及外加劑對粉煤灰發泡混凝土性能的影響，採用正交設計試驗方法得出了600級粉煤灰發泡混凝土的最佳配合比，同時發現發泡液和粉煤灰摻量對發泡混凝土的影響最為顯著，因此，以二者為自變量建立了二元線性回歸方程，通過全相關系數的檢驗發現方程較為理想。此外，還對氯氧鎂水泥基粉煤灰發泡混凝土的耐水性進行了相關實驗，發現磷酸有較好的耐水性效果，同時找到了其合適的摻量范圍。
  2. The pretreatment, effect of bath compositions and operation conditions such as temperature, currenty and time on compactness of the zinc and cu / ni / cr coatings have been investigated. the relationship of operation conditions to thickness of the coatings was studied by weight method. the specimens have been pickled in nacl or sulfate acid solution to evaluate the porosity of the coating

    研究了鎂合金電鍍前處理工藝，電鍍鋅、電鍍銅/鎳/鉻工藝配方及其施鍍溫度、電流密度和時間對鍍層緻密性的影響;採用稱重法研究施鍍工藝與鍍層厚度的關系，利用nacl溶液和硫酸溶液浸泡試樣來考察鍍層孔隙率，採用劃痕試驗和熱震試驗檢驗鍍層的結合力，採用金相顯微鏡和掃描電子顯微鏡觀察鍍層表面形貌。
分享友人
分享到 Line

分享到臉書