相對生長 的英文怎麼說

中文拼音 [xiāngduìshēngzhǎng]
相對生長 英文
allometry
  • : 相Ⅰ名詞1 (相貌; 外貌) looks; appearance 2 (坐、立等的姿態) bearing; posture 3 [物理學] (相位...
  • : Ⅰ動詞1 (回答) answer; reply 2 (對待; 對付) treat; cope with; counter 3 (朝; 向; 面對) be tr...
  • : Ⅰ動詞1 (生育; 生殖) give birth to; bear 2 (出生) be born 3 (生長) grow 4 (生存; 活) live;...
  • : 長Ⅰ形容詞1 (年紀較大) older; elder; senior 2 (排行最大) eldest; oldest Ⅱ名詞(領導人) chief;...
  • 相對 : 1. (面對面) opposite; face to face 2. (非絕對的) relative 3. (比較的) relatively; comparatively
  • 生長 : grow; grow up; ascent; merisis; build up; auxesis; increment; overgrowth; gain; burgeon; bourgeon...
  1. These seedlots can be denoted by their relative growth rates.

    這些種子組可根據其相對生長速度進行編號表示。
  2. Root elongation in hydroponic solutions showed that the transgenic plant have increased al tolerance. the transgenic plants have higher relative root elongation under 20umol / l al stress than untransformed control

    相對生長量實驗證明轉基因植株具有一定的鋁耐受性,在20 mol l的al ~ ( 3 + )濃度下比照具有更高的根相對生長量。
  3. It is found that different genotypes of maize was markedly different in seed growing and filling speed, the varieties which had lower and steadier rate of average growth and earlier appeared max filling - speed could realize adversity resistance and good harvest

    不同基因型之間存在顯著差異,籽粒相對生長率低而穩定、最大灌裝速度出現早的品種能夠抗逆高產。
  4. After correlation analysis of the raw of growth and development, dry matter accumulation, rate of filling, hulk density and yield, it concluded that the best sowing - time was on 30th in april and the best harvest - time was on 5th in october

    通過發育規律及干物質積累、灌溉速率、容重、產量進行關分析,確定4月30日左右為吉油1號玉米的最佳播種期, 10月5日左右為最佳收獲期。
  5. This incubation adjustment of parents makes the synchrony in hatching and the hatching intervals of nestlings shorter than the laying intervals of eggs. this phenomenon was perhaps resulted from the incubating behavior difference of parents in laying time and incubating time. the research also found that the growth rate and survival rate in the latest hatched nestlings in little egret were lower than the earlier hatched ones

    卵的孵化時間與產卵順序呈負關性,先產的卵比后產的卵所需孵化時間,此現象產是由於親鳥在產卵期和產卵后的孵化行為不一致造成的,這種孵化調節使同一窩雛鳥孵出時間具有集中的趨勢,雛鳥出殼的時間間隔比產卵的時間間隔短;另一方面,在白鷺雛鳥的過程中,最晚出殼的雛鳥水平和成活率明顯落後于早出殼的雛鳥,而池鷺由於窩卵數和窩雛數為5的數量較少,雛鳥均衡。
  6. Only later were the tissue isolates reduced to their minimum size to produce the maximum relative growth rates.

    只有到后來,離體組織減少到它們的最小體積而產最大的相對生長速率。
  7. 6. through analysis and discuss of the precipitation mechanism of cr phase, it can be deduced that primary ( cr ) phase exhibits petal shape or triangular due to solute and heat flow in local fluid

    6通過( cr )析出機制的初步分析和探討,認為由於熔體局部的溶質和熱流波動,初形態有花瓣狀或三棱形。
  8. Abstract : based on the ahievement of epitaxial growth in several perovskite oxide films, we discuss the importance of substrate temperature ( ts ) and substrate material in the epitaxial growth of perovskite oxide thin films. influences of ts on growth orientation and epitaxial threshold temperature were observed. the results indicate that during the growth of the oxide films the phase formation and growth dynamics should be taken into consideration. the threshold temperature for epitaxial growth depends on the substrate materials. this demonstrates the influence of substrate material on the initial nucleation and epitaxial growth

    文摘:在成功地外延超導、鐵電、鐵磁等多種性質的鈣鈦礦結構氧化物薄膜的基礎上,討論影響氧化物薄膜外延的一些因素.考慮到形成和薄膜動力學,在利用脈沖激光淀積法外延氧化物薄膜中襯底溫度是十分重要的工藝參數.襯底溫度薄膜的取向都有影響.考慮到薄膜是首先在襯底表面成核、成.因此襯底材料晶格的影響是不容忽視的.觀察到襯底材料薄膜外延溫度的影響.在適當的工藝條件下,利用低溫三步法工藝制備得到有很強織構的外延薄膜.這突出表明界面層的互作用鈣鈦礦結構薄膜的取向有著當大的影響
  9. The main parameters influencing relative elongate on are analysed by research on experiment of size prediction of thick - walled tube without mandrel by open - die cold extrusion, and their curves of changing rule are given, which applies reference in order to direct practical production

    本文通過厚壁管件無芯棒開式冷擠壓尺寸預測的實驗研究,分析了影響量的犯要參數,找出了它們與量之間的變化規律曲線,為指導實際產提供了依據。
  10. This article begins with a brief overview of the discovery of glucagon and the contributions that somatostatin and a sensitive and selective assay for pancreatic ( vs. gut ) glucagon made to understanding the physiological and pathophysiological roles of glucagon

    文章的開始部分簡單回顧了胰高糖素的發現過程,以及其抑素的作用和一項具有高敏感性和特異性的檢驗胰腺中的胰高糖素的方法(與腸道內的檢測法比) ,來幫助人們理解胰高糖素的理和病理理作用。
  11. In this paper, pmnt, pznt single crystals in the vicinity of the morphotropic phase boundary were obtained by high - temperature solution technique. the growth, structure and phase stability of single crystals were studied. the results are shown as follows : 1

    本論文採用高溫熔液法技術,用高溫熔液法弛豫鐵電單晶材料工藝進行了研究,成功地制備出準同型界附近的pmnt 、 pznt單晶材料,分析了晶體形成、晶體結構及其結構穩定性,並機理作了初步探索,主要研究結論如下: 1
  12. Mr. li just participated worked, because frequently glances over the pornographic website, is stirred by the on - line pornographic content the spring tide to organ blister measles, are life - long cannot cure.

