煙道廢氣 的英文怎麼說

中文拼音 [yāndàofèiqì]
煙道廢氣 英文
stack gases
  • 煙 : Ⅰ名詞1 （物質燃燒時產生的氣體） smoke 2 （像煙的東西） mist; vapour 3 （煙草） tobacco 4 （紙煙、...
  • 道 : Ⅰ名詞（道路） road; way; route; path 2 （水流通過的途徑） channel; course 3 （方向; 方法; 道理） ...
  • 廢 : Ⅰ動詞（不再使用; 不再繼續） abandon; abolish; abrogate; discard; give up Ⅱ形容詞1 （沒用的; 失去...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  1. An integrated process of wastewater treatment and utilization is presented. the process is made up of heating the soft water of room temperature by high temperature printing and dyeing wastewater via heat exchangers, reusing the low level base decrement wastewater of water washing for dust control and desulphurizing of stack gas and anaeration - aeration biological treatment of printing and dyeing wastewater. this process has fair economical benefit on the principle of so called waste control by waste itself. this might be an ideal process for printing and dyeing wastewater treatment and disposal, the effluent of this process is quite enough to meet the requirement of urban sewer collector. additionally also many advantages are attractive such as the complete return of biological sludge to digestion, no chemicals dosage and free of secondary pollution

    介紹了高溫印染廢水通過熱交換加熱常溫軟水、低濃度堿減量水洗廢水用於煙道氣除塵脫硫、厭氧-好氧處理一般印染廢水等印染廢水綜合處理技術，該技術具有較好的經濟效益，達到了以廢治廢的目的，生物污泥全部迴流硝化，不加任何藥劑，無二次污染，處理后水質達到城市截污管網標準要求，是一種較為理想的印染廢水處理工藝。
  2. For treating industrial emission of chemical engineering, kiln - firing industry, electroplating, metal surface treatment, flue gas, boiler and furnace

    用於化工業、窯業、電鍍、金屬表面處理、煙道廢氣、鍋爐、燃燒爐等工業廢氣。
  3. All our flights are non - smoking, so the level of airborne pollutants is far lower than on most city streets

    我們所有航班均屬非吸煙客機，因此機艙空氣所含的有害廢棄物量應較一般繁盛街道所錄取的為低。
  4. Adopting the direct vent system could emit smoke to outdoor, you can save the cost of the installation of pipeline integrity of the chimney

    採用把廢氣排到室外的水平排煙系統，您可節省安裝完整煙囪管道的費用。
  5. The technology process : the waste, through operation stand, to be rationed into the standing majorcombustion room, being ignited by the ignition - burningmachine, upon the principal of burningthree t, fully burned in the major combustion room （ 800 - 1000 ). the remaining waste gas afterburning via flue goes into secondary combustion room for further high temperature oxidizingcombustion. the gas flow after the secondary combustion goes into the highly effective cyclonedust remover, removing the bigger granule of dust, flowing into rapid - cooling spay and washing equipment to absorb acid gas

    廢棄物經操作臺連續定量投入立式爐本全燃燒室，由點火文空燃燒機自動點火，根據三t原則在爐本體燃燒室（ 800 - 1000 ）以充分燃燒，焚燒后產生的殘余廢氣經煙道進入二次燃燒室再經高溫（ 1100 - 1200 ）氧化焚燒，經二次焚燒后的氣體進入高效旋風除塵器，除去顆粒較大的粉塵后，進入急冷塔噴淋洗滌裝置吸收酸性氣體。
  6. Methods for determination of hydrogen chloride in flue gas

    煙道廢氣中氯化氫含量的測定方法
  7. Automated measuring systems and analyzers for nitrogen oxides in flue gas

    煙道廢氣中氧化氮的自動測量系統和分析儀
  8. Automated measuring systems and analyzers for sulfur dioxide in flue gas

    煙道廢氣中二氧化硫的自動測量系統和分析儀
  9. Air pollution. flue gases. determination of the smoke spot number bacharach method

    空氣污染.煙道廢氣.煙霧點數字的測定bacharach法
  10. Automated measuring systems for sulfur dioxide in flue gas using non - extractive methods

    用非萃取法測定煙道廢氣中二氧化硫的自動測量系統
  11. Automated measuring systems for oxides of nitrogen in flue gas using non - extractive methods

    用非萃取法測定煙道廢氣中氮的氧化物的自動測量系統
  12. Standard test methods for heat resistance of polymer linings for flue gas desulfurization systems

    煙道廢氣脫硫系統聚合物襯里耐性能熱標準試驗方法
  13. Flanges, bolting and gaskets for exhaust gas, piping for diesel engines and boiler uptakes

    柴油機和鍋爐上風煙道用廢氣管道法蘭螺栓和密封墊
分享友人
分享到 Line

分享到臉書