剩餘校正 的英文怎麼說

中文拼音 [shèngyújiàozhēng]
剩餘校正 英文
residual correction
  • 剩 : Ⅰ動詞（剩餘） be left over; remain Ⅱ形容詞（剩餘的） surplus; remnant
  • 餘 : Ⅰ同「余」Ⅰ-Ⅳ1. Ⅱ名詞（姓氏） a surname
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 剩餘 : overplus
  • 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
  1. According to these accomplishments, several techniques are expounded emphatically in this paper, including 3d refraction statics, coherent noise suppression by prestack wave field separating ( prestack fx noise attenuation ), 3d prestack multiple domain random noise attenuation, multiples attenuation, nmo of unsymmetrical hyperbola, dynamic replacement of wave equation, surface - inconsistent residual static, super bin stacking, poststack depth migration and prestack depth migration. all the techniques have been applied in seismic processing of 2d, 3d and wide - line profiling and obtained good results

    本文根據項目組研究成果，重點閘述了三維折射波靜校正技術，疊前波場分離相干噪音壓制方法（疊前fx去噪） ，疊前三維多域隨機噪音衰減技術，多次波衰減技術，非對稱雙曲線動校正技術，波動方程動態替換技術，非地表一致性的剩餘時差靜校正技術，超面元迭加處理技術，疊后深度偏移處理，疊前深度偏移處理等。
  2. The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on

    主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。
  3. Based on these, this paper puts forward a new method of measuring residual capacity of the electric vehicles traction battery. namely using ampere - hour, open - voltage and the adaptive neural fuzzy inference system ( an fis ) method, correct the actual capacity to get the exact result

    在此基礎上提出了一種新的監測蓄電池剩餘容量的方法，即結合安時法、開路電壓法和自適應模糊推理法，對蓄電池的實際容量進行校正，達到準確預測電池的剩餘容量的目的。
  4. The program of delphi can call the dynamic link library ( dll ) which is programmed beforehand. it can on - line estimate and correct soc in time. it can advance the precision of the estimation of brc and the capability of the energy management system, then satisfies the practical need of electric vehicles

    並且，在對電池的荷電狀態的預測採用了delphi和matlab混合編程的方法，在delphi中調用事先編好的動態連接庫（ dll ） ，能實時在線的對電池的荷電狀態進行估計和校正，提高了電池剩餘容量預測的精度，從而提高能量管理系統的性能，滿足電動汽車的實用需求。
  5. Doing the further research on the division frequency stack on the foundation of study of predecessor, at first the residual moveout correction is done to the seismic record, make the phase axle regularity, doing foundation for the same phase stack ; then carried on division scale processing by wavelet transform ; spectrum whitening is done to each scale, the high and low frequency band need to do prolongs, the middle frequency bands only increase the value of the frequency spectrum ; several kinds of methods that estimate the value of signal - noise ratio has been studied further, and summarize their advantage and disadvantage as well as the scope of application ; the seismic record after spectrum whitening is stacked by weighting with the value of the signal - noise ratio ; then estimate the value of signal - noise ratio which is each scale section after stacking, the scale that the signal - noise ratio is big is assigned big weighting, otherwise, the scale that signal - noise ratio value is small is assigned small weight ing, and carried on weighted reconstruct to each scale section

    本文在前人研究的基礎上，在分頻疊加方面做了進一步的研究。首先對地震記錄進行剩餘時差校正，校齊同相軸，為同相疊加做好基礎工作；然後對地震記錄用小波變換的方法進行分尺度處理；對各個尺度分別做譜白化，對于高、低頻段需要做頻帶延拓，中間頻段僅提升頻譜值；對于幾種信噪比定量估計的方法進行了深入的研究，並且總結了它們的優缺點以及適用范圍；對譜白化后的地震記錄用信噪比估計值作為加權系數進行加權疊加；對于各尺度的疊加剖面也進行信噪比估計，對于信噪比大的尺度給予大的加權系數，反之，信噪比值小的尺度給予小的加權系數，對各尺度疊加剖面進行加權重構。
  6. In view of characteristics of seismic data of gobi - sand dune areas, this paper, through various data - processing means such as quality control, high - pass filltering, dip angle filltering, field static correction, surface consistency deconvolution, precise velocity analysis, denoising before stack, multiple iterative operation of residual static correction, denoising after stack and modification after shift, has raised the data quality of seismic profiles in low signal - to - noise ratio areas and managed to form the seismic data - processing technique for such complex areas as gobi, foreland and dune

    摘要針對戈壁、沙丘地區地震資料的特點，通過對原始資料進行質量控制、高通濾波、傾角濾波、野外靜校正、地表一致性反褶積、精細速度分析、疊前去噪、剩餘靜校正多次迭代、疊後去噪和偏後修飾等處理，提高了低信噪比地區地震剖面的資料質量，摸索出了一套戈壁、山前、沙丘等復雜地區地震資料處理技術。
  7. In this dissertation, the method of field primary static correction and refraction statics are applied together is given firstly, avoid the fault of using refraction static alone ; compile the program of calculating static values, studying the automatic residual statics multiple iterating technique. practical data processing shows that the static correction processing flow given in this dissertation is feasible

    本文首次使用了野外靜校正和折射波靜校正聯合處理的方法，避免了折射波靜校正孤立使用的缺點，編制了計算低降速帶靜校正量的應用程序，研究了自動剩餘靜校正的多次迭代技術，在塔里木地區地震資料處理應用中，見到了明顯效果。
  8. We describe three static methods : field primary static correction, refraction statics and automatic residual statics, and then introduce the principle of the three static methods. second, the dissertation gives the method of elevation statics, calculating static values by using minor refraction data, first - break pickup method and residual technique

    其次，重點闡述了1 、野外靜校正方法中地面高程校正的過程、利用小折射測量數據計算低降速帶靜校正量的演算法； 2 、應用現有的折射波靜校正軟體進行初至拾取及靜校正量計算的操作要領； 3 、自動剩餘靜校正多次迭代技術。
  9. Based on the simple understanding of normal seismic processing, this paper has carried out deep research on the problems of deep prospecting in seismic data processing, such as s / n ( signal to noise ratio ), velocity analysis and residual nmo of unsymmetrical hyperbola, stacking and imaging of complex rays and migration arc. until now tens of accomplishments have been achieved

    在簡單了解地震資料常規處理的基礎上，本文針對當前深層資料的問題，緊緊圍繞著深層地震數據處理技術研究需要解決的重點問題，即信噪比問題、非對稱雙曲線的速度分析與剩餘動校正時差問題、復雜射線的迭加及偏移成像問題和偏移畫弧問題等，進行了深入的研究工作，目前已完成十多個成果。
  10. An improved simulated annealing algorithm and its application to seismic remaining static correction

    模擬退火方法的改進及其在地震剩餘靜校正中的應用
  11. According to the distinction of scanning and staring ir imaging systems, researches and simulations on two - point nuc ( tpnuc ) are made respectively. as most of algorithms presume thermal imaging sensors " response is linear, they cannot avoid the effect of response nonlinearity, leaving a residual special noise

    一般溫度定標校正法都建立在探測元的響應是線性定常的假設之上，故無法避免響應非線性的影響，校正後仍存在剩餘非均勻性。
  12. Automatic residual statics

    自動剩餘靜校正
分享友人
分享到 Line

分享到臉書