磨蝕試驗機 的英文怎麼說

中文拼音 [móshíshìyànjī]
磨蝕試驗機 英文
abrader
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 機 : machineengine
  • 試驗 : trial; experiment; test
  1. Test method for abrasion resistance of organic coatings by air blast abrasive

    鼓風磨蝕試驗測定有機塗料耐磨性能試驗方法
  2. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  3. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  4. Standard test method for resistance to abrasion of resilient floor coverings using an abrader with a grit feed method

    用帶喂磨料的磨蝕測試機測定彈性地板覆蓋物耐磨性的標準試驗方法
  5. This paper unfolds engineering disposition and theoretical research of negative temperature high performance concrete ( nthpc ) with the damage of many factors motivation, the project background based on qing - zang railway engineering, which is one of four - emphasized engineering during the tenth five - plan. due to the difference of environment of construction and service between nthpc and ordinary concrete, and therefore durability of nthpc is required to higher level. at a first, nthpc must avoid frozen damage at early age and possess anti - freezing property at later period, in order to meet engineering practicable application need, and this are two emphasized and difficult problems, as for nthpc ; by means of mechanism analysis about deicing - agent ingredient and anti - freezing at early period, adopting composite technique routine of mineral addition + anti - freezing element + water - reducer4 - air - entraining + anti - erosion of steel component etc, based on orthogonal experimental approach, fd - 1 composite functional admixtu re was manufactured, which has more property and orientation on qing - zang railway

    負溫混凝土由於和普通混凝土在施工環境及服役環境上存在的差異，因此表現為比普通混凝土更為較高的耐久性要求；負溫混凝土首先要避免早期的凍害以及具備長期抗凍性能，才能夠滿足工程實際應用的要求，這也是負溫混凝土必須解決的兩大技術關鍵；通過對目前常用防凍劑組分作用機理的分析研究及混凝土早期防凍機理探討，採用礦物外加劑+防凍組分+高效減水劑+引氣+阻銹組分功能復合的技術路線，通過正交試驗設計復配了適應青藏鐵路工程要求的專用多功能復合型外加劑fd - 1 ；並在此基礎上配製不同等級負溫高性能混凝土，開展一系列包括硫酸鹽侵蝕、氯離子滲透、抗凍融循環、收縮及耐磨性等耐久性能研究；通過對fd - 1組分和摻量的調整，優化負溫混凝土在施工特性、力學指標和耐久性三個方面的兼容、協調性。
  6. Study on erosion - resistance of the flexible organic coating composite

    有機復合彈性塗層材料的抗磨蝕試驗研究
  7. In order to study the slurry erosion properties of the particle reinforced polyurethane composites, a slurry erosion test apparatus was designed and manufactured based on the considerations of comparison between the present slurry erosion apparatuses and cost factor. the slurry erosion test apparatus proved to stable and reliable through tests, and it can be applied to material selection and erosion mechanism research

    經過實驗驗證表明，該沖蝕磨損試驗機供漿穩定，磨損數據重現性較好，是較為可靠的研究漿體沖蝕磨損的試驗裝置，適合於進行耐磨材料對比選擇以及漿體沖蝕磨損機理的研究。
  8. A set of conventional processing methods of vanadium and vanadium alloy specimens, including mechanical polishing, mechanical chemical polishing, chemical etching as well as relevant techniques and experiences is introduced

    摘要介紹了一種釩及釩基合金金相試樣的常規制樣方法，即試樣的機械磨光，機械化學拋光，化學侵蝕等技術和經驗。
  9. The numerical simulation and experimental research made on the characteristics of the clearance cavitations in kaplan turbine are described herein ; in which the analysis mainly is concentrated on the characteristics of leakage - vortex caused by the flow of the clearance between blade tip and blade chamber, that occurs at the front - pressure side of the blade, and the intensity of the secondary - flow - vortex ; furthermore, the relationship in between the leakage - vortex, secondary flow vortex, cavitations and erosion are analyzed as well