    「安立克」的作用機理理論是:細胞和病毒的存時間並不久,機體細胞和病毒細胞的分裂再過程一直在進行。
  13. The beginning of exponential growth phase for jsa10 was 8th day, with a rapid growth phase from 8th to 12th day followed by a slower growth phase from 14th to 18th day, then entered a senescence phase after 20th day

    Jsa25與jsa10比,周期較短,進入期提前2d ,增高峰期短,較快進入緩慢期,花色素苷的積累高峰也是在緩慢期。
  14. The main character of the overcompensation in tetraselmis tetrethele was those treated groups had a higher average relative growth rate, a more number of cells, a more biomass and a higher chlorophyll - a content than those of the control

    四列藻超補償的主要表現是:與照組比較,處理組藻的平均相對生長率提高,細胞數增多,葉綠素a含量提高,物量增高。
  15. The results showed that drought stress at flowering stage delayed the date of the max filling - speed ( dmfs ), and weakened the rate of average growth ( rag ) and the max filling - speed ( mfs ), and then shorten linear dry matter accumulation phase and leveling - off of dry matter accumulation phase

    結果表明:花期乾旱導致玉米最大灌槳速度出現時間推遲、籽粒相對生長率和最大灌裝速度減弱、干物質線性積累期和干物質穩定增期顯著縮短,乾旱結束后植株通過提高幹物質線性積累期的持續時間和干重,以彌補前期乾旱的損失。
  16. Through analyzing survival rate and correlative growth indeice of nursery stocks, application effect of multiple tree species using solid water was contrastively studied

    通過分析樹種成活率和指標,比研究固體水多樹種應用效果。
  17. An optimized cvi - pip process has been achieved, by which the c / sic composites with 2. 1 ig / cm3 high density and uniformity are fabricated in 200 hours. the microstructure and composition of pyrolytic carbon interphase and cvi - pip silicon carbide matrix in the c / sic composites are investigated with the help of polarization microscope, scanning electron microscope, and x - ray diffraction technique, etc. the structure characteristic of pyrolytic carbon interphase and cvi - pip silicon carbide matrix, and effects of cvi - pip process on it are summarized and discussed. by growth course and feature of pyrolytic carbon interphase and cvi - pip silicon carbide matrix analyzed, a whole - course densification mechanism of lamellar - growth - pattern is proposed to explain the densification phenomenon, which makes a systematic understanding on the feature of pyrolytic carbon interphase and cvi - pip silicon carbide matrix, and the multiple stitching interface binding

    根據熱解碳中間、 cvi - pip系sic基體的組織構成與外貌特徵,通過熱解碳中間、 cvi - pip系sic基體過程和特徵進行分析,提出了基於層模式的緻密化過程理論,解釋了熱解碳中間、 cvi - pip系sic基體以及釘扎誘導結構多重界面的形成: ( 1 )在1150下, cvi - sic亞基體遵從「過飽和?凝聚?融合」機理沉積,以8f型? sic為主,同時還會有少量4h型? sic ,無游離si和游離c存在; ( 2 ) pip - sic亞基體由非晶態sic以及彌散分佈的- sic微晶、 si - o - c和游離c組成; ( 3 )熱解碳中間與碳纖維增強之間、 cvi - sic亞基體之間形成滲透釘扎結構過渡界面, pip - sic亞基體與摘要cvi一sic亞基體之間形成誘導結構過渡界面。
  18. This longer growth period involves higher risks of bone or joint cartilage disorders

    這個的成期給小崽骨骼和關節軟骨帶來風險, (及有可能)導致發育不良。
  19. In order to study these questions, we researched three topics in this paper mainly : 1. we prepared zno nanowires using chemical vapor deposition ( cvd ) method based vapor - liquid - solid ( vls ) mechanism. our object was getting arrayed and controllable growth of zno nanowires through integrating the controllable ability of vls mechanism and merits of cvd and controlling the technique conditions of preparation

    以上存在的問題,本文主要在以下三個方面進行了初步的探索: 1 .採用基於氣-液-固( vls )機理的化學氣沉積( cvd )法制備zno納米線,結合vls機理過程的控製作用以及cvd方法的優點,通過催化劑、源溫度、溫度和反應氣氛等工藝條件的控制,得到納米線的陣列化
  20. The length of mandible in male is longer than in female, and the length from posterior border of the mandibular condyle to the central section of m1 and to the under - minipeak of m3, the height of the mandibular branch is relative smaller in male than in female

    通過太行山獼猴下頜物力學、異速的研究表明,雄性下頜,與此有關的物力學特點是下頜髁后緣至m1近中側、下頜髁后緣至m3下次小尖和下頜支高等阻力臂減小,而下頜髁、下頜髁寬、下頜體高、下頜體寬、下頜聯合等變量則增強,使咀嚼力增加。
分享友人