粘結介質 的英文怎麼說
中文拼音 [niánjiējièzhí]
粘結介質
英文
cementing agent-
Based on the effective medium hb resistivity models in laminated or dispersed shaly sands proposed by berg, the general effective medium hb resistivity model in laminated and dispersed shaly sands is established. in the derivation of the model we assume that clay - bound water fraction is included in total pores, clay - bound water and formation water have the same resistivity, and yet the difference of electrical properties between the two waters is incorporated into clay grain conductivity
本文首先基於berg提出的層狀泥質或分散泥質砂巖有效介質hb電阻率模型，並在總孔隙中考慮粘土結合水的體積，但不考慮粘土結合水與地層水導電性的差別，而將粘土結合水與地層水的導電性差別歸結到粘土顆粒導電中，建立了混合泥質砂巖有效介質通用hb電阻率模型。First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field
首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。Applicable to lpressure measurements for liquid mediums at high temperature, such as corrosive, high viscous, crystallizable and solid - particles containing fluids commonly used in petrochemical indusery, etc
隔膜壓力表用於化工等部門生產過程中測量具有腐蝕性、高粘度、易結晶、含有固體狀顆粒、溫度較高的液體介質的壓力。The coalescence & separation filter core, targeting at low viscosity oils, is highly efficient to dewater according to the difference of different material ' s surface tension
針對低粘度油液的特殊配比的聚結分離濾芯，根據介質表面張力的不同進行細化分離，脫水效率高，脫水能力強。The glass adherence craft has avoided the temperature, humidity, machinery fatigue and medium to the glue water and material influence, and then improved the sensor long - term stability in the industry ambient, in the meanwhile also avoided the sensor p - n effect phenomenon that appeared in the traditional micro machining operation manufacture process
玻璃粘接工藝避免了溫度濕度機械疲勞和介質對膠水和材料的影響，從而提高了傳感器在工業環境中的長期穩定性能，同時也避免了傳感器在傳統微機械加工製造工藝過程中出現的p - n結效應現象。The consolidating wave speed means the speed at which elastic stress wave transmits throughout reinforced concrete, and it is intervenient the inherent wave speed of steel and of the concrete. moreover, the consolidating wave speed inherent in the material of the reinforcing steel bar and the concrete, and it relates to the cling strength of steel bar and the concrete
固結波速是指彈性應力波通過鋼筋-混凝土體系傳播時的速度，通過理論分析得知固結波速的大小介於鋼筋和混凝土中彈性應力波速之間，由鋼筋與混凝土二者的材質特性決定，與二者的粘結強度密切相關。The measuring devices are suitable for non - aggressive, liquid or gaseous media as far as they are not cristallysing or highly viscous
該測量表適用於不易於結晶或粘稠低的無腐蝕性液體或氣體介質。The paper introduces the characteristic of carbon fiber, and the influence of the carbon fiber surface quality on carbon cohesive to the resin and the applicability of the carbon fiber composite
摘要介紹了碳纖維的特點以及碳纖維表面質量對纖維與樹脂基體的粘結性和碳纖維增強復合材料的使用性能的影響。Complicated hydrologic and geographic conditions, and the large scale of the xiaolangdi hydraulic project on the yellow river are introduced briefly. three desilting tunnels are designed to meet the requirements of flood control, sediment discharge and runoff regulation. according to the performance requirements of desilting tunnels, the tunnel lining down - stream of the grouting curtain is designed to be post - tensional prestressed lining. on the basis of investigation and research, experiements and analysis, the unbonded prestressing system is used. it is the largest unbonded prestressed tunnel lining project in the world, and the first one in china