    摘要對軸流轉槳式水輪機輪緣間隙流動及空化特性進行數值模擬和試驗研究，重點分析輪緣間隙流動在正面頭部泄漏流動所引起的泄漏渦帶、二次流動的漩渦強度和空化特性，以及泄漏渦帶旋轉、二次流動的漩渦與空蝕和磨損之間的關系。
  10. Until now, there have been a few reports on the damage of the water pumps caused by sand and water cavitation. by use of the test loop for solid and liquid two phases, under the condition of 3 % head drop, the damage location and relative degree of the sand and water cavitaiton occurred on the impeller were tested and researched. the result was, them, compared with the results under the condition that water cavitation occurred and no cavitation but only wear occurred. the differencts were analyzed. the analysis result can be used as the basis of the further research and the improvement of the impeller shape

    目前含沙水汽蝕對水泵損傷方面的報導甚少，本文利用固液兩相流試驗臺，對離心泵閉式葉輪在含沙水汽蝕時（ 3揚程下降點）的損傷部位和相對程度進行了試驗研究，並將此結果與清水介質發生汽蝕時的損傷情況[ 13 ]及含沙水無汽蝕情況下的磨損情況[ 7 ]相比較，對其差異進行了分析，為今後進一步探討葉輪損傷機理和葉型改進提供了實驗依據。
  11. Secondly, been generalized the failure data of electrical connectors from working and testing environment, electric contact failure, insulation failure, mechanical connection failure and other failure are four mainly failure modes of connectors, moreover, built the faulty - tree to analyze their reliability level. however, contact fault failure was the most prevalent mode of electrical connectors. under natural working and reserving conditions, the contact stress decreasing, fretting and surface film growing are mainly reasons to make electrical connector failure

    其次，通過對現場、試驗場電連接器的失效情況進行統計和分析，總結出電連接器的四種主要失效模式：電接觸失效、絕緣失效、機械連接失效和其他失效，並對電連接器進行了故障樹分析，指出電接觸失效是電連接器失效的主要形式，而在正常的工作條件下，造成電接觸失效，即決定電連接器工作壽命的主要原因是氧化膜層的生長、接觸對磨損以及磨損腐蝕物的堆積，而影響氧化膜層的生長、接觸對磨損以及磨損腐蝕物堆積的主要因素是環境振動和溫度應力，為電連接器進行失效機理分析奠定了基礎。
  12. In order to prolong the natural life of fracturing pump valve, this article do much basic research work on fracturing pump value. firstly, kinetic characteristics of fracturing pump valve are stated particularly and analysed. through stimulated experiment based on practical working conditions, the wearing disciplinarian and forms of impact particle wear about fracturing pump valve are researched by comparing it with pure impact wear and abrasive wear. furthermore, the wear mechanism of impact particle wear and particle erosion are analysed. in the end, by using the fenite element analyzing tool ansys, the distributing law of stress and strain of fracturing pump valve at the state of closing and during the process of impact are analysed carefully

    詳細闡述和分析了它的運動特性；根據其實際工況，通過模擬試驗，研究了壓裂泵閥沖擊磨料磨損的磨損規律和磨損形式，並且將其與純沖擊磨損、滑動磨料磨損進行了對比；分析了壓裂泵閥的沖擊磨料磨損、沖蝕磨損等磨損機理；藉助ansys有限元分析工具，對泵閥關閉狀態下和沖擊過程中的應力應變分佈規律進行了詳細分析。
  13. In this study, the resistance to high impact, corrosion and abrasive wear was determined for low carbon high alloy steel, and for comparison, the high manganese steel and the medium carbon alloy steel are also tested

    腐蝕磨損試驗機的轉速400轉分。在不同的介質（ ph 3 ）和不同的時間內，對低碳高合金鋼、高錳鋼和中碳合金鋼進行了沖擊腐蝕磨損性能的研究。
  14. Standard test method for abrasion resistance of organic coatings by the taber abraser

    用泰伯爾磨蝕機測定有機塗層耐磨性的標準試驗方法
  15. Methods of test for ancillary components for masonry - part 13 : determination of resistance to impact, abrasion and corrosion of organic coatings

    圬工輔助構件試驗方法.第13部分:有機塗層耐沖擊性耐磨性及耐腐蝕性的測定
分享友人
分享到 Line

分享到臉書