簡介黃河小浪底水利樞紐復雜的水文、地質條件以及龐大的工程規模.該樞紐設計有3條排沙洞，擔負著泄洪、排沙、調節徑流和保證進水口不被泥沙淤堵的任務.根據排沙洞的水庫運用要求，灌漿帷幕下游排沙洞洞身段設計為混凝土后張預應力隧洞.通過大量的調研、試驗、分析論證，在施工前確定該預應力方案選用無粘結預應力系統，成為目前世界上規模最大的無粘結預應力隧洞襯砌工程，在國內尚屬首例The pressure switch is suitable for almost all liquid and gaseous mediums and is used in vacuum technology pump control, gas technology stock monitoring, leak detection, filter monitoring dirt detection, as well as a whole variety of measurement tasks in hydraulics and pneumatics, in machine, equipment and plant construction, in process technology and in building technology
壓力開關幾乎適用於所有液體和氣體介質，可以用於真空技術氣泵控制氣體技術貯存量監測泄露探測過濾監測灰塵探測，也用於過程技術和建造技術的機器機械和設備製造中的所有液壓和氣壓測量任務。前置式設計使開關能用於高粘稠和結晶介質。Test gauges are suitable for measuring of non - aggressive gaseous and liquid media, although this may not be to viscous or be susceptible to cristallization
該表適用於測量非腐蝕性液體和氣體介質，但介質不能太粘稠或易結晶。Test gauges are suitable for measuring of non - aggressive gaseous and liquid media, although this may not be too viscous or be susceptible to crystallization
該表適用於測量非腐蝕性液體和氣體介質，但介質不能太粘稠或易結晶。The necessity of chemical seals is given, when measuring errors can occur due to a high viscousity pastry or cristaline growth in the measured media
當測量介質高粘稠膏狀或結晶時，會產生測量錯誤，此時就必須使用化學密封。Chemical seals are used when media can falsify the pressure measurements due to high temperature, high viscosity media in paste form or their propensity to crystallise
當介質溫度高粘稠度高介質呈膏狀或者結晶時會導致測量錯誤，使用化學密封可以避免錯誤。The recent research status on tungsten heavy alloys was reviewed. the methods to improve the properties of tungsten alloys, including the changes of tungsten particle size, component, content of matrix and the improvements of sintering technics, were also discussed in details. at the same time, some advanced overseas penetrators were introduced and research directions of tungsten alloy materials were pointed out in this paper
主要介紹高密度鎢合金穿甲彈材料侵徹性能的國內外研究發展狀況，從改變合金中鎢顆粒性質、粘結相組成與含量，以及結合工藝改善的角度，總結目前國內外改善高密度鎢合金侵徹性能的主要途徑，並對當前國外先進鎢合金穿甲彈產品的材料成分、制備工藝及侵徹效果進行了簡要介紹和分析;同時針對國外穿甲彈的研究概況和發展趨勢，提出我國今後研究和開發新型高侵徹性能鎢合金穿甲彈的主要研究方向。The temperature pressure measuring instruments of the standard programme can be used anywhere where liquid or gaseous materials to be measured do not attack copper alloys, do not crystallise and are not highly viscous
溫度壓力計標準程序的溫度-壓力測量儀可以用於任何液體氣體介質測量，但介質不能腐蝕銅合金結晶或高粘稠。The forming processes of the decorated rib and handle with the numerical simulation and experimentation has been done for cooperation. the numerical simulation results can indicate aluminum alloy ’ s viscous pressure forming for car door bodies
將實驗結果與有限元分析預測結果進行了對比，結果表明有限元數值模擬能夠較好的預測粘性介質壓力成形鋁合金車門結構件。The paper deduced movement and wave equation of seismic wave field in constant q viscoelastic media using the method of pseudo - spectral, and carried on forward modeling, the modeling result is the same with the one of other modeling ways
摘要本文採用偽譜法推導了常q粘彈介質中地震波場的運動方程和波動方程，並進行了地震波場數值正演模擬，模擬結果達到了其它模擬方法同樣的效果。In this paper, vpf used for forming automobile door outer with aluminum alloys is investigated, and the investigation used with numerical simulation and experimentation
本文研究了鋁合金車門外板縮比件粘性介質壓力成形，採用實驗與數值模擬相結合的方法對成形過程和結果進行了分析。2 ) a computational procedure is proposed to solve the interaction problem of elastic structure and fluid. little simplification of fluid is carried out. the coupling algorithm solves the equations for the fluid and solid domains independently of each other
2 ）在計算流體動力學（ cfd ）的基礎上，發展了一種流固耦合計算模式（ fsi ） ，流體為粘性介質，採用ale格式處理流體和結構之間的移動界面，流體域和固體域分別獨立計算，程序控制傳遞流體壓力及固體位移和速度作為對方的邊界條件，實現耦合計算。分享友